Ca—Mg系复合凝聚剂富集分离造纸法烟草薄片废水处理及资源化研究

采用制备的Ca—Mg系复合凝聚剂,对造纸法烟草薄片废水进行高效固-液分离,以大大降低后续生化处理负荷。获得的污泥固体富含烟碱类物质而进一步提取,用于生物源杀虫剂的活性成份;提取后的污泥固体用作粉状杀虫剂的载附剂,完全达到资源化利用。采用该法单级分离COD去除率可达到70％-80％,具有一定实用价值。     

强化两相混合的超临界技术制备聚乳酸微粒

针对商品化聚乳酸微球粒径分布较宽难于适用气溶胶给药要求的不足,采用水力空化混合强化超临界流体辅助雾化技术(SAA-HCM)制备聚乳酸(PLA)超细微粒.该技术主要特点是通过在超临界流体和液相进料处引入水力空化混合器,强化两相间的混合.考察SAA-HCM过程混合器压力、温度、沉淀器温度、进料中CO2与液体溶液质量流量比和溶液质量浓度等操作参数对微粒形态和粒径分布的影响,成功制备出球形度较好,粒径分布较窄(1～3μm)的PLA微球.经X射线衍射(XRD)分析和差示扫描量热(DSC)分析显示,与原料PLA相比,微球晶型及热曲线变化不大,但结晶度下降.同时把操作参数与相行为进行关联,探讨了影响颗粒形貌的机理.对比超临界流体辅助雾化法(SAA)的实验结果表明:水力空化的引入能有效强化混合器内的两相传质,混合更好,能制备出适用于气溶胶给药要求的超细微粒.     

混凝法去除水中TiO2纳米颗粒

为了探讨混凝法去除水中纳米颗粒的可行性及最佳条件,研究了无机混凝剂（PAC、PFS、PAFC）和有机絮凝剂（CPAM、APAM、NPAM）对TiO₂纳米颗粒的去除效果,并考察了投加量、pH、沉淀时间、水力条件及有机无机复配对TiO₂纳米颗粒去除效率的影响。单独投加PAC、PFS和PAFC时,三者对应的最高去除率分别为92.51%、84.43%、95.66%。单独投加CPAM、APAM、NPAM时三者对应的去除率仅为61.72%、29.06%、55.37%。复配最佳混凝条件为：投加40 mg/LPAC和3 mg/LCPAM,pH值为9,G值143.5/s,沉淀时间15 min,此时,TiO₂纳米颗粒去除率为99.6%。     

Mechanism for clogging of microchannels by small particles with liquid cohesion

We numerically investigate the effect of liquid cohesion on the clogging of microchannels induced by small wet particles. The computer simulation is performed by the discrete element method (DEM) with cohesive contact models in presence of pendular liquid bridges, which is embedded into the computational fluid dynamics (CFD). We find that liquid cohesion significantly promotes particle deposition and agglomerate growth. A clogging phase diagram, in the form of Weber number and Stokes number, is constructed to quantify the clogging-nonclogging transition. The competition between particle–particle and particle–fluid interactions is quantitatively discussed in terms of particle velocity and slip velocity. Strong cohesion can address a greater slip velocity or drag between particles and fluid, which depresses the resuspension of deposited particles and results in clogging. Finally, we compare our results with clogging induced by van der Waals adhesion of small dry particles and find that the competence of liquid cohesion is more prominent.     

Processing and oxidation of co-deposited Ni-Al coatings

Electrodeposited Ni matrix/Al microparticles or nanoparticles dispersed composite coatings (termed as EMCCs or ENCCs) are developed from a Ni-based electrolyte bath. The Al microparticles are in a size range of 1 -5 μm and the Al nanoparticles in an average size of 75 nm. The Al content in coatings increases with increase in the particle content in the bath. Particle size effect on the degree of codeposition is not significant. However, codeposition of Al nanoparticles instead of microparticles promotes more homogenous growth of Ni deposits on {111}, {200} and {220} planes. The oxidation at 1 050 ℃ of the as-deposited composite coatings shows that at a comparable Al content, ENCC of Ni-Al exhibits a better oxidation resistance than EMCC of Ni-Al due to the fast formation of an alumina scale during the transient stage of oxidation.     

Nanoparticle‐embedded polymer‐dispersed liquid crystal for paper‐like displays

Abstract— A polymer‐dispersed liquid‐crystal (PDLC) matrix template embedded with nano/microparticles can be backfilled/infiltrated with a dye‐doped liquid crystal for a paper‐like reflective display. In this way, a desirable degree of diffusion can be realized to reduce the viewing‐angle dependency of a gain reflector and metallic glare without changing other electro‐optical properties.     

絮凝剂在大庆油田中的应用

综述了絮凝剂的种类、用途和作用原理，分析了国内外絮凝剂技术的现状及发展方向。并就絮凝剂在大庆油田中的应用现状做了描述，指出大庆油田的水质特性及对絮凝剂的要求，提出了今后的工作重点。     

石灰混凝法处理污水厂二级出水的实验研究

通过对石灰混凝法去除城市污水处理厂二级出水有机物最佳处理条件的研究,结果表明:采用干投石灰法比湿投石灰法对有机物的去除效果好;通过对比试验与正交试验,确定了最佳药剂组合为石灰、PFS、PDMDAAC、HPAM组合,其中复合絮凝剂中PFS的最佳投加量为15-25mg/L,PDMDAAC的最佳投加量为1.0-2.0mg/L,HPAM的最佳投加量为0.5-1.0mg/L,对有机物的去除率达50%以上,出水清澈透明,可回收利用。     

大浪淀水库水直接过滤处理工艺中絮凝剂的筛选

在利用直接过滤法处理大浪淀水库水应用研究的试验中，分别投加硫酸铝、聚合铝、聚合氯化铁、聚硅铝4种絮凝剂后，先根据进入床层前的水中颗粒的粒径分布情况进行了絮凝剂的筛选，同时以筛选的絮凝剂的处理效果作以比较，然后还对滤床各层截污分布情况进行了分析，最终确定了最适合的絮凝剂种类是聚合氯化铁。     

The Blocking of Integrin-Mediated Interactions with Maternal Endothelial Cells Reversed the Endothelial Cell Dysfunction Induced by EVs,Derived from Preeclamptic Placentae

Placental extracellular vesicles (EVs) have increasingly been recognized as a major mediator of feto-maternal communication. However, the cellular and molecular mechanisms of the uptake of placental EVs by recipient cells are still not well-understood. We previously reported that placental EVs target a limited number of organs in vivo. In the current study, we investigated the mechanisms underlying the uptake of placental EVs into target cells. Placental EVs were derived from explant cultures of normal or preeclamptic placentae. The mechanisms underlying the uptake of placental EVs were elucidated, using the phagocytosis or endocytosis inhibitor, trypsin-treatment or integrin-blocking peptides. The endothelial cell activation was studied using the monocyte adhesion assay after the preeclamptic EVs exposure, with and/or without treatment with the integrin blocking peptide, YIGSR. The cellular mechanism of the uptake of the placental EVs was time, concentration and energy-dependent and both the phagocytosis and endocytosis were involved in this process. Additionally, proteins on the surface of the placental EVs, including integrins, were involved in the EV uptake process. Furthermore, inhibiting the uptake of preeclamptic EVs with YIGSR, reduced the endothelial cell activation. The interaction between the placental EVs and the recipient cells is mediated by integrins, and the cellular uptake is mediated by a combination of both phagocytosis and endocytosis.