创建理性地对蓄电池充电的社会环境——促进电动汽车的发展

由电网电源V-变换成直流电流源V1后从正方向对蓄电池V2充电是现有技术。本文是推荐一种由V1正向V2,V2又负向外接负载Rf的双向交替电流对蓄电池充电的技术路径,是在遵循马斯定律的理论计算又结合具体的控制电路可真实实施的一种技术路径。所达到的效果是现有技术基础上：Ⅰ段速充电速率提高16倍;蓄电池循环使用周期寿命延长一倍...     

Improvement of non-destructive fissile mass assays in α low-level waste drums: A matrix correction method based on neutron capture gamma-rays and a neutron generator

Within the framework of radioactive waste control, non-destructive assay (NDA) methods may be employed. The active neutron interrogation (ANI) method is now well-known and effective in quantifying low α-activity fissile masses (mainly ²³⁵U, ²³⁹Pu, ²⁴¹Pu) with low densities, i.e. less than about 0.4, in radioactive waste drums of volumes up to 200 l. The PROMpt Epithermal and THErmal interrogation Experiment (PROMETHEE [F. Jallu, A. Mariani, C. Passard, A.-C. Raoux, H. Toubon, Alpha low level waste control: improvement of the PROMETHEE 6 assay system performances. Nucl. Technol. 153 (January) (2006); C. Passard, A. Mariani, F. Jallu, J. Romeyer-Dherber, H. Recroix, M. Rodriguez, J. Loridon, C. Denis, PROMETHEE: an alpha low level waste assay system using passive and active neutron measurement methods. Nucl. Technol. 140 (December) (2002) 303-314]) based on ANI has been under development since 1996 to reach the incinerating α low level waste (LLW) criterion of about 50 Bq[α] per gram of crude waste (≈50 μg Pu) in 118 l drums on the date the drums are conditioned.Difficulties arise when dealing with matrices containing neutron energy moderators such as H and neutron absorbents such as Cl. These components may have a great influence on the fissile mass deduced from the neutron signal measured by ANI. For example, the calibration coefficient measured in a 118 l drum containing a cellulose matrix (density d = 0.144 g cm⁻³) may be 50 times higher than that obtained in a poly-vinyl-chloride matrix (d = 0.253 g cm⁻³). Without any information on the matrix, the fissile mass is often overestimated due to safety procedures and by considering the most disadvantageous calibration coefficient corresponding to the most absorbing and moderating calibration matrix.The work discussed in this paper was performed at the CEA Nuclear Measurement Laboratory in France. It concerns the development of a matrix effect correction method, which consists in identifying and quantifying the matrix components by using prompt gamma-rays following neutron capture. The method aims to refine the value of the adequate calibration coefficient used for ANI analysis.This paper presents the final results obtained for 118 l waste drums with low α-activity and low density. This paper discusses the experimental and modelling studies and describes the development of correction abacuses based on gamma-ray spectrometry signals.     

Argacel RC的应用技术

涤棉织物一般用分散／活性染料染色。分散染料在棉纤维上容易沾色而降低摩擦牢度及水洗牢度。为提高色牢度，在分散染料染色后要进行还原清洗。传统的烧碱保险粉还原方法耗水、耗电、耗汽，且保险粉不稳定，易分解，新型酸性还原剂Argacel RC的使用可使工艺简化并降低成本。     

The design and calibration of a phantom for depth profiling measurements of entrained radioactivity in silica-based media

