转炉炼钢静态模型的初步探讨

根据转炉炼钢的物理化学反应机理，从质量平衡和能量平衡的计算出发，通过小参数变动，导出了增量式静态模型中矿石方程和供氧方程的系数。所得结论与新日铁资料基本相符。同时，还进行了炉料和产物的计算，分析了改变废钢比对生产的影响。     

An attempt to compare the performance of bioscrubbers and biotrickling filters for degradation of ethyl acetate in gas streams

This study presents a comparison of the efficiency of a bioscrubber and a biotrickling filter (BTF) for the removal of ethyl acetate (EA) vapour from a waste gas stream, under the same operating conditions. The maximum EA elimination capacity achieved in the bioscrubber was 550 g m^?3 h^?1 with removal efficiency higher than 96%. For higher EA loadings the bioscrubber was oxygen limited, which caused incomplete EA biodegradation. When pure oxygen was fed to the bioscrubber at a rate of 0.02 L min^?1, the bioscrubber recovered and could treat higher EA loadings without any oxygen limitation. The BTF achieved EA elimination capacity of 600 g m^?3 h^?1 with removal efficiency higher than 97% and the dissolved oxygen concentration remained substantially higher than in the bioscrubber. However, severe channelling and blockage of the spray nozzle occurred due to the excessive biomass growth. Overall, the bioscrubber system was easier to operate and control than the BTF, while an enhancement of the oxygen mass transfer in the bioscrubber could potentially increase its performance by up to three times. Copyright © 2005 Society of Chemical Industry     

Comparison of mass transfer efficiency in horizontal rotating packed beds and rotating biological contactors

In this study, the mass transfer efficiencies of a novel horizontal rotating packed (h‐RPB) bed and the conventional disc‐type rotating biological contactor (RBC) were studied at four speeds and seven submergences. Pall rings of two different sizes (25, 38 mm), superintalox saddles and a wiremesh spiral bundle were used as packings in the h‐RPB. Volumetric gas–liquid mass transfer coefficients were determined by unsteady state absorption of atmospheric oxygen in de‐aerated water. Power consumption per unit liquid volume has been found for all geometries tested. The oxygen transfer efficiency values for the h‐RPB were found to be 2–5 kg kWh^?1 and for the disc RBC were found to be 1–2 kg kWh^?1. The performance of the h‐RPB was also compared with other gas–liquid contactors such as surface aerators. The study proves that the h‐RPB is a energy efficient alternative to conventional contactors. Copyright © 2005 Society of Chemical Industry     

Phosphorus Inputs to Lake Simcoe from 1990 to 2003: Declines in Tributary Loads and Observations on Lake Water Quality

Total phosphorus (TP) inputs to Lake Simcoe have led to hypolimnetic dissolved oxygen (DO) depletion and loss of cold water fish habitat. Since 1990, efforts have been made to reduce the total TP input to the lake below a defined target of 75 t/year, which was predicted to lead to reductions in spring TP concentration and improvements in end-of-summer hypolimnetic DO concentrations. The total TP load to the lake during the most recent period of record (1998/99-2003/04) ranged from 53 to 76 t/yr and averaged 67 t/yr, compared to an average of 114 t/yr estimated between 1990/91 and 1997/98 (range 85-157 t/yr). Reductions in TP loads from the catchment via tributary discharge (∼26 t) accounted for the majority of the decrease in total load between the two time periods. Total P concentrations decreased significantly in four out of six long-term monitored tributaries; however, concentrations in all six tributaries remain above the level recommended to avoid nuisance plant growth (30 μg/L). Although TP loads to the lake are currently below the target 75 t/yr, excessive growths of filamentous algae and macrophytes continue to be a problem in the nearshore zone. End-of-summer minimum hypolimnetic DO concentrations (average 4.3 mg/L, 1998/99-2003/04) remain substantially below the level (7 mg/L) that is considered protective of lake trout. Efforts to reduce TP loads to the lake therefore need to continue.     

