Theoretical investigation of intrinsic point defects and the oxygen migration behavior in rare earth hafnates

In this work, the composition-dependent point defect types and formation energies of RE₂Hf₂O₇ (RE = La, Ce, Pr, Nd, Pm, Sm, Eu and Gd) as well as the oxygen diffusion behavior are systematically investigated by first-principles calculations. The possible defect reactions and dominant defect complexes under stoichiometric and non-stoichiometric conditions are revealed. It is found that O Frenkel pairs are the predominant defect in stoichiometric pyrochlore hafnates. Hf-RE cation anti-site defects, accompanied by RE vacancies and/or oxygen interstitials, are stable in the non-stoichiometric case of HfO₂ excess. On the other hand, RE-Hf anti-site defects together with oxygen vacancies and/or RE interstitials are preferable in the case of RE₂O₃ excess. The energy barriers for the migration along the V_O48f - V_O48f pathway of pyrochlore hafnates were calculated to be between 0.81 eV and 0.89 eV. Based on these results, a defect engineering strategy is proposed and the pyrochlore hafnates investigated here are predicted to exhibit potential oxygen ionic conductivity.     

Efficient utilization of silanol group in rice husk to promote the synthesis of Ni-phyllosilicate for CO2 methanation

It is a challenge to prepare Ni-phyllosilicate catalysts deriving from the reaction of nickel salts and biomass-based silica with high Ni contents. In order to efficiently synthesize nickel phyllosilicate, the acid-treated rice husk without calcination (P-R) was directly used as the raw material. The as-synthesized Ni-phyllosilicate (N/P-R) exhibited high nickel content of 46.7 wt% owing to utilization of the abundant silanol group in the fresh rice husk. On the contrary, the Ni content of Ni-phyllosilicate sample (N/R–S) prepared using the calcinated rice husk-based silica was only 4.8 wt% because of the loss of silanol group during calcination process. As a result, N/P-R displayed much higher catalytic activity for CO₂ methanation than N/R–S. It was found that the silanol group was in favour of forming the important intermediate Si(OH)₄, and thereby facilitated the formation of nickel phyllosilicate. In addition, the N/P-R catalyst demonstrated superior stability and excellent anti-sintering ability in the long lifetime test. In short, the proposed method in this work could not only efficiently synthesize nickel phyllosilicate with high Ni content, but also reduce energy consumption and operation steps compared to the one prepared using biomass-based silica.     

四川盆地及邻区上二叠统一下三叠统海槽的深水沉积特征

四川盆地及邻区广元-旺苍、城口-鄂西、开江-梁平海槽是上二叠统一下三叠统飞仙关组（P3-T1f）的深水碳酸盐沉积区。该区上二叠统上部大隆组是硅质岩、硅质泥岩、硅质灰岩组合，含放射虫、有孔虫等化石，厚125—29．0m，为海槽裂陷期凝缩沉积。三叠系飞仙关组下部为远洋沉积的暗色泥岩、微晶碎屑灰岩和重力流沉积的浊积岩、角砾灰岩组成的深水碳酸盐沉积，厚50．0～300．0m，是裂陷期后的海槽充填沉积。海槽相区沉积在晚二叠统世末达到最大海泛面沉积了大隆组。海平面缓慢下降期沉积了补偿充填性质的飞仙关组深水碳酸盐岩。海槽相区上二叠统一下三叠统飞仙关组构成了一个完整的三级层序。深水沉积物的有机碳平均值高达6．21％，是良好的烃源岩。但在海槽相区上二叠统不发育生物礁，飞仙关组缺乏鲕粒岩。     

富县探区长6段油藏特征与勘探对策分析

富县探区三叠系延长组长6段普遍见到不同级别的油气显示,但试油未能获得工业油流.据分析,该区白垩纪末的抬升和翘倾运动使油气发生了第三次运移成藏,油、气、水重新分布并受储层物性控制.正确勾画出有利沉积相带、针对油藏特征采取更有效的工艺技术,是实现该区勘探突破的关键.     

离子色谱技术在钻井现场的应用研究

将离子色谱技术(IC)应用于钻井现场的钻井液滤液分析,从而获取所钻井钻遇地层的可溶性矿物的性质、地层水的类型等资料信息。离子色谱技术在这一领域的应用尚属探索阶段,但通过现场两口井的试用已见到较好的应用效果,文章简介了该技术的应用前景及价值,如:确定油水界面的位置及指导钻井液的调配、确保井下安全等。这方面的论述,对分析化验仪器向井场转移实现多手段综合分析具有一定的促进作用。     

Continuous formation of slurry ice by cooling water–oil emulsion in a tube

Water-silicone oil emulsion with an additive, (C₂H₅O)₃SiC₃H₆NH₂, was examined as a heat storage material. A spiral tube used as a heat exchanger was immersed in a low temperature bath and the emulsion was circulated in the tube to make ice continuously. Ice was separated from the ice–liquid suspension in an outlet tank. The amount of formed ice, the temperatures of the inlet and the outlet of the heat exchanger, and the temperatures in the tube wall were measured and the overall heat transfer coefficient and the heat flux through the tube were calculated. Experiments were carried out, varying the flow rate, the temperature of cooling brine, and the thickness of tube wall. The condition under which slurry ice was formed continuously without adhesion of ice to the cooling wall was clarified. Though decrease in the thermal resistance of the tube increased the rate of ice formation or raised the brine temperature, it narrowed the range of the flow rate and of the brine temperature in which slurry ice was formed continuously.     

