全文获取类型
收费全文 | 2924篇 |
免费 | 299篇 |
国内免费 | 79篇 |
专业分类
电工技术 | 11篇 |
综合类 | 199篇 |
化学工业 | 1028篇 |
金属工艺 | 710篇 |
机械仪表 | 78篇 |
建筑科学 | 46篇 |
矿业工程 | 67篇 |
能源动力 | 33篇 |
轻工业 | 237篇 |
水利工程 | 17篇 |
石油天然气 | 79篇 |
武器工业 | 14篇 |
无线电 | 34篇 |
一般工业技术 | 263篇 |
冶金工业 | 451篇 |
原子能技术 | 23篇 |
自动化技术 | 12篇 |
出版年
2024年 | 4篇 |
2023年 | 19篇 |
2022年 | 54篇 |
2021年 | 86篇 |
2020年 | 91篇 |
2019年 | 60篇 |
2018年 | 70篇 |
2017年 | 85篇 |
2016年 | 89篇 |
2015年 | 97篇 |
2014年 | 141篇 |
2013年 | 188篇 |
2012年 | 233篇 |
2011年 | 182篇 |
2010年 | 124篇 |
2009年 | 172篇 |
2008年 | 127篇 |
2007年 | 181篇 |
2006年 | 180篇 |
2005年 | 170篇 |
2004年 | 122篇 |
2003年 | 120篇 |
2002年 | 120篇 |
2001年 | 110篇 |
2000年 | 79篇 |
1999年 | 56篇 |
1998年 | 52篇 |
1997年 | 47篇 |
1996年 | 34篇 |
1995年 | 36篇 |
1994年 | 25篇 |
1993年 | 26篇 |
1992年 | 21篇 |
1991年 | 15篇 |
1990年 | 21篇 |
1989年 | 9篇 |
1988年 | 7篇 |
1987年 | 10篇 |
1986年 | 7篇 |
1985年 | 5篇 |
1984年 | 4篇 |
1983年 | 2篇 |
1982年 | 6篇 |
1981年 | 6篇 |
1980年 | 3篇 |
1978年 | 2篇 |
1977年 | 1篇 |
1976年 | 2篇 |
1951年 | 1篇 |
排序方式: 共有3302条查询结果,搜索用时 15 毫秒
1.
Mohamed A.El-Nemr Ibrahim M.A.Ismail Nabil M.Abdelmonem Ahmed El Nemr Safaa Ragab 《中国化学工程学报》2021,36(8):199-222
Watermelon peel residues were used to produce a new biochar by dehydration method. The new biochar has undergone two methods of chemical modification and the effect of this chemical modification on its ability to adsorb Cr(VI) ions from aqueous solution has been investigated. Three biochars, Melon-B, Melon-BO-NH_2 and Melon-BO-TETA, were made from watermelon peel via dehydration with 50% sulfuric acid to give Melon-B followed by oxidation with ozone and amination using ammonium hydroxide to give Melon-BO-NH_2 or Triethylenetetramine(TETA) to give Melon-BO-TETA. The prepared biochars were characterized by BET, BJH,SEM, FT-IR, TGA, DSC and EDAX analyses. The highest removal percentage of Cr(VI) ions was 69% for Melon-B,98% for Melon-BO-NH_2 and 99% for Melon-BO-TETA biochars of 100 mg·L~(-1) Cr(VI) ions initial concentration and 1.0 g·L~(-1) adsorbents dose. The unmodified biochar(Melon-B) and modified biochars(Melon-BO-NH_2 and Melon-BO-TETA) had maximum adsorption capacities(Qm) of 72.46, 123.46, and 333.33 mg·g~(-1), respectively.The amination of biochar reduced the pore size of modified biochar, whereas the surface area was enhanced.The obtained data of isotherm models were tested using different error function equations. The Freundlich,Tempkin and Langmuir isotherm models were best fitted to the experimental data of Melon-B, Melon-BO-NH_2 and Melon-BO-TETA, respectively. The adsorption rate was primarily controlled by pseudo-second–order rate model. Conclusively, the functional groups interactions are important for adsorption mechanisms and expected to control the adsorption process. The adsorption for the Melon-B, Melon-BO-NH_2 and Melon-BO-TETA could be explained for acid–base interaction and hydrogen bonding interaction. 相似文献
2.
使用钡盐法对铬废水处理,对p H值在废水中的初值、反映温度计量结果、重铬酸钾的浓度等,在回收六价铬的影响效果进行了分析。对废水中的六价铬使用了源自吸收的分光光度法回收。经过处理后,废水中的p H为8~9的时候,六价铬的回收在9%。废水中的六价铬随着其浓度不断上升增加。超过10℃的时候,六价铬的反应没有非常大的影响,但是当温度降低到10℃以下的时候,回收率就逐步下降了。经过处理之后,六价铬的浓度达到了0.276 7 mg/L,达到了相关规定的标准。 相似文献
3.
