排序方式: 共有41条查询结果,搜索用时 218 毫秒
1.
����ľ���٪��ϵú��ģ��ʵ�顪�����ĵػ����������� 总被引:2,自引:0,他引:2
通过对塔里木盆地满加尔凹陷侏罗系演化程度较低 (Ro=0 .4% )的煤岩及煤岩中的显微组分镜质组进行了从 2 5 0~ 5 5 0℃的热模拟实验 ,发现无论是煤岩还是镜质组 ,热模拟气体组分中氮主要在低温阶生成 ;3 0 0℃时达到最大 ;反映了煤岩在未成熟阶段 ,相当于Ro<0 .6% ,大量蛋白质发生水解作用而产生氨基酸 ,氨基酸很不稳定 ,在黏土矿物的作用下生成NH3,而NH3被进一步氧化生成氮。镜质组在 45 0℃时仍有少量氮的生成 ,由于部分含氮化合物在热催化作用下降低了氨基断裂所需的活化能而生成NH3,NH3在黏土矿物的作用下生成氮。因此 ,在煤岩热演化过程中从未成熟到成熟都有氮的生成 ,特别是未成熟阶段 ,从而为油气的勘探与开发提供科学依据 相似文献
2.
电子束辐照下富氢镜质体生烃标志 总被引:1,自引:1,他引:0
IntroductionThetransfOrmatiOnfrOmorganicmaterialincoalseamtohydrocarbonmainlyoccursunderthethermaldegradationeffectoforganicmatters.TheabilityOfcoaltoformliquidhydrocarbonanditsconstitutionfeaturesiscloselyrelatedwiththecOntentofliptinite(includinghydrOge… 相似文献
3.
高阶煤层气井的平均单井产气量低已成为制约我国煤层气产业发展的主要瓶颈之一,直接导致了煤层气开发经济效益低。为此,基于不同煤储层的地质条件,选择适用于煤层气高效开发的工程技术是提高当前高阶煤层气开发效益的关键。在剖析影响高阶煤层气开发效果的地质因素的基础上,建立了高阶煤层气开发的地质模式,并针对不同的地质模式优选出了相应的开发工程技术。结果表明:(1)影响高阶煤层气开发效果的主要地质因素按其影响程度从小到大依次为:煤体结构、煤岩变质程度、地应力、临储比;(2)据此划分了直井压裂、裸眼多分支水平井、U型和顶板仿树形水平井、鱼骨状和单支型水平井等4种工程地质模式。结论认为:直井压裂和裸眼多分支水平井仅适用于煤体结构好、变质程度高的地区;而低成本、后期可维护、占地面积少的单支型水平井和鱼骨状水平井适用范围广,是适宜大力推广的井型。 相似文献
4.
镜质体反射率作为成熟度指标的探讨 总被引:3,自引:0,他引:3
本通过对源岩样品镜质体反射率的测定分析表明,未抽提源岩的R0值与已抽提源岩的R0值存在差异,并随成熟度增加这种差异逐渐增大;不同类型但经历了相同的演化程度之后的源岩R0值不同;相同样品不同气体反应压力下,其R0值不同。 相似文献
5.
利用镜质体反射率数据估算地层剥蚀厚度 总被引:47,自引:3,他引:44
认为依照Dow(1977 ) 提出的直接利用镜质体反射率数据估算不整合面地层抬升与剥蚀厚度的方法所获得的计算结果并非不整合面地层剥蚀厚度,其物理意义相当于正断层错动造成的地层缺失厚度。强调了古地热梯度随时间的变化及其在剥蚀厚度估算中的意义;阐明利用镜质体反射率数据计算古地热梯度、进而估算剥蚀厚度的方法;通过对Dow(1977) 的井下数据进行的再评估, 演示了此方法的实际操作过程;为使此方法简便易用,给出了用于镜质体反射率与最高古地温换算的RoTt 曲线图解。 相似文献
6.
Closed system gold-tube pyrolysis experiments were performed on a peat and two coals (TY: Ro = 0.51%; SX: Ro = 0.94%) at temperatures ranging from 337 to 600 °C and a pressure of 50 MPa with heating rates of 2 and/or 20 °C/h. Solid reaction residues were analyzed microscopically. Yields and chemical and isotopic compositions of the generated gases were also determined. All three samples had similar thermal evolution pathways. With increasing heating temperature, vitrinite reflectances (VRr) of the residues increased linearly from 0.72% to 4.50%. This increase was lesser for the sample with a higher hydrocarbon generation potential and at faster heating rates. Gas compositions are dominated by CO2 and CH4 throughout the experimental process. Total gas and CH4 yields gradually increase with pyrolysis temperature for all samples. The carbon isotopic compositions of CH4 generated from the peat are lighter than those from the coals. The δ13CCH4 values exhibit a generic evolution pattern which the initial CH4 is isotopically heavy, then becomes lighter at moderate temperatures, and finally becomes heavier again. Methane produced from the samples at low heating rate has higher transformation ratio than that at high heating rate under the same temperature, so tends to be isotopically heavy after pyrolysis temperature of more than 408 °C. 相似文献
7.
8.
9.
10.