LTE系统多小区上行联合功控算法

针对传统的小区内开环功率控制算法通常以提升本小区的吞吐量性能为目标，忽略了当前小区用户对邻小区用户同频干扰的问题，为提升边缘用户性能的同时兼顾系统整体性能，提出了一种LTE系统小区间上行联合功率控制（UJPC）算法。该算法采用单基站三扇区为系统模型，以最优化系统吞吐量比例公平函数为目标，首先根据最小信干噪比（SINR）约束值和用户最大发射功率这两个约束条件得到相应的数学优化模型，然后采用连续凸近似的方法求解优化问题得出各个基站所管辖的小区内所有用户的最优发射功率。仿真结果表明，与基准的开环功控方案相比，联合功控方案在保证系统平均频谱利用率的情况下能够较大幅度地提高小区边缘频谱利用率，其最佳性能增益能达到50%。     

配网侧接入电源对负荷建模的影响

研究了配网侧接入电源对负荷建模的影响。发现当配网侧电源的发电容量逐渐增大时，原有的感应电动机并联恒阻抗、恒电流、恒功率（ZIP）模型的负荷模型将不再能很好地反映该区域的负荷特性，进而提出了一种新的负荷模型结构———异步发电机并联ZIP模型。通过仿真计算，验证了该新负荷模型的有效性，并进一步统一了上述2种负荷模型，称为异步机并联ZIP负荷模型。     

混凝土外加剂在防渗工程中的应用

根据江东灌区的工程实际，总结了在渠道防渗工程中混凝土外加剂应用情况，提出了应用中的注意事项。     

Some investigations on fuzzy P + fuzzy I + fuzzy D controller for non-stationary process

The paper addresses the adaptive behaviour of parallel fuzzy proportional plus fuzzy integral plus fuzzy derivative (FP+FI+FD) controller. The parallel FP+FI+FD controller is actually a non-linear adaptive controller whose gain changes continuously with output of the process under control. Two non-stationary processes, whose characteristics change with time, are considered for simulation study. Simulation is performed using software LabVIEW TM . The set-point tracking response of parallel FP+FI+FD is compared with conventional parallel proportional plus integral plus derivative (PID) controller, tuned with the Ziegler-Nichols (Z-N) tuning technique. Simulation results show that conventional PID controller fails to track the set-point and becomes unstable as the process changes its characteristic with time. But the parallel FP+FI+FD controller shows considerably much better set-point tracking response and does not deviate from steady state. Also, a huge spike is observed in the output of PID controller as the reference set-point and process parameters are changed, while the FP+FI+FD controller gives spike free control signal.     

多小区多播无线携能通信鲁棒信干噪比平衡

针对非理想信道多小区多播协作网络中的供能问题,提出了一种鲁棒的无线携能通信优化方案,该方案以最差用户信干噪比最大化为目标、以每用户能量采集和每小区功率为约束,在保证用户能量采集约束和系统功率预算的前提下实现最差用户服务质量最优化.为了求解优化问题,采用半定松弛和S-引理将原始问题转化为拟凸优化问题,进而采用二分迭代算法得到问题的最优解.仿真结果表明,所提系统设计正确,迭代算法收敛特性良好.     

50%丁莠悬浮剂的制备

以50％丁莠悬浮剂为例。介绍了用莠去津原粉直接研磨的方式制备悬浮剂时。助剂的选择和制备方法，研究了助剂对贮存稳定性的影响和研磨速率及研磨时间对莠去津粒度、悬浮刺贮存稳定性的影响。该方法制备的悬浮剂成本低、质量稳定、使用安全。     

An analytical tuning approach to multivariable model predictive controllers

Multivariable model predictive control is a widely used advanced process control methodology, where handling delays and constraints are its key features. However, successful implementation of model predictive control requires an appropriate tuning of the controller parameters. This paper proposes an analytical tuning approach to multivariable model predictive controllers. The considered multivariable plants are square and consist of first-order plus dead time transfer functions. Most of the existing model predictive control tuning methods are based on trial and error or numerical approaches. In the case of no active constraints, closed loop transfer function matrices are derived and decoupling conditions are addressed. For control horizon of one, analytical tuning equations and achievable performances are obtained. Finally, simulation results are used to verify the effectiveness of the proposed tuning strategy.     

Electrochemical behaviour of heat-treated AlZnMg alloys in chloride solutions containing sulphate

The electrochemical corrosion and passivation of Al5Zn1.7Mg0.23Cu0.053Nb alloys, submitted to different heat treatments (cold-rolled, annealed, quenched and aged, and quenched in two steps and aged), in sulphate-containing chloride solutions, has been studied by means of cyclic polarization, electrochemical impedance spectroscopy (EIS), scanning electron microscopy (SEM), energy-dispersive X-ray (EDX), and X-ray photoelectron spectroscopy (XPS). The cyclic polarization curves showed that sulphate addition to the chloride solution produced a poor reproducible shift of the breakdown potential to more positive potentials. The repassivation potentials, much more reproducible, and practically separating the passive from the pitting potential region, were slightly displaced in the negative direction with that addition. When the alloys were potentiodynamically polarized in the passive potential region, sulphate was incorporated in the oxide film, thus precluding chloride ingress. In addition, Zn depletion was favoured, whereas Mg losses were avoided. Different equivalent circuits corresponding to different alloys and potentials in the passive and pitting regions were employed to account for the electrochemical processes taking place in each condition. This work shows that sulphate makes these alloys more sensitive to corrosion, increasing the fracture properties of the surface layer and favouring the pitting attack over greater areas than chloride alone.     

TSP203Plus超前地质预报技术在贵广铁路客运专线长大隧道施工中的应用技术研究

贵广铁路线路中特大长隧道、特大断面的隧道所占比例达到75%以上,隧道穿越某些地质情况复杂地区,可能遇到的工程地质问题及地质灾害较一般浅埋隧道更多、更严重。因此,在隧道施工中开展超前地质预报工作非常有必要。TSP203plus的工作原理和系统工作特点能满足工程预报需要。在贵广铁路部分隧道超前地质预报中证实了TSP203plus作为一种隧道地质预报手段的合理性和有效性。在对TSP203plus超前地质预报产生的误差原因进行分析的同时,提出了提高预报精度对策,从而指导不良地质条件下的隧道安全快速施工。     

群策式智能多联机末端在大学教学楼的设计应用与分析

建筑能耗占全国能耗比重较大,中央空调在公共建筑中使用广泛,滥用无管理使得公共建筑夏季空调能耗很高。本文针对大学中多联机中央空调系统以末端智能调控系统控制策略方向为目的进行基于群策控制智能末端控制改造,达到节能的目的。通过单片机对空调控制面板进行电信号控制,数据判断及传输通过总服务器进行计算。控制方式采用自动控制与群策相结合,由微信公众号进行查询及发送命令,通过网络传输和数据库相连。数据库录入空调系统使用教室信息、工作及学习时段表等相关数据。从调研、设计、模拟来看,节能效果显著,最理想节能量可达84%,在调研过程中大部分学生对此可接受。