Influence of metal-support interactions on reaction pathways over Ni/CeZrOx–Al2O3 catalysts for ethanol steam reforming

This work investigates selective Ni locations over Ni/CeZrO_x–Al₂O₃ catalysts at different Ni loading contents and their influences on reaction pathways in ethanol steam reforming (ESR). Depending on the Ni loading contents, the added Ni selectively interacts with CeZrO_x–Al₂O₃, resulting in the stepwise locations of Ni over CeZrO_x–Al₂O₃. This behavior induces a remarkable difference in hydrogen production and coke formation in ESR. The selective interaction between Ni and CeZrO_x for 10-wt.% Ni generates more oxygen vacancies in the CeZrO_x lattice. The Ni sites near the oxygen vacancies enhance reforming via steam activation, resulting in the highest hydrogen production rate of 1863.0 μmol/g_cat·min. In contrast, for 15 and 20-wt.% Ni, excessive Ni is additionally deposited on Al₂O₃ after the saturation of Ni–CeZrO_x interactions. These Ni sites on Al₂O₃ accelerate coking from the ethylene produced on the acidic sites, resulting in a high coke amount of 19.1 mg_c/g_cat·h (20Ni/CZ-Al).     

浅谈延迟焦化装置露天栈桥的设计

根据延迟焦化装置露天栈桥的工程设计实践,围绕一炉两塔(一个加热炉两个焦炭塔)的焦化装置,分析了露天栈桥设计中的要点及难点,对其在平面布置、基础安排和吊车梁选型等设计方面做一些介绍和论述。     

焦炭反应性试验影响因素分析

针对梅山自产焦炭，利用梅山焦炭反应性试验设备，通过改变焦炭块数、CO2流量和温度等控制参数，讨论了这些参数对焦炭反应性和反应后强度检测值的影响，以及保证测定可靠性应采取的控制措施。     

焦化加热炉爆管故障分析与预防

焦化加热炉炉管内的物料通常为有杂质容易结焦的混合渣油,如果设计不合理、操作控制不当、运行周期过长等,极易造成炉管爆管事故。以2005年9月大庆石化分公司炼油厂焦化加热炉爆管故障为例,阐述了焦化加热炉的爆管原因、故障处理及预防措施,认为注水量小、渣油中含催化剂、负荷偏离设计工况、烧焦周期和烧焦速度不当等引起严重结焦是爆管的主要原因。     

焦炉装煤烟尘治理的烟气量计算

通过对焦炉装煤烟尘治理的烟气量计算和研究,提出不同治理系统的烟气量计算方法及应采取的措施。     

Electrochemical improvement of low-temperature petroleum cokes by chemical oxidation with H2O2 for their use as anodes in lithium ion batteries

The electrochemical performance of non-graphitized petroleum cokes has been improved by mild oxidation using hydrogen peroxide, a procedure used for the first time in these materials. For this purpose, various carbonisation temperatures and H₂O₂ treatments were tested. For low sulfur content cokes, the aqueous oxidative treatment significantly increases the capacity values above 372 mAh/g during the first cycles. In contrast, cokes with a sulfur content of ca. 5%, did not shown a real improvement. The former results have been interpreted in terms of an effective oxidation of the particles surface, which removes unorganized carbon, where lithium can be irreversibly trapped. Moreover, a stable and less resistive passivating layer grows during the first discharge of lithium, as revealed by impedance spectroscopy. Therefore, chemical procedures, as mild oxidation, open an interesting field of research for the improvement of disordered carbons as anode materials in lithium ion batteries.     

Sulfur distribution in coke and sulfur removal during pyrolysis

In order to investigate the mechanisms of coke desulfurization by blowing additional gas into coking chamber during pyrolysis process, some experiments were conducted to study the effects of some factors on the distribution of sulfur in coke. These factors include pyrolysis temperatures, the kinds of the blowing gases and the diameters of coking chamber. It was found that sulfur was mainly released at the range of 300–600 °C. Under this temperature range, the sulfur content in coke can be reduced by 0.05–0.06% by blowing N₂, CO or CH₄, and by 0.14% by blowing H₂ at a space velocity of 1.2 mm/s compared with the absolute sulfur content of 0.92% in the case without gas feeding. Obviously, H₂ is more effective on sulfur removal than N₂, CO or CH₄. The total, organic and inorganic sulfur contents in coke increase with increasing the diameter of coking chamber under identical pyrolysis conditions. Both organic and inorganic sulfur contents in coke increase regularly from the center to brim at identical height of a coke column for all the cases. In addition, the organic and inorganic sulfur contents at the cranny surface are higher than those in interior at the same sampling position. X-ray photoelectron spectroscopy (XPS) analyses suggest that the main contributions to the increase of inorganic and organic sulfur contents are due to the formation of negative bivalent sulfur and thiophenic compounds, respectively.     

高喷煤比操作对焦炭劣化的影响

为考查提高喷煤量对焦炭在炉内劣化的影响,在宝钢高炉上进行了风口取样研究.结果表明,喷煤量达到200 kg/t以上时焦炭劣化严重.高炉生产实绩回归显示,焦炭的热性能对高炉透气性的影响比冷强度显著.分析认为焦炭热性能指标CRI、CSR对高炉高煤比操作更重要.借此还提出了提高喷煤量和改善焦炭质量需加强研究的课题.     

异构化催化剂Pd／HM结焦失活的再生

运用ＴＥＭ、ＴＰＤ、ＸＲＤ等技术考察了烧焦温度对异构化催化剂Ｐｄ／ＨＭ再生性能的影响。结果表明：在８２３Ｋ时，催化剂上金属钯粒子能重新分散，催化剂恢复活性，且稳定性不变，二次再生性也较好。     

相位测量定位法在焦炉车辆上的应用与研究

文中通过测量载波相位进行定位的方法来解决焦炉车辆的定位问题，以达到无线定位的目的。并对定位的数学模型进行了详细的分析与论述。