Display illumination with modulated directional backlight

Illumination is essential for modern life as colorful world is perceived by human visionary system. Display technology has been developing rapidly in recent decades, and the basic principle is related to the way that the image is illuminated and light is emanated. Traditional illumination is provided by different types of light sources, and the display image is visible in large viewing space until the emanating light decays to zero. This work proposes and demonstrates a novel illumination scheme for a display in which the displaying images are visible only in specific spatial regions. The directional backlight ensures the image propagating to specific direction while imaging visibility can be controlled to terminate abruptly at certain distance from the display screen while exerting no influence to nearby regions. The working principle for such an illumination scheme is the use of the modulated coherent directional backlight through an axicon lens. It is shown that the illumination scheme can robustly deliver carried image information to the designated viewing region. This new illumination scheme has many advantages over conventional illumination, including its usage for personal display, very lower energy consumption, as well as minimizing light hazard pollution.     

一种宽带矢量调制器的设计及其应用

矢量调制器是一种可以同时控制微波信号幅度和相位的器件。本文介绍了一种基于新型微带定向耦合器的宽带矢量调制器。新的耦合器结构克服了传统微带耦合器耦合度低、方向性差的问题,也不需要Lange耦合器复杂的加工工艺,在平衡放大器、移相器和衰减器等场合具有广泛的应用。其次,研究了用串联电感对衰减器中PIN二极管的寄生参数进行补偿的一种简单方法,以改善衰减器衰减量变化时的相位性能。该方法原理简单,可在一定带宽内替代复杂的平衡结构,并给出相近的性能。最后给出了矢量调制器的测试结果和它在自适应天线阵等实际系统中的应用情况,并讨论了用于提高载波和边带抑制、满足高精度要求的校准方法。     

定向断裂爆破技术在特软岩层巷道中的应用

介绍了大雁矿区特软岩层巷道成型新技术,包括定向断裂爆破技术的机理、爆破参数,以及大雁矿区特软岩层条件下实施定向断裂爆破的技术关键和注意事项。应用该技术不仅提高了巷道成型质量、节约了材料,而且保护了围岩稳定,对软岩巷道维护有重要作用。     

井下乳化/水热催化裂解复合降黏开采稠油技术研究

实验考察了胜利孤东稠油井下催化水热裂解和乳化/催化水热裂解降黏效果。所用催化剂为水溶性铁镍钒体系,Fe3+∶Ni2+∶VO4+=5∶1∶1,100 g稠油与30 g 0.5%催化剂水溶液在240℃反应24小时。原始黏度(50℃)11.0和8.36 Pa.s的两种稠油裂解并静置除水后,黏度降低76.2%和75.6%,室温放置60天后降黏率下降小于3个百分点,气相色谱显示裂解后轻组分明显增加,红外光谱显示稠油组分发生脱羧反应且芳环数减少。讨论了稠油催化水热裂解反应机理。所用化学助剂JN-A在油水中均可溶,耐温达250℃,耐矿化度达50 g/L,其水溶液以30∶100的质量比与稠油混合时形成低黏度的O/W乳状液。当水相含1.0%JN-A和0.5%催化剂时,两种稠油水热裂解后的反应混合物为O/W乳状液,黏度仅为319和309 mPa.s,静置除水后的稠油降黏率增加到86.5%和87.3%,其中的轻组分含量进一步增加。该井下乳化/催化水热裂解复合降黏法成功地用于孤东两口蒸汽吞吐井,稠油井作业后初期采出的原油黏度由~9 Pa.s降低到1 Pa.s左右,随采油时间延长而逐渐升高,约50天后超过4Pa.s。图2表6参5。     

引入激光回馈的双光束干涉效应的研究

提出了一种引入He-Ne激光回馈的双光束干涉系统,并在理论和实验两方面进行了研究。实验中对系统中的干涉信号及激光器尾光功率变化同时进行探测。发现当干涉仪的主回馈镜移动时,激光器尾光信号是正弦形波形,而干涉仪输出的是以双峰为一个周期的信号,双峰中一峰总是高于另一峰,并且当主回馈镜移动方向改变时,同一周期中两峰出现的顺序也随之改变。对实验现象进行了理论分析,并模拟出干涉信号及激光自身功率的变化曲线。理论分析及模拟结果与实验结果完全吻合。讨论了利用发现的现象进行测量的可行性,所提出的测量方法易于实现。     

SiGe／Si多量子阱中垂直方向红外吸收及共振色散效应

用垂直入射的中红外光束调制非掺杂SiGe/Si量子阱中光致子带间吸收，氩离子激光器作为子带间跃迁的光泵浦源在阱中产生载流子，红外调制光谱用步进式傅立叶变换光谱仪记录，实验中观察到明显的层间干涉效应与子带间跃迁有关的色散效应，理论和实验分析认为样品折射率变化造成的位相调制可以补偿吸收所造成的幅度调制。     

定向棱镜腔平顶高斯激光束特性的研究

在XeCl准分子激光器中,采用定向棱镜作为端反射镜与平面输出镜构成激光器谐振腔,获得了近场能量分布均匀、远场能量分布高度集中的相干平顶高斯激光束输出,并具有腔镜高抗失调能力,改善了激光束质量。     

定向探测引信技术分析

从提高引信与战斗部配合效率出发 ,根据定向战斗部的战术技术性能 ,介绍了一种能够识别弹体周围 4个方向目标的定向探测引信 .分析了定向探测器的工作原理和目标方位识别的关键技术 ,并对探测天线的设计做了详细的分析和计算 .     

In-situ composite Cu-Cr contact cables with high strength and high conductivity

In order to develop a new type of contact cable with high strength and high electrical conductivity, Cu-Cr alloy series were selected as materials and Cu-Cr alloy castings were produced by means of directional solidification continuous casting (DSCC) process. The results show that the fibrillar strengthening phase, 13-Cr, orderly arranges among the copper matrix phase along the wire direction; and a microstructure of in-situ composite forms, which retains the basic property of good conductivity of the copper matrix and meanwhile obtains the strengthening effect of [3-Cr phase. The production technology as well as the mechanical property, electrical property, and synthetic property of the in-situ composite contact cables was discussed.