通过冲击磨损试验,测试了变形低铬半钢耐磨性,并对其磨损面特征进行了分析。结果表明:该钢变形后经适当的余热热处理可获得较高的耐磨性能。 相似文献
4.
以特定污泥挂膜的自制厌氧生物滤床系统具有良好的去铬(VI)能力。恒流泵最佳流量为47mL/min,外加碳源使废水COD约140mg/L,铬(VI)的浓度由60mg/L左右降到0.5mg/L以下(一级排放标准),需要4h,而对照组(未加碳源)需要14h。铬(VI)浓度由64.66mg/L提高到75.53mg/L时,对系统负面影响甚微,提高到95.47mg/L时,系统出水达标所需时间延长到7.5h。添加微量金属离子与未添加微量金属离子的情况相比,处理效率提高21.26%。分析试验表明:铬(VI)的去除途径可能是由生物还原作用将六价铬还原为三价铬,形成氢氧化铬沉积于微生物表面。 相似文献
5.
主要研究了Cr对低碳Si-Mn系TRIP钢组织与力学性能的影响。首先利用Formastor-F型膨胀仪测定了含Cr和不含Cr两种低碳钢的连续冷却转变(CCT)曲线,分析指出了Cr对连续退火工艺的潜在影响;然后采用Gleeble-3800热/力模拟试验机对两种钢的薄板试样进行了连续退火模拟实验,并通过拉伸试验测定了力学性能;最后采用金相、扫描电镜、X-射线衍射分析等技术考察分析了两种钢的显微组织。结果表明:含Cr的TRIP钢的组织比较细小,铁素体晶粒近似等轴分布;两种TRIP钢的残余奥氏体含量相近,但含Cr钢的残余奥氏体中的含碳量较高。分析认为这是由于含Cr钢在热轧阶段较易生成细小的组织,而在热处理阶段则抑制贝氏体的生成,最终获得稳定的残余奥氏体。 相似文献
6.
7.
抗高温磨损高铬铸铁的研究 总被引:3,自引:0,他引:3
经Mo、B、V、Ti合金化和RE变质处理的高铬铸铁,具有优良的抗高温磨损性能和强韧性,用于制造筛分高温烧结矿的振动筛筛板,使用寿命比ZG30Cr18Mn12Si2N耐热钢筛板提高2倍以上。多元高铬铸铁筛板制造工艺简单,成本低,值得在筛分领域推广使用。 相似文献
8.
Francisco Jos Alguacil Concepcin Caravaca María Isabel Martín 《Journal of chemical technology and biotechnology (Oxford, Oxfordshire : 1986)》2003,78(10):1048-1053
The transport of chromium(VI) through a flat‐sheet supported liquid membrane containing Cyanex 921 as a carrier has been investigated. The permeation of the metal is investigated as a function of various experimental variables: hydrodynamic conditions, concentration of chromium(VI) and HCl in the feed phase, carrier concentration and diluent in the membrane and strippant concentration in the stripping phase. The mass transfer coefficient and the thickness of the aqueous boundary layer were calculated from the experimental data. Furthermore, the selectivity of Cyanex 921‐based flat‐sheet supported liquid membrane towards different metal ions and the behaviour of the system against other carriers are presented. Copyright © 2003 Society of Chemical Industry 相似文献
9.
The interaction between thin films of hydrogenated amorphous silicon and sputter-deposited chromium has been studied. Following
deposition of the chromium films at room temperature, the films were annealed over a range of times and temperatures below
350°C. It was found that an amorphous silicide was formed only a few nanometers thick with the square of thickness proportional
to the annealing time. The activation energy for the process was 0.55±0.05 eV. The formation process of the silicide was very
reproducible with the value of density derived from the thickness and Cr surface density being close to the value for crystalline
CrSi2 for all films formed at temperatures ≤300°C. The specific resistivity of the amorphous CrSi2 was ≈600 μΩ·cm and independent of annealing temperature. 相似文献
10.
Modified Imidazoles: Degradation Inhibitors and Adhesion Promoters for Polyimide Films on Copper Substrates 总被引:1,自引:0,他引:1
Polyimide films on copper substrates that are exposed to elevated temperatures and an oxidizing environment will be subject to degradation. In order to halt this degradation without changing the properties of the system, a polymeric agent could be placed between the polyimide and the copper. This paper will investigate three such materials that will not only slow down the degradation of the polyimide and the oxidation of the copper, but will also improve adhesion within the system. Fourier transform infrared reflection-absorption spectroscopy (FTIR-RAS) will be used to investigate the polyimide/polymeric agent/copper system. 相似文献