全文获取类型
收费全文 | 666篇 |
免费 | 26篇 |
国内免费 | 12篇 |
专业分类
电工技术 | 3篇 |
综合类 | 45篇 |
化学工业 | 168篇 |
金属工艺 | 49篇 |
机械仪表 | 16篇 |
建筑科学 | 12篇 |
矿业工程 | 13篇 |
能源动力 | 7篇 |
轻工业 | 266篇 |
石油天然气 | 13篇 |
武器工业 | 3篇 |
无线电 | 2篇 |
一般工业技术 | 28篇 |
冶金工业 | 74篇 |
自动化技术 | 5篇 |
出版年
2024年 | 1篇 |
2023年 | 2篇 |
2022年 | 1篇 |
2021年 | 5篇 |
2020年 | 10篇 |
2019年 | 12篇 |
2018年 | 9篇 |
2017年 | 8篇 |
2016年 | 10篇 |
2015年 | 9篇 |
2014年 | 23篇 |
2013年 | 21篇 |
2012年 | 47篇 |
2011年 | 47篇 |
2010年 | 30篇 |
2009年 | 24篇 |
2008年 | 16篇 |
2007年 | 47篇 |
2006年 | 55篇 |
2005年 | 35篇 |
2004年 | 47篇 |
2003年 | 36篇 |
2002年 | 47篇 |
2001年 | 44篇 |
2000年 | 25篇 |
1999年 | 23篇 |
1998年 | 16篇 |
1997年 | 16篇 |
1996年 | 7篇 |
1995年 | 4篇 |
1994年 | 12篇 |
1993年 | 4篇 |
1992年 | 3篇 |
1991年 | 2篇 |
1990年 | 2篇 |
1989年 | 2篇 |
1988年 | 1篇 |
1982年 | 1篇 |
排序方式: 共有704条查询结果,搜索用时 15 毫秒
1.
2.
以特定污泥挂膜的自制厌氧生物滤床系统具有良好的去铬(VI)能力。恒流泵最佳流量为47mL/min,外加碳源使废水COD约140mg/L,铬(VI)的浓度由60mg/L左右降到0.5mg/L以下(一级排放标准),需要4h,而对照组(未加碳源)需要14h。铬(VI)浓度由64.66mg/L提高到75.53mg/L时,对系统负面影响甚微,提高到95.47mg/L时,系统出水达标所需时间延长到7.5h。添加微量金属离子与未添加微量金属离子的情况相比,处理效率提高21.26%。分析试验表明:铬(VI)的去除途径可能是由生物还原作用将六价铬还原为三价铬,形成氢氧化铬沉积于微生物表面。 相似文献
3.
A new sulfonated melamine–urea–formaldehyde (MUF) resin of relatively low melamine content, prepared according to a sequential formulation, has been shown to be highly effective when coupled with different natural vegetable tannins to produce leather with the same good characteristics of leather prepared with chrome salts. In particular, the antishrinkage effectiveness of the leather prepared according to the new approach is comparable to that obtained with chrome tanned leathers. The comparison of the traditional leather shrinkage temperatures test method with a new thermomechanical analysis (TMA) test method in tension yields thermograms presenting three major modulus of elasticity (MOE) peaks. These are closely connected to molecular level phenomena determining the shrinkage temperature of leather. The three determining parameters appear to be as follows: (1) The average value of the temperatures at which the three MOE peaks occur: the higher the value of this average, the lower is the shrinkage of leather. (2) The average of maximum MOE values of the TMA peaks: the higher this average is, the better is the leather in regard to antishrinkage effectiveness. This means the leather maximum MOE at each peak is a measure of the resistance to the contraction force induced by heat. (3) The relative intensity of the first TMA peak in relation to the second: the higher the value of the MOE for the first TMA peak is in relation to the second peak, the lower the leather shrinkage appears to be. However, it has not been possible to better define or quantify this latter effect. This new TMA test method in tension has also yielded a mathematical relationship correlating the thermogram peak temperatures and MOE averages with the traditional shrinkage temperature to a high degree of confidence. A previous TMA test method, in compression, has proven to yield more problematic and finally not very reliable results when one needs to apply it to a wide variety of different cases. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 88: 1889–1903, 2003 相似文献
4.
5.
6.
水煤浆加压气化炉用高铬耐火材料的显微结构及损毁机理 总被引:3,自引:0,他引:3
采用扫描电镜和能谱分析方法 ,分析了水煤浆加压气化炉用高铬砖渣蚀前后的显微结构和相组成 ,探讨了主要损毁机理。结果表明 :煤熔渣与砖反应和渗透引起砖组成的改变 ,从而导致砖的结构剥落和强度弱化是砖损毁的主要原因 ;LIRR -HK90砖的显微结构呈网络状镶嵌结构 ,直接结合程度高 ,与渣反应可生成 (Mg ,Fe) (Al,Cr,Fe) 2 O4 复合尖晶石致密带 ,阻止了渣的进一步渗透 ,减缓渣蚀速度和结构剥落 ,其使用效果优于进口的同类产品 相似文献
7.
8.
9.
利用GC-FPD和TPD-MS考察了浸渍Fe3+和Cr3+对灵石煤热解过程中气体产物逸出的影响.结果表明:Fe3+和Cr3+破坏了煤中的氢键并与煤表面官能团形成活性络合物,使煤样的挥发分增加、固定碳等减少;由于Fe3+的氧化作用,载铁煤中的黄铁矿硫明显减少.低于300℃时,Fe3+和Cr3+促进煤中有机硫分解,增加了H2S和SO2的生成量;300~700℃时,由于Fe3+和Cr3+的固硫反应,转移到气相中的硫急剧减少;700℃时置换为氮气和氢气混合气后,在高温还原性气氛下,Fe和Cr的固硫产物和稳定的有机硫加氢脱硫产生大量的H2S.由于Fe3+和Cr3+促进了煤的热解和初级焦油裂解,CO2,CO,H2O,CH4的生成量增加;金属离子对芳香结构缩聚反应的促进作用增加了H2的生成量,Cr3+对灵石焦煤热解过程中逸出气体的影响强于Fe3+. 相似文献
10.