Effect of heat loss on the syngas production by fuel-rich combustion in a divergent two-layer burner

The effect of heat loss on the syngas production from partial combustion of fuel-rich in a divergent two-layer burner is numerically studied using two-dimensional model with detailed kinetics GRI-Mech 1.2. Both the radiation and wall heat losses to the surrounding are considered in the computations. It is shown that two types heat losses have different effects on the syngas production. The radiation heat loss has significant effect on the syngas temperature and the syngas temperature is dropped as radiation heat loss is increased, but it has neglected effect on the reforming efficiency and methane conversion efficiency. The wall heat loss has a comprehensive effect on the syngas production. The wall heat loss not only reduces the conversion efficiency, but also significantly decreases the syngas temperature. The effect of wall heat loss becomes weak as the equivalence is increased. The reforming efficiency drops from 0.440 to 0.424 for equivalence ratio of 2 and mixture velocity of 0.17 m/s for the predictions between adiabatic wall and non-adiabatic conditions.     

蓄热式均热炉生产中存在问题的分析及解决方案

介绍了高温空气燃烧技术在均热炉上的应用情况，对应用中出现的问题进行了分析，并提出了解决方案。     

Emission of trace toxic metals during pulverized fuel combustion of Czech coals

A study of the trace elements emission (As, Se, Cd, Co, Cr, Cu, Zn, Hg, Tl, Pb, Ni, Sn, Sb, V, Mn and Fe) from pulverized coal combustion has been made at six heating and power stations situated in the Czech Republic. The amount of chlorine in coal has considerable influence on volatilization of some elements such as Zn, Cu, Pb, Hg and Tl, which is explained by the formation of thermodynamically stable compounds of these elements with chlorine. Generally, the affinities for Cl follows the order Tl > Cu > Zn > Pb > Co > Mn > Sn > Hg. The experimental data indicates enrichment of some of the trace toxic elements in the emissions (Cu, Zn, As, Se, Cd, Sn, Sb, Hg and Pb) and good agreement was obtained by thermodynamic equilibrium calculations with a few exceptions. In the case of Fe, Mn, Co, Cr and Sn calculated values are overestimated in the bottom ash and there are zero predicted amounts of these elements in the fly ash. In comparison, the results from experiments show up to 80% of these elements retained in fly ash. This implies that there exist additional steps leading to the enrichment by Fe, Mn, Co, Cr and Sn of small particles. Such mechanisms could include the ejection during devolatilization of small inorganic particles from the coal of bottom ash particles, or disintegration of the char containing these metals to small particles of fly ash. On the other hand, there are slightly overestimated or similar values of relative enrichment factors for As, V, Cu, Cd, Sb, Tl and Pb in the fly ashes and zero predicted values for bottom ashes. Our experimental results show about 5% or less of these elements are retained in bottom ashes, so they probably remain in the bottom ash inside unburned parts of coal. Copyright © 2003 John Wiley & Sons, Ltd.     

鼓风引射式燃气燃烧器的计算

提出鼓风式射式燃气燃烧器的基本计算公式与计算结果，并进行结构尺寸与工况分析，确定各种因素对其的影响程度。     

55t/h锅炉技术改造成功经验

介绍了35t／h锅炉扩容改造为55t／h非标锅炉的技术成功经验。从增加锅炉的容积、受热面面积、燃烧器喷嘴改造三个方面介绍了对锅炉本体的改造，改造后实现了锅炉的水位、汽温及燃烧自动调节，提高了锅炉的热效率为以后的锅炉扩容改造提供了实践经验。     

煤粉粒度对高炉风口前燃烧性能的影响

安钢炼铁厂在喷吹瘦煤后，将小于0．074mm的比例由70％放宽到30％，使磨煤能力提高了21％。采用自行设计的风口取样器，研究了风口前气体成分和煤粉燃烧率的变化。当煤粉粒度变粗后，风口前循环区变长，放宽煤粉粒度与高富氧、高风温配合，能使高炉得到较好的经济效益。     

喷煤未燃煤粉在高炉内行为的研究

在模拟攀钢高炉喷吹煤粉的生产条件下进行的未燃煤粉在高炉内的行为研究结果表明，在铁的直接还原、生铁渗碳、硅和钛还原、未燃煤粉和焦粉在炉渣中沉积、煤和焦炭反应性的各个试验中，未燃煤粉的反应性都大于焦炭，这些都是由于未燃煤粉的比表面积大，结构疏松所造成的。     

天铁炼铁技术进步

近十年来，天铁集团炼铁厂通过改善原燃料条件；优化炉料结构，提高入炉品位；采用提高炉顶压力、富氧喷煤、低硅冶炼、炉顶气象系统等多项先进技术，使高炉各项经济技术指标逐年提高。     

脉动燃烧控制技术在隧道式淬火炉上的应用

为解决隧道式淬火炉炉温分布不均匀的问题，采用了高速调温烧嘴脉动燃烧控制技术。实践证明：脉动燃烧控制对象是带延迟的一阶惯性环节，因此对控制对象采用常规的PID控制策略完全可行。还阐述了高速调温烧嘴脉动燃烧控制技术运用于隧道式淬火炉的优越性和取得的显著效果。