The development of a phantom which replicates the effect of concrete on radioactivity entrained within it is described. The phantom was designed as a basis on which methods can be developed to measure the depth of radioactive contamination in the concrete of defunct nuclear facilities. In particular, this apparatus has been used to validate a differential attenuation method for the profiling of radioactive contamination at depth. Entrained radioactive contamination is a significant issue in defunct nuclear facilities where in situ, non-destructive assay of radioactive waste arisings is a routine requirement.The phantom comprises a polymethylmethacrylate structure filled with high-purity silica-sand which, for the purposes of the application, is an effective analogue of fully-hydrated concrete paste. A void was created within the silica sand which incorporates a sliding mechanism for the insertion of a radioactive source to a required depth. The sealed source represents the entrained radioactivity in the phantom but is also specifiable, removable and poses no long-term contamination risk beyond the expected life of the apparatus. The remainder of the void either side of the source is filled with silica-sand to complete the homogeneity of the phantom. The void was situated near the front of the phantom constructed at a 5.14° angle with respect to the front scanning surface; thus the apparent depth within the silica-sand can be varied by changing the position of the source along the phantom's void.The steps taken to develop the concrete phantom are described. The design has been validated with a set of radiation transport simulations affording comparison with an exemplar of the concrete found used in nuclear facilities. Some initial results from measurements taken with the phantom and a caesium-137 γ-radiation source in combination with a sodium iodide radiation detector are provided. These measurements are used to validate the differential attenuation method and compared with data from previous measurement attempts with concrete slices.     

开关电流电路中的时钟馈入效应

本文采用ＭＯＳ开关的集总时变ＲＣ模型，对开关电流（ＳＩ）电路中的时钟馈入效应进行了详细的理论分析，导出了开关电流镜中钟馈电压和钟馈电流的表达式，从而揭示出了钟馈电压／电流与工艺参数、ＭＯＳ器件尺寸、时钟信号幅值及其下降沿斜率等之间的内在关系。用它可对ＳＩ电路中时钟馈入的影响进行快速预测。文中的理论分析与ＳＰＩＣＥ仿真结果相一致。所提供的结果对于设计高精度低功耗ＳＩ电路有应用价值。     

谈化工工业厂房钢筋砼结构构件加固与施工

化工工业厂房钢筋砼构件 ,由于受空气中有害气体和化学介质腐蚀等造成千万结构破损 ,和扩大生产 ,荷载的增加 ,需进行加固处理 ,才能满足生产使用要求     

Observation of strain effect on the suspended graphene by polarized Raman spectroscopy

We report the strain effect of suspended graphene prepared by micromechanical method. Under a fixed measurement orientation of scattered light, the position of the 2D peaks changes with incident polarization directions. This phenomenon is explained by a proposed mode in which the peak is effectively contributed by an unstrained and two uniaxial-strained sub-areas. The two axes are tensile strain. Compared to the unstrained sub-mode frequency of 2,672 cm⁻¹, the tension causes a red shift. The 2D peak variation originates in that the three effective sub-modes correlate with the light polarization through different relations. We develop a method to quantitatively analyze the positions, intensities, and polarization dependences of the three sub-peaks. The analysis reflects the local strain, which changes with detected area of the graphene film. The measurement can be extended to detect the strain distribution of the film and, thus, is a promising technology on graphene characterization.     

深沟球轴承保持架球兜曲率Rc取值原则探讨

深沟球轴承浪形保持架,按新参数设计存在夹球问题。采用松铆钉结构,调整兜曲率Rc取值,解决夹球问题,提高回转灵活性。     

Nucleogenic Cl, U and Pu in uranium ores

The nucleogenic isotopes ³⁶Cl, ²³⁶U and ²³⁹Pu are produced naturally in subsurface environments via neutron capture of thermal and epithermal neutrons. Concentrations are, however, very low and accelerator mass spectrometry (AMS) is required for quantitative measurements. A particular challenge is presented by the measurement of ²³⁶U/²³⁸U ratios down to the level of 10⁻¹³ that is expected from rocks with low uranium concentration. Here, we present the AMS methodology that has been developed at the ANU for measuring ²³⁶U/²³⁸U ratios at this level. The more established methodologies for ³⁶Cl and ²³⁹Pu measurements are also summarised. These capabilities are then used to characterize the ³⁶Cl, ²³⁶U and ²³⁹Pu concentrations in a range of uranium ores. A simple model of the neutron production and capture processes in subsurface environments has been developed and is presented. It is shown that nucleogenic ³⁶Cl, ²³⁶U and ²³⁹Pu can be used to determine both thermal and epithermal neutron fluxes in subsurface environments. Potential applications include uranium exploration and monitoring of the environmental impact of uranium mining.