Evaluation of Scale and Corrosion Inhibition of Modified Polyaspartic Acid

Amino acid modified polyaspartic acids were evaluated as calcium-scale inhibitors. Feasibility of scale inhibition experiments was analyzed by molecular dynamics simulation and Gaussian optimization, and the scale inhibition mechanism was theoretically analyzed. Scale inhibition performance was studied by scanning electron microscopy, X-ray diffraction, X-ray photoelectron spectroscopy, static scale inhibition experiments, and electrochemical performance testing, which provided an experimental basis for the molecular dynamics simulation. The experimental results showed that Arg-SA-PASP has better scale inhibition and corrosion inhibition performance than His-SA-PASP. The scale inhibition effect increased with increasing concentration. Electrochemical tests indicated that Arg-SA-PASP is an excellent scale and corrosion inhibitor.     

Two-step pyrolytic engineering to form porous nitrogen-rich carbons with a 3D network structure for Zn-air battery oxygen reduction electrocatalysis

It is of great urgency to design inexpensive and high-performance oxygen reduction reaction (ORR) electrocatalysts derived from biowastes as substitutes for Pt-based materials in electrochemical energy-conversion devices. Here we propose a strategy to synthesize three-dimensional (3D) porous nitrogen-doped network carbons to catalyze the ORR from two-step pyrolysis engineering of biowaste scale combined with the use of a ZnCl₂ activator and a FeCl₂ promotor. Electrochemical tests show that the synthesized network carbons have exhibited comparable ORR catalytic activity with a half-wave potential (~0.85 V vs. RHE) and outstanding cyclical stability in comparison to the Pt/C catalyst. Beyond that, a high electron transfer number (~3.8) and a low peroxide yield (<7.6%) can be obtained, indicating a four-electron reaction pathway. The maximum power density is ~68 mW cm^?2, but continuous discharge curves (at a constant potential of ~1.30 V) for 12 h are not obviously declined in Zn-air battery tests using synthesized network carbons as the cathodic catalyst. The formation of 3D porous structures with high BET surface area can effectively expose the surface catalytic sites and promote mass transportation to boost the ORR activity. This work may open a new idea to prepare porous carbon-based catalysts for some important reactions in new energy devices.     

基于儿童使用主体的建成环境评价尺度研究

评价尺度是建筑使用后评价的基 本问题之一，它是使用者评判建成环境好 坏、优劣的重要测度标准。为弥补目前环境 评价尺度研究方面的缺失，建立与儿童使用 主体相一致的建成环境评价尺度，对儿童常 用语义量词进行汇总和筛选，采用五级线 分刻度方法进行问卷调查研究。基于儿童的 理解，通过问卷试验分析，结果表明：双侧 5级区间评价尺度为：很（负面）；有点（负 面）；中等；有点（正面）；很（正面）；单侧 5级区间评价尺度为：不；好像有点；比较； 很；特别。     

The development of a single-item Food Choice Questionnaire

Based on the multi-item Food Choice Questionnaire (FCQ) originally developed by Steptoe and colleagues (1995), the current study developed a single-item FCQ that provides an acceptable balance between practical needs and psychometric concerns. Studies 1 (N = 1851) and 2 (2a (N = 3290), 2b (N = 4723), 2c (N = 270)) showed that the single-item FCQ scale has good convergent and discriminant validity. Generally, the results showed the highest correlations with the related multi-item dimensions (>0.40). Study 2 refined the scale. Only the items for convenience (Study 2a), sensory appeal (Study 2b) and mood (Study 2c) needed to be revised (as Study 1 showed a correlation between the multi-item and the single-item below the threshold of 0.60). The results also showed comparable predictive validity. Both methods revealed similar association patterns between food motives and consumption behaviours (Fisher’s z tests revealed agreements of 86.2% for Study 1, 92.9% for Study 2a and 100% for Studies 2b and 2c). Study 3 (N = 6062) showed an example of the added value of a context-specific application for the single-item FCQ. Different motives were shown to be relevant across contexts, and the context-specific motives had additional explained variance beyond the general multi-item FCQ. Studies 2b and 3 also showed the performance of the single-item FCQ in an international context. In sum, the results indicate that the single-item FCQ can be used as a flexible and short substitute for the multi-item FCQ. The study also discusses the conditions that should be considered when using the single-item scale.     