砾岩油藏合理注采压力系统研究--以七中东区八道湾组油藏为例

注采压力系统指的是从注水泵站到采油井井口的各环节的压力配置 ,在这一压力系统中 ,地层压力和油井流动压力是决定整个压力系统的关健 ,也是油藏工程研究的核心。本文利用油藏工程方法对砾岩油藏高含水期油井和注水井的地层压力、流动压力等注采压力系统进行了研究界定 ,将为砾岩油藏的开发水平提供技术支持     

垦东地区上第三系馆陶组上段成藏规律研究

通过对山东垦东地区构造特征，地层特征和储层特征的研究，从油气运聚，储盖组合，油藏类型及分布和油气控制因素等方面对馆陶组上段成藏规律进行了综合分析，研究表明，研究区的储层主要为曲流河沉积砂体，原油来源于周边的4个生油凹陷，通过不整合曲，储集层以及断层运移到垦东地区后聚集成藏。     

Kinetochemical and morphological differentiation of ettringites by the Le Chatelier-Anstett test

In this research, former XRD experiments have been verified by Le Chatelier-Ansttet (L-A) test. For this purpose, 28 cements consisting of 7 Portland cements and 21 blended cements containing 20%, 30% and 40% metakaolin have been submitted to the Le Chatelier-Anstett (L-A) test for 2 years. With all these cements, L-A specimens were manufactured and a direct parameter was measured for these specimens: increase in diameter, Δ∅, or diameter growth. Other complementary determinations were chemical analysis, XDA patterns and SEM of ettringites and specific properties of some cements tested. The experimental results have borne out that the formation rate of the ettringite formed from the reactive alumina, Al₂O₃^r−, present in pozzolans must be considerably higher than the formation rate of the ettringite from C₃A and much higher than the ettringite from C₄AF, both present in OPC. Owing to this, these ettringites were proposed being named “rapid formation” (ett-rf), “slow formation” (ett-lf) and “very slow formation” (ett-vlf) ettringites, respectively. On the other hand, these experimental results have also shown that the ett-rf has a much smaller size than the ett-lf (this is a direct consequence of the aforementioned conclusion); that almost all the alumina, Al₂O₃, present in M pozzolan must be regarded as being “reactive,” Al₂O₃^r−, or at least, the greatest part; that the detrimental effects derived from gypsum attack are shown much earlier in these POZC than in their plain OPC and, to such an extent, that this aggressive action can be described as rapid gypsum attack; and that none of the 21 POZC tested can be described as high nor moderate sulphate resistant cements according to L-A test.     

SEISMIC FACIES ANALYSIS BASED ON 3D MULTI-ATTRIBUTE VOLUME CLASSIFICATION, DARIYAN FORMATION, SE PERSIAN GULF

Interpretation of recently acquired 3D seismic data from the adjacent Sirri C and D oilfields in the SE Persian Gulf indicates that a 3D interpretation of seismic facies is crucial to resolve the internal stratal geometries of the Aptian Dariyan Formation. This carbonate formation passes southward into the Shu'aiba Formation, a prolific reservoir rock of similar facies in the UAE. Lack of exposures and limited cored intervals have forced reliance on the seismic data for evidence of the depositional environment and the internal architecture of potential reservoir rocks. The progradational nature of the Dariyan Formation and the occurrence of carbonate build‐ups within it make this stratal geometry complex. The complex internal heterogeneity of the build‐ups and presence of seismic noise make mapping of the build‐ups in 3D space using conventional seismic interpretation tools difficult, despite the availability of high‐quality 3D seismic data covering the area. The high quality seismic and limited well data from this field is one of the few datasets of this kind presented in the literature. A procedure for the hierarchical multi‐attribute analysis of seismic facies using Paradigm's Seis Facies software is used in this study to provide a 3D interpretation of the stratal patterns. Principal component analysis reduces the noise and redundant data by representing the main data variances as a few vector components in a transformed coordinate system. Cluster analysis is performed using those components which have the greatest contribution to the maximum spread of the data variability. Six seismic attribute volumes are used in this study and the result is a single 3D classified volume. Important new information obtained from within the Dariyan Formation gives new insights into its stratigraphic distribution and internal variability. This method of processing seismic data is a step towards exploring for subtle stratigraphic traps in the study area, and may help to identify exploration targets.