毛/涤纱分散/酸性(媒染)染料一浴法筒子染色工艺

毛/涤纱分散/酸性(媒染)染料一浴法筒子染色工艺,在100℃条件下能满足毛、涤两种纤维同时上染,染色产品具有着色深浓鲜艳,色泽一致,各项牢度符合要求,对纤维无损伤等优点,从而缩短生产时间,降低成本,提高经济效益。     

水溶性丙烯酸共聚物对羊毛织物抗缩性能的研究

本文对水溶性丙烯酸共聚物的合成，以及其对羊毛织物的抗缩性能的影响作了较详细的研究和讨论。     

新型梳形电缆防火墙的应用

通过新型梳形电缆防火墙的实施，有效地限制了电缆火灾范围，增强了电缆防火、隔火能力，并详细地介绍了梳形电缆防火墙的原理结构、安装使用和注意事项。     

甲壳素纤维/毛/绒双层织物的设计

通过分析甲壳素纤维各项性能,将其引入山羊绒产品中,对双层织物的设计进行探讨,并经过纺纱和织物试制,提出了设计与生产中应注意的问题,开发出了具有永久抗菌性的表层为羊绒、里层为甲壳素与改性羊毛混纺的系列产品.     

Layering garments during rest and exercise in the cold (8°C): wearer responses and comparability with selected fabric properties

How garments contribute to performance of the clothing system during wear is of interest, as is understanding the value of using fabric properties to inform end-use characteristics. To investigate the influences of layering upper-body garments, four fabrics were used to construct two first-layer garments (wool and polyester) and two outer-layer garments (wool and membrane laminate). Over six sessions, 10 moderately trained males wore each first-layer garment as a single layer and in combination with each outer-layer garment while resting, running and walking in cold environmental conditions (8 ± 1°C, 81 ± 4% RH). Here, the type of garment arrangement worn (fabric type or number of layers) had little influence on heart rate, core body temperature and change in body mass. Weighted mean covered skin temperature was warmer and weighted mean next-to-skin vapour pressure was typically higher (following the onset of exercise) with two layers versus one. Differences among fabrics for individual properties were typically overstated compared to differences among corresponding garments for physiological and psychophysical variables under the conditions of this study. These findings inform the interpretation of particular fabric properties and highlight issues to be acknowledged during development/refinement of fabric test methods.

Practitioner Summary: We examined the way in which selected fibre, fabric and garment (layering) characteristics contribute to performance of the clothing system during wear under cold conditions. Selected properties of the constituent fabrics were found to provide limited insight into how garments perform during wear under the conditions of this study.     

Preparation,characterization, and some physical properties of polypropylene/poly(methyl acrylate)‐grafted glass wool composites

Polypropylene/poly(methyl acrylate)‐grafted glass wool (PMA‐g‐GW) mixes were prepared. The polymerization process was carried out using potassium persulfate (PPS) and PPS/acetone sodium bisulfite (ASBS) as a redox‐pair initiation system at 60 and 70°C. The effect of using PPS or PPS/ASBS on the grafting percent and conversion percent reveals that the conversion percent values on using PPS as an initiator are higher than those of PPS/ASBS, while in the case of grafting, the inverse is true, that is, using PPS as an initiator gives grafting percent values lower than those that can be obtained using PPS/ASBS. The dielectric properties, thermal diffusivity, specific heat capacity, and thermal conductivity of PP loaded with modified glass wool as a function of different types and concentrations of initiators—used in the grafting polymerization process, namely, PPS and the redox initiating system—were also studied. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 87: 723–732, 2003     

甜菜红用于羊毛染色的研究

分析了甜菜红对羊毛的染色性能以及羊毛经二乙胺处理后染色性能的改善。实验结果表明,甜菜红色素不耐高温、对羊毛染色必须在60℃以下并在强酸性条件下进行;羊毛经乙二胺处理后上染率明显提高, 染色时间明显缩短。     

Lanaset染料染色性能的研究

实验结果证明了硫酸铵替代Albegal SET的可能性，其染色牢度和匀染性都达到了Lanaset染色体系要求的标准,并具有更高的上染率。与中性染料相比，条染复精梳制成率提高3.6％．纺纱制成率提高4.0％。     

利用近红外光谱进行羊绒与羊毛的鉴别技术研究

利用近红外光谱技术,以不同产地的羊绒、羊毛纤维为研究对象,结合主成分分析法和多元线性回归方法分别建立了羊绒、羊毛定性分析模型和羊绒-羊毛混纺纤维的定量分析模型.对模型的验证结果表明:定性分析模型能够准确地鉴别出羊绒与羊毛纤维;定量分析模型的相关系数和预测标准偏差分别达到了0.998 1和1.206 1,能够对羊绒-羊毛混纺纤维的含量进行准确的预测;近红外光谱技术用于羊绒、羊毛定性及定量分析具有可行性.     

琥珀酰亚胺酯基类偶氮染料的制备及其超临界CO2羊毛清洁化染色

以对氨基苯甲酸和4-氨基-2-氯苯甲酸、苯胺和间甲苯胺为原料,采用重氮偶合反应制备染料前驱体,通过在前驱体上引入琥珀酰亚胺酯获得4例活性分散染料Ⅰ～Ⅳ.对染料的紫外-可见吸收光谱、光热稳定性、超临界二氧化碳(scCO2)中羊毛纤维的染色工艺等进行了测试.结果表明,4例染料均具有良好的光热稳定性,染料Ⅰ、Ⅲ和Ⅳ最大吸收波长集中在360～370 nm,染料Ⅱ的最大吸收波长红移到379～452 nm,染料均具备scCO2染色的条件.染料Ⅰ和Ⅲ的最佳染色条件为2 h、80℃和15 MPa,染料Ⅱ的最佳染色条件为1.5 h、80℃和15 MPa,染料Ⅳ的最佳染色条件为2 h、80℃和24 MPa.染色后的羊毛纤维的耐皂洗和耐光色牢度都可达4～5级,固色率最高可达86％,相比于未活化的前驱体,耐皂洗色牢度能提高2～3级,固色率最高能提升63％.SEM和显微镜成像证明4例染料具有良好的透染性,且能均匀附着于纤维的表面和内部.力学性能测试表明,染色后的羊毛纤维能基本保持原有的力学性能.