Scale Up from Small Oven-Drying Tests of Mineral Concentrate to Pilot-Scale Drying with a Heated Pad

While Fickian diffusion models are commonly used in other applications, there are few reports of them being applied to the batch drying of a mineral concentrate. Diffusion coefficients estimated from small-scale oven-drying tests were used to predict the drying behavior of a concentrate sample 1 m × 1 m in area and 50 cm deep, with a heated bottom pad. These pilot-scale tests included both daily turning of the sample and turning every three days. The excellent quantitative agreement between the predicted and observed pilot-scale behavior gives a high level of confidence in the model predictions and suggests that a Fickian diffusion model is adequate to predict the behavior of mineral concentrates at the low moisture contents used here.     

Two-Dimensional Physical and Numerical Modeling of a Pile-Supported Earth Platform over Soft Soil

This paper focuses on the mechanisms occurring in a granular earth platform over soft ground improved by rigid piles. Two-dimensional physical model experiments were performed using the Schneebeli’s analogical soil to investigate the load transfer mechanisms by arching and the settlement reduction and homogenization. Experimental outputs are compared to results obtained on a numerical model using a plane strain continuum approach. The impact of the constitutive model complexity to simulate the platform material behavior was first assessed, but no large difference was recorded. As far as the proposed model, which takes the main features of the observed behavior satisfactorily into account, the numerical procedure could be validated and the parametric studies extended numerically. Both approaches of this study underlined the main geometrical and geotechnical parameters which should inevitably be taken into account in a simplified design method, namely the capping ratio, the platform height, and the platform material shear strength.     

Reliability and Validity of the Revised Children's Manifest Anxiety Scale in a French-Canadian Sample.

The aim of this study was to examine the reliability and validity of a French version of the Revised Children's Manifest Anxiety Scale (RCMAS). A sample of 2,666 school-age French-Canadian children completed the questionnaire. With regard to factor structure, the 5-factor model found in U.S. normative samples was confirmed. The internal consistency of the 5 scales and of the 2 global scales was good to excellent. Test-retest reliabilities after a 6-month period were also similar to those of the original version. Finally, the concurrent validity, assessed by a correlation with the State-Trait Anxiety Inventory for Children, was also found to be good. Results of the present study show that the French version of the RCMAS is a good instrument to assess anxiety in children. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Silica removal from Mokai, New Zealand, geothermal brine by treatment with lime and a cationic precipitant

Preliminary experiments using two chemicals (CaO, a quicklime, and a cationic nitrogen-bearing precipitant, EC-004) to remove silica from geothermal brine were undertaken at the Mokai geothermal plant, New Zealand. The brine was mixed with the reagent (CaO or EC-004). The reaction was studied from the start of the experiment (NRT, 0 min, no retaining time) and after 15 min (15RT) at 90 °C. The concentration of silica in the brine was initially 954 mg/l, and decreased linearly with increasing reagent concentration. When CaO is added, the silica concentration at 15RT was 200 mg/l lower than at NRT and became almost zero on addition of 1.5 g/l. In contrast, when EC-004 is added, the total silica concentration nearly reaches the solubility of amorphous silica at 90 °C. In order to prevent silica scaling in Mokai brines cooled to 90 °C, the CaO and EC-004 added should be individually adjusted to 0.5 g/l and 80 mg/l, respectively.     

MOSFET亚阈特性分析与低温按比例缩小理论的研究

器件尺寸按比例缩小是实现超大规模集成电路的有效途径，但寄生和二级效应却将器件限在一定的水平，本文在对比分析常温与低温下小尺寸器件效应的基础上，重点研究了ＭＯＳ器件亚阈特性对器件性能及按比例缩小的影响，并根据低温工作的特点，提出了ＭＯＳ器件一种低温按比例缩小规则，该原则对低温器的优化设计，从而更大程度在提高电路与系统性能具有重要的指导意义。