Magnetic effects of direct ion implantation of Mn and Fe into p-GaN

In p-GaN implanted with Mn (3×10¹⁶ cm⁻² at 250 keV), the material after annealing shows ferromagnetic properties below 250 K. Cross-sectional transmission electron microscopy (TEM) revealed the presence of platelet structures with hexagonal symmetry. These regions are most likely Ga_xMn_1−xN, which produce the ferromagnetic contribution to the magnetization. In p-GaN implanted with Fe, the material after annealing showed ferromagnetic properties at temperatures that were dependent on the Fe dose, but were below 200 K in all cases. In these samples, TEM and diffraction analysis did not reveal any secondary phase formation. The results for the Fe implantation are similar to those reported for Fe doping during epitaxial growth of GaN.     

稀疏气泡流动的粒子跟踪测速技术研究

采用动态阈值技术实现了对气泡图像的正确分割，利用灰度加权方法提高了气泡颗粒的定位精度。根据稀疏气泡流动图像的特点，提出了一种新的基于相关的粒子跟踪测速算法（2-HPTV）。通过进行两时刻中围绕待研究气泡所取的两个小的诊断窗口的相关运算，成功实现了气泡颗粒的轨迹追踪。实验表明本文算法较传统的PIV技术在测速精度上有很大程度的提高，与4帧粒子跟踪测速算法相比，降低了对摄像机帧频的要求，具有较强的实用性。     

植物油、脂肪酸和植物油甲酯在塔河稠油掺稀降黏中的应用评价

稠油由于富含沥青质、胶质等重质组分而具有很高的黏度，给稠油的开采和运输带来了很大的困难。降低稠油黏度进而改善其流动性成为一项十分重要的工作。以植物油、脂肪酸及植物油甲酯为掺稀介质，以塔河油田稠油为研究对象，考察对比了3种不同的掺稀介质对稠油的掺稀降黏效果。研究结果表明，3种掺稀介质对稠油具有良好的掺稀降黏效果，在同一掺稀比下，植物油甲酯对稠油的降黏效果最显著，其次是脂肪酸，再次是植物油。通过斑点试验考察了掺稀介质和稠油的相容性和体系稳定性。结果显示，植物油甲酯与稠油相容性和稳定性最好，脂肪酸和植物油与稠油的相容性和稳定性相对较差。     

Transport properties of critical dilute solutions

On the basis of the isomorphism of critical phenomena, the behavior of transport properties of binary mixtures in the vicinity of the vapor-liquid critical line is considered. In particular, the renormalization of the singularity of the thermal conductivity in dilute critical solutions has been analyzed in detail. It is shown that the behavior of the thermal conductivity is determined by the critical background, i.e., the fluctuation-induced regular part, which diverges at the critical point of a solvent.     

Investigation of transport phenomena in a hybrid ion exchange-electrodialysis system for the removal of copper ions

Hybrid ion exchange electrodialysis processes allow the removal of metal ions from dilute waste liquids and the recovery of more concentrated solutions. The work reported here was aimed at investigating the two steps in the treatment process, namely, adsorption of metal ions onto the packed bed of resin and electromigration (i.e., the transport of these ions in the complex system under the applied electrical field). The case of copper sulfate was investigated. Dowex resins with a cross-linking degree of 2 and 8% were used. The flux of copper through the resin bed and the current efficiency for ion transfer to the cathode compartment were determined as a function of potential gradient and copper ionic fraction in the bed. Apparent diffusion coefficients of Cu²⁺ in the overall system were deduced from the experimental data.     

含碳氨水集成分离新技术的应用

通过应用含碳氨水集成分离技术改造氨回收装置，提高了分离效率及处理通量，经济与环保效益显著，氨回收率达９９％，处理量提高６０％，塔阻力下降８０％，蒸汽耗量下降４２％，装置出口废液含氨量达国家一级排放标准。     

弱酸性铵盐与碱性锌酸盐双缸套镀锌工艺及低铬钝化

总结了弱酸性链盐镀锌和碱性锌酸盐镀锌的优缺点，并综合两者的优点，提出了一种弱酸性铵盐与碱性锌酸盐双缸套镀锌工艺。钝化膜的性能得到了改善。     

Nucleophilic substitution onto poly(methylmethacrylate): 4. Dilute solution properties of substituted polymethacrylates

The morphological and hydrodynamic properties of a series of homogeneous fractions of substituted poly(methylmethacrylate) (A units) bearing keto-β-functional groups (B units) of the general structureCOCH₂R, with R = SO_xCH₃ (x = 1,2) or SO₂N(CH₃)₂, were investigated by intrinsic viscosity, light scattering and partial specific volume measurements in dimethylformamide (DMF) solution at 25°C. For molar substitution degrees $\text{DS}{}_{\mathrm{m}}\text{< 0.5}$, the copolymers behave as flexible random coils. The Stockmayer-Fixman-Yamakawa analysis of the $\text{[η]-}\text{M}\text{?}{}_{\mathrm{w}}$ data leads to slightly higher unperturbed dimensions K_o and steric factor σ than those for PMMA, and to stronger chain expansion as a result of the weak hydrogen bonding between DMF and COCH₂R units and a positive X_AB interaction parameter. For $\text{DS}{}_{\mathrm{m}}\text{> 0.5}$ however, copolymers bearing COCH₂SO₂N(CH₃)₂ groups behave as worm-like chains, as derived from the Fujii-Yamakawa analysis of the $\text{[η]-}\text{M}\text{?}{}_{\mathrm{w}}\text{-}\text{v}\text{?}$ data: the persistence length increases from 380 to 570 Å within the $\text{DS}$_m range 0.57–0.75. This transition from a random coil to a worm-like chain for $\text{DS}{}_{\mathrm{m}}\text{> 0.5}$ was tentatively correlated with the accumulation of B units in sterically hindered and self-associated short blocks of average length l_B ? 1.6 which provide drastically increased rigidity to the copolymer chain.     

Characterization of dilute and dense phase vertical upflow gas-solid transport based on average concentration and velocity data

Dilute, ‘dense phase 1’, and possibly a third regime-‘dense phase 2’, were observed in a vertical 0.02 m diameter pneumatic conveyor using 210 μm sand particles. The transitions were marked by the alterations in the trend of the measured average solids hold-up while varying the solids mass flowrate at constant air velocity. Hydrodynamic characteristics together with the transition criteria for the various transport modes were established. A novel regime diagram based on average gas velocities and solids mass flowrates was developed to identify the operating conditions for these regimes, as well as the limiting solids carrying capacities of the present conveyor. A probable cause of the dilute to dense phase transition is speculated upon.     

由二元合金相图提取无限稀活度系数（英文）

提出了由二元相图提取定温下无限稀活度系数的方法,分别在正规溶液和Richardson假设条件下,计算了31个二元液态合金体系两组元无限稀活度系数,并与相应的实验值比较,所获得的平均相对误差为:共晶体系为23.2%和20.7%;含固溶体体系为19.4%和18.3%;含化合物体系为39.5%和46.1%;分层体系为25.8%和14.3%.结果表明:由共晶相图、含固溶体相图提取无限稀活度系数,有效性较好,由含化合物相图提取无限稀活度系数有效性较差.引入Richardson假设后,对计算值的精度有所提高.研究表明,运用二元相图提取无限稀活度系数方法提取二元合金体系无限稀活度系数是可行的.