Effects of non-thermal plasma treating wheat kernel on the physicochemical properties of wheat flour and the quality of fresh wet noodles

The effects of non-thermal plasma (NTP) on the physicochemical properties of wheat flour and the quality of fresh wet noodles ( FWN) were investigated. The results showed that NTP effectively decreased the total plate count (TPC), yeast and mould count (YMC) and Bacillus spp. in wheat flour. Wet gluten contents and the stability time reached the maximum when treated for 20 s. The viscosity of starch increased significantly after treatment due to the increased of damaged starch. The contents of secondary structure were altered to some extent, which was because that the ordered network structure of gluten protein broken. Furthermore, compared with the control, texture properties of FWN were enhanced significantly at 20 s, and the darkening rate of FWN was greatly inhibited due to the low polyphenol oxidase (PPO) activity. Consequently, the most suitable treatment was 500 W for 20 s, providing a basis for the application of NTP in flour products.     

Open‐cycle OTEC systems with freshwater product: Effects of noncondensable gases on performance of condenser

An open‐cycle ocean thermal energy conversion (OC‐OTEC) system is one of the energy conversion methods used to generate electricity from ocean thermal energy. For the OC‐OTEC system, steam evaporated from the surface seawater due to flash evaporation drives the turbine. At that time, dissolved gas such as air is introduced into the low‐pressure system (OC‐OTEC system) as the noncondensable gas, which degrades the performance of condensation heat transfer. In this paper, a small‐scale OC‐OTEC experimental unit experimentally investigates the effect of noncondensable gas on the heat transfer performance in a condenser. The experimental results are discussed in comparison with theoretical estimation by the Sparrow–in method. It is shown that the condensation is occupied by heat and mass transfer near a condensation surface and that the condensation efficiency is affected by exhaust quantity of noncondensable gas at a relatively high concentration ratio of condensable gas. © 2005 Wiley Periodicals, Inc. Electr Eng Jpn, 154(1): 29–35, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20179     

新区采油速度与稳产时间、递减率变化关系研究

针对新区稳产时间以及递减期递减余率大小难以确定等问题,通过对中原油田61个独立小区块进行分析对比,得出采油速度与稳产时间,不同采油速度下无因次采油速度与时间关系曲线,对于新区开发预测稳产时间以及预测递减期产量变化有着重要意义.     

樊口大闸加固工程中的爆破振动分析

在考闸墩上爆破开挖出新的闸门槽，在新浇混凝土附近进行底板爆破开挖，爆破振动对闸墩和新浇混凝土的影响值得重视；介绍了在樊口大闸加固工程中的爆破振动观测成果，并对爆破振动特性进行了分析。     

Air entrainment in fresh concrete with PFA

The results of a study into the influence of PFA on air entrainment in fresh concrete are discussed It is shown that the required dosage of AEA to produce an air content of 5.5 ± 0.5% in a PFA modified concrete mix is two-six times that required in the corresponding neat OPC concrete mix. The dosage of a vinsol based air entraining agent (AEA) required appears to be directly related to the PFA content of the mix. Similar direct relationships were obtained with a range of different PFAs. The dosage of an AEA based on the salt of a fatty acid appears to be sensitive to both PFA and OPC contents. For the type of PFA used, the variability of measured air content or the amount of air retained after continued agitation both indicated that vinsol based AEAs show the highest variability whilst fatty acid based AEAs show low variability. The between batch variability of air content was significantly improved by the addition of PFA regardless of the AEA used.     

恒粘天然橡胶理化性能的研究

用粘度稳定剂处理天然橡胶鲜胶乳和湿杂胶，研究了粘度稳定剂种类及处理方法对橡胶的P0、PRI、MV、氮含量和加速贮存硬化值（△P）等的影响。结果表明，鲜胶乳所制得的恒粘胶经加速贮存后的△P≤1个塑性值，门尼粘度值变化量（△MV）≤3个门尼值。其它性能虽有变化，但均能达到天然生胶标准的要求。自然凝固制得的恒粘胶的P0、PRI和MV相对较高，氮含量相对较低。粘度稳定剂延长了鲜胶乳的凝固时间。粘度稳定剂处理后的杂胶，△P和△MV减少，但恒粘效果不及鲜胶乳制得的恒粘胶。     

Influences of metallic polymeric materials on the properties of fresh polyester and acrylic polymer concrete

To investigate the influences of three metallic polymeric materials in polyester and acrylic fresh polymer concretes (PCs), PC‐incorporated different levels of these materials have been investigated for their properties of fresh PC. The mix design was made and optimized for workability, strength, and economy, depending on the resin viscosity, the intended use, and the additional quantities of these polymeric materials. The properties investigated include workability, working time, and curing time of fresh PC. It is concluded that these polymeric materials offer the possibility of improving properties of polyester and acrylic fresh polymer concretes. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci, 2006     

玻璃钢管在核电站淡水输水工程中的应用

本文阐述了玻璃钢管在淡水输水工程中球墨铸铁管相比有比较明显的技术及经济优势，以及安装施工中应重视的几个问题。     

客户分类下生鲜配送两级路径问题与算法研究

生活水平的提高使得消费者对生鲜产品的需求不断增长,进而促进了冷链物流行业的快速发展。将客户按重要性分为重要客户和普通客户两类,以总配送成本最小为目标,建立考虑客户分类的两级容量有限车辆路径优化模型。提出两阶段启发式算法求解该模型：第一阶段设计改进的遗传-模拟退火算法增强全局搜索能力,其中采用轮盘赌选择机制结合精英保留策略保留优秀个体,部分匹配交叉算子结合自适应交叉率维持种群多样性,Metropolis准则以一定概率接受较差解;第二阶段使用精确方法求解一级配送路径。基于Perboli的Set2算例集和Hemmelmayr的Set5算例集,共30个基准案例,分别将所提出算法与四种现有算法进行对比分析,验证了改进算法的效果,并测试了算法的收敛性。基于模拟数据进行模型分析,验证了所提出模型和算法的有效性和适用性。     

生鲜食品微生物预测及评估平台研究

针对如何快速、有效地评估食品的安全,预测出食品的货架期,拟建立一个生鲜食品微生物预测与品质评估管理平台,通过对生鲜食品中微生物菌群基本状况及优势菌群在生长规律的数据采集,分别构建不同的温度下优势菌群的一级和二级生长模型,实现对生鲜食品货架期的预测。阐述了该平台的基本组成,工作流程,主要数据结构和主要数学模型。该平台能帮助预测生鲜食品在运输、储存和加工过程中的货架期并进行环境控制。