Ischemia‐reperfusion injury. A phenomenon,that also occurs in the bone

Ischemia‐reperfusion injury of the bone occurs due to traumatic and non‐traumatic alterations affecting blood supply to the bone. It is likely to occur also upon insertion of an implant. Ischemia‐reperfusion injury of the bone has been studied by interruption of blood supply in situ, in limb replantation/transplantation models, in revascularized bone grafts and non‐vascularized bone fragments, as well as in isolated cultured cells. All cells of the bone are affected, including osteoblasts, osteocytes, osteoclasts, chondrocytes, and bone marrow cells. Critical ischemia times for induction of bone cell death, either in the ischemic period or following reperfusion, are in the range of 3 to 7 h. These critical ischemia times are significantly increased by decreasing the temperature from 37 °C to 0–4 °C. Anoxia is the most likely trigger of cell injury in the ischemic phase. In the reperfusion phase, reactive oxygen species are decisively involved in the injurious process. In general, however, the available information on the mechanism of ischemia‐reperfusion injury of the bone is relatively sparse. On the other hand, there are clear similarities to the mechanisms of ischemia‐reperfusion injury known from other organs, and there is a clear potential for protection against ischemia‐reperfusion injury of the bone.     

Evaluation of the reactivity of titanium with mould materials during casting

A methodology for evaluating the reactivity of titanium with mould materials during casting has been developed. Microhardness profiles and analysis of oxygen contamination have provided an index for evaluation of the reactivity of titanium. Microhardness profile delineates two distinct regions, one of which is characterised by a low value of hardness which is invariant with distance. The reaction products are uniformly distributed in the metal in this region. The second is characterised by a sharp decrease in microhardness with distance from the metal-mould interface. It represents a diffusion zone for solutes that dissolve into titanium from the mould. The qualitative profiles for contaminants determined by scanning electron probe microanalyser and secondary ion mass spectroscopy in the as-cast titanium were found to be similar to that of microhardness, implying that microhardness can be considered as an index of the contamination resulting from metal-mould reaction.     

氧浓度对近临界水中纤维素分解的影响

研究了不同初始氧浓度对纤维素在近临界水中分解的影响，实验结果表明，氧浓度显著地影响产物总碳收支平衡，液相不同组分的收率、气体的产量以及气相产物的组成，微量氧对产物总碳收支平衡影响不大，而对液相不同组分的收率有一定的影响。从实验结果可以看出，离子型反应机理在纤维素水解的第一步中起主导作用。而单糖的进一步分解是一个以自由基反应机理为主的过程。     

Extraction of penicillin G from simulated media by an emulsion liquid membrane process

The extraction of penicillin G from simulated media was performed by water/oil/water (w/o/w) emulsion liquid membranes (ELMs) and studied under various operational conditions in a batch system. The degree of extraction achieved was between 80% and 95% under specific conditions. A concentration of greater than nine times the initial concentration of penicillin G in the external phase was obtained in the internal phase. The pH of the internal aqueous solution, containing a basic salt, was theoretically calculated on the basis of the amount of penicillin G transported into the internal phase. The calculated results agreed with the experimental data well and were used to select a suitable type and concentration of a basic salt in the internal phase to give a pH within the range 5 to 8 where penicillin G was stable after the termination of extraction. The extraction of penicillin G was successfully performed by the ELM process with sodium carbonate in the internal phase.     

Oxygen Tracer Diffusion in Vitreous Silica

Oxygen diffusion in vitreous silica glass is studied using the gas exchange technique. The tracer concentration profiles are consistent with a model based on two mechanisms, one network and the other interstitial. These processes are coupled through limited network–interstitial exchange. Nuclear reaction analysis and secondary ion mass spectrometry techniques are performed and compared. These results are compared to experiments on transport in thin silica films grown on single-crystal silicon.     

用热分析法研究硝化棉的熔化过程

用ＭＤＳＣ，显微镜温台熔点测定仪和固体原位反应池／快速扫描傅立叶变换红外光谱联用装置考察了硝化棉的熔化过程。ＭＤＳＣ曲线表明吸热过程是可逆的，它系由ＮＣ和部分分解凝聚相产物的混合物的固液相变所引起。由ＮＣ的ＭＤＳＣ曲线得到的熔点，熔化含，熔化熵，分解含和分解反应热温熵分别为４７６．８４Ｋ，２０５．６Ｊ．ｇ＾－１，０．４３１２Ｊ．ｇ＾－１．Ｋ＾－１，－２４７５．０Ｊ．ｇ＾－１，－５．２４２Ｊ．ｇ＾－