Performance of BaZrO3/Y2O3 dual-phase refractory applied to TiAl alloy melting

Vacuum induction melting is a potential process for the preparation of TiAl alloys with good homogeneity and low cost. But the crucial problem is a selection of high stability refractory. In this study, a BaZrO₃/Y₂O₃ dual-phase refractory was prepared and its performance for melting TiAl alloys was studied and compared with that of a Y₂O₃ refractory. The results showed the dual-phase refractory consisted of BaZr_1-xY_xO_3-δ and Y₂O₃(ZrO₂), exhibited a thinner interaction layer (30 μm) than the Y₂O₃ refractory (90 μm) after melting the TiAl alloy. Although the TiAl alloys melted in the dual-phase and Y₂O₃ refractory exhibited similar oxygen contamination (<0.1 wt%), the alloy melted in the dual-phase refractory had smaller Y₂O₃ inclusion content and size than that in the Y₂O₃ refractory, indicating that the dual-phase refractory exhibited a better melting performance than the Y₂O₃ refractory. This study provides insights into the process of designing highly stable refractory for melting TiAl alloys.     

A distributed state estimation method for power systems incorporating linear and nonlinear models

High-voltage transmission networks are commonly equipped with phasor measurement units (PMU), and some of them are PMU observable. However, PMUs are seldom installed in distribution networks due to budget limitations. The state estimation equations of PMU observable areas are linear, while those of other areas remain nonlinear. This paper proposes a new distributed state estimation method for solving multi-area state estimation problems, in which linear models are used for high-voltage transmission network, while nonlinear models are adopted for other areas. In PMU observable area, we select coordinating variables as generalized cost functions which accurately represent the sensitivity between the linear SE objective function and boundary states. Consequently, SE results identical to a centralized estimator can be obtained without iterations at the coordination level. This paper presents the problem model and theoretical analysis of the proposed method, and shows its effectiveness by numerical tests.     

Inducing sustained oscillations in feedback-linearizable single-input nonlinear systems

The present paper concerns the induction of stable sustained oscillation in feedback-linearizable single-input affine nonlinear dynamical systems via continuous-time state feedback control. The proposed application-oriented control approach is based on the conception of a state feedback controller that ensures the tracking of a limit cycle characterized in terms of the feedback-linearized system. Boundedness and convergence of the closed-loop trajectories are established following the Lyapunov theoretical framework and applying LaSalle׳s stability principle. The proposed approach is demonstrated with computer-simulated control experiments, showing that it ensures the convergence of the state trajectories of the controlled system to a designed limit cycle and that the methodology can, in principle, be applied to any single input feedback linearizable system.     

微球聚焦测井仪小极板的理论及实验研究

本文对微球聚焦测井仪小极板进行研究，利用有限元法计算了小极板的均质及非均质Ｋ值，并与实验结果进行了比较，结果表明理论值怀实验值吻合较好，说明了理论计算的正确性，给出了对应于小极板的泥饼校正图版及屏流比曲线，对小极板的推广应用有实用价值。     

低渗透率地层渗透率的确定方法

结合大庆油田外围低渗透率地层的地质特点,根椐渗流理论和岩心分析资料,分析了地层渗透率与孔隙度、组成地层的各种矿物含量以及泥质含量之间的关系,建立了不同矿物组合地层的渗透率计算方程。用本方法计算的和岩心分析的渗透率进行了对比,二者之间具有较好的一致性。     

汽车稳定杆组织与疲劳性能研究

对28Mn6钢制造的汽车稳定杆，分别采用整体感应加热－整体淬火、连续感应加热淬火两种不同热处理工艺，并进行了台架疲劳寿命试验，采用光学显微镜和扫描电镜，分析了经两种不同热处理工艺处理的稳定杆的金相组织及其早期疲劳断裂的断口形貌，提出，获得细小的高韧性索氏体组织是保证良好疲劳寿命的关键，稳定杆喷丸表面质量，游离铁素体也是影响疲劳性能的重要因素。     

Induction in the Timed Interval Calculus

The Timed Interval Calculus, a timed-trace formalism based on set theory, is introduced. It is extended with an induction law and a unit for concatenation, which facilitates the proof of properties over trace histories. The effectiveness of the extended Timed Interval Calculus is demonstrated via a benchmark case study, the mine pump. Specifically, a safety property relating to the operation of a mine shaft is proved, based on an implementation of the mine pump and assumptions about the environment of the mine.     

中子寿命测井在评价管外窜槽中的应用

管外窜槽已成为制约中原油田注水开发的障碍，并造成了严重的经济损失。文中分析了管外窜槽的形成机理，重点介绍了注硼中子寿命测井技术用于管外窜槽监测的原理、工艺及解释方法。结合中原油田的应用实例，论证了中子寿命测井评价管外窜槽的有效性，为油藏动态监测提供了有效手段。     

关于碳氧比测井的几个问题

本文根据碳氧比测井技术的发展现状,提出5个值得讨论的问题,并较详细地阐述了对这些问题的看法。这5个问题是:碳氧比测井的地质—物理基础、总门本底谱、数字与模拟量传输技术、对仪器幅度稳定性的要求和仪器屏蔽系统设计。     

基于嵌入式以太网的异步电机矢量控制系统体系结构设计

为了实现异步电机现场控制与上层管理的无缝集成，提出在通用变频器一异步电动机调速系统的基础上，采用基于ARM7TDMI核的微控制器和以太网控制芯片，实现异步电机的网络化控制。详细介绍了该系统的体系结构设计方案。