Impact of the addition of an enzyme pool on an activated sludge system treating dairy wastewater under fat shock loads

BACKGROUND: The application of lipase‐rich enzyme pools (such as the crude solid enzymatic preparation (SEP) obtained from Penicillium restrictum solid‐state fermentation of agro‐industrial wastes) to activated sludge systems may be an effective strategy for preventing various operational problems. The continuous addition of SEP to the treatment system can become cost‐prohibitive when in situ production and/or storage are factored in. The application of SEP to high‐fat wastewater treatment would only be justified as an emergency measure, such as a sudden increase in the fat content of the bioreactor influent. Therefore, the primary objective of this work was to investigate the efficiency of a crude SEP during fat shock loads, simulated through the periodic addition of dairy industry waste containing high fat concentrations to the feed stock of an activated sludge system, operated in continuous mode. RESULTS: The test bioreactor exhibited a higher average chemical oxygen demand (COD) removal efficiency than the control bioreactor (83% for control and 90% for test) and the fat accumulation in the biological flocs of the test bioreactor was 3.2 times lower than that in the control bioreactor. Turbidity was also lower in the effluent of the test bioreactor (123 and 66 FTU in control and test, respectively) and it had a shorter recovery time between shock loads, especially when the interval between loads was shorter than one month (biweekly and weekly shock loads). CONCLUSION: The addition of SEP during fat overloads in the reactor feed maintained efficient COD removal in the test bioreactor for 270 days without any operational problems. Copyright © 2008 Society of Chemical Industry     

矿石中金的快速测定

研究了活性炭纤维滤布富集分离的条件和解脱方法,并利用微波溶样、液珠萃取比色法测定矿石中的金。该方法的测定范围为(0.5~xx)×10-6,相对标准偏差RSD为3.2%,可用于矿石中金的野外快速测定。     

On the suitability of agricultural by-products for the manufacture of granular activated carbon

An investigation of several agricultural by-products revealed that their suitability for activated carbon production is not determined by general material-specific features (elemental composition) but by type-specific features. A coarse-cellular structure (as in wood), which is indicated by porosities of the raw materials higher than 35% is disadvantageous. A specific change in the properties of cokes (porosity, density, hardness) is possible by varying the conditions of pyrolysis. By rapid heating in the pyrolysis step, for instance, macroporous residues are produced. Temperature and burnoff have the greatest influence on the quality of the activated carbon during the activation step. Of the investigated materials, coconut shells yield granular activated carbon of the highest quality. The following order of suitability of raw materials for activated carbon production was established: coconut shells> peach stones> plum stones> hazelnut shells> walnut shells> cherry stones.     

Use of TNSAC in phosphate adsorption studies and relationships. Isotherm relationships and utility in the field

There is a need for developing low cost, easily and abundantly available, yet efficient, adsorbents for the removal of phosphates during the tertiary treatment of wastewaters. The tamarind nut shell activated carbon (TNSAC) prepared on a laboratory scale has been used to evaluate its performance for phosphate adsorption. This paper describes the laboratory production of this adsorbent material in its various forms, and discusses the effects of the TNSAC process variables (the unrinsed and rinsed forms of the TNSAC and the impregnation ratio) on its performance in adsorbing phosphate. The material has been shown to be a good alternative adsorbent. As much as 95% phosphate removal by the unrinsed TNSAC is possible in about 30 min under the test conditions. The phosphate adsorbing capacity is about two times higher for the unrinsed TNSAC in comparison to the rinsed TNSAC. The adsorption rates, however, transit to extremely low rates towards the end when equilibrium conditions could be attained in about 2 h contact time. The phosphate removal mechanics are adsorption and precipitation/ion exchange when unrinsed TNSAC is used, and adsorption alone for the rinsed TNSAC. The maximum phosphate removal is found to take place at an impregnation ratio of 1.0 for both forms of the TNSAC.     

死髓变色前牙的激光漂白治疗临床评价

本文的研究目的是探讨激光冠内漂白治疗死髓牙变色的治疗作用。材料与方法 :漂白基本操作同激光活髓牙变色的漂白操作程序。先将牙龈及口唇有效防护 ,将漂白药物放在唇舌两面并同时封入根冠内。结果 :所有牙齿的灰暗变色均有 3- 5级的色度提高。平均治疗次数为 3.4± 0 .75 ,脱色 85 %以上的占 89%。结论 :牙齿创伤和牙髓分解是冠内变色的常见原因 ,激光冠内漂白是治疗这种变色的有效手段 ,可以完全恢复患者的自信。     

Vinyl acetate monomer—a pilot plant study

The kinetics of the reaction of acetic acid and acetylene over zinc acetate-activated carbon catalyst was investigated over a wide range of process variables in a pilot reactor. Although various catalytic reaction mechanisms were postulated, the rate of reaction was most satisfactorily correlated by a mechanism of surface reaction between charged adsorbed acetic acid and acetylene, which assumes that the rate controlling step was the irreversible charged adsorption of acetylene and acetic acid.     

活性污泥生物相对污水处理运行的指导作用

污水处理系统处理效果的好坏都与污水处理系统中组成活性污泥的微生物种类、数量及其代谢活力有关,本文从活性污泥结构、微生物种类、数量及活性等方面分析了污泥生物相与运行状态的相互关系.说明了可通过对污水处理系统的生物相观察了解处理效果及运行状况,也可通过对污泥生物相观察发现处理系统环境的变化,及时调整运行环境,预防污水处理系统的运行中的异常情况发生.     

活性炭单柱提取肌苷新技术研究

活性炭单柱提取肌苷新技术研究李永泉，张进，姚恕，郑莲英，俞峰（杭州大学生物系杭州３１００２８）（浙江大学化工系杭州３１００２７）关键词：肌苷，提取技术，活性炭单柱１前言目前，国内肌苷发酵后处理工艺落后，在分离提取工序中肌苷损失严重，收率一般只有５０％...     

Laboratory simulated slipstream testing of novel sulfur removal processes for gasification application

The Wabash River Integrated Methanol and Power Production from Clean Coal Technologies (IMPPCCT) project is investigating an Early Entrance Coproduction Plant (EECP) concept to evaluate integrated electrical power generation and methanol production from coal and other carbonaceous feedstocks. Research, development and testing (RD&T) that is currently being conducted under the project is evaluating cost effective process systems for removing contaminants, particularly sulfur species, from the generated gas which contains mainly synthesis gas (syngas), CO₂ and steam at concentrations acceptable for the methanol synthesis catalyst. The RD&T includes laboratory testing followed by bench-scale and field testing at the SG Solutions Gasification Plant located in West Terre Haute, Indiana. Actual synthesis gas produced by the plant was utilized at system pressure and temperature for bench-scale field testing.     

CAST的工作原理与设计计算

详细论述了循环式活性污泥法(CAST)的工作原理，对该工艺的设计计算作了探讨，提出了设计方法，并提供了有关计算公式和操作时间分配。