基于多相滤波器的信道化接收机及其应用研究

本文主要研究了应用多相滤波技术的信道化接收机建模问题。在给定信道频谱划分方案下,推导了基于多相 滤波器的信道化接收机数学模型。并由此模型设计了一个四信道模拟系统。最后用仿真实验结果验证了模型的正确性。     

Analysis and Optimization of Noise in Bipolar RF Harmonic Mixers

A noise analysis of bipolar harmonic mixers (BHM) used for direct-conversion receivers is presented in this paper. Analytical and simulated results for the transfer function of the mixer are presented. Simple analytical expressions describing noise contribution from all sources are derived. Estimation of flicker noise quite agrees with harmonic-balance simulation results. Based on the derived expressions, total time average noise power spectral density (PSD) at the output is compared with simulation results. For the recommended regions of operation, error is less than 20%. The overall BHM noise figure (NF) is calculated and optimized based on a simple extracted formula. Errors introduced by analysis remain within a 1.5-dB margin with respect to simulation results. The validity of analysis for high frequencies is justified. The effect of flicker noise coefficient on the overall mixer NF is compared for different available processes.     

Multistatic passive radar imaging algorithm for the gapped aperture

Due to usually a small number of narrowband external illuminators and their uneven distribution, a single external illuminator and several receivers are used to synthetize aperture equivalently. The form of the target echo of the multistatic passive radar system is analyzed, and then the relationship of Fourier transform pair between target scattering function and the echo received by radar is deduced. Based on the prior knowledge of sparse distribution of the target, the algorithm of Compressed Sensing is used to recover the scattering coefficient of targets. Finally, the positions of receivers have been optimized by minimizing the correlation of the dictionary matrix based on minimizing the correlation coefficient of the dictionary matrix by the algorithm of Simulated Annealing (SA). Simulations show that the performance of the recovery of the image is improved significantly after optimizing.     

广域电磁接收机中ARM系统的应用

在多通道广域电磁接收机中,高性能嵌入式系统的应用,将有利于提高其智能化控制水平,更好地满足勘探中在功耗、信号处理能力和实时响应能力等方面的要求。本文在分析嵌入式系统及微处理器的基础上,选取了美国德州仪器公司生产的嵌入式ARM Cortex－A8微处理器AM3517作为硬件核心,阐述了AM3517处理器的基本工作原理和ARM嵌入式系统硬件平台的设计方法,结合广域电磁法的应用需求,设计了基于AM3517的核心主控电路。应用Cadence专业电子设计软件,详细解析了硬件平台设计过程,所设计平台配置了存储系统及外围硬件等模块,完成了核心系统的硬件电路原理图和PCB板设计。同时基于硬件平台,完成了Linux软件系统的移植以及主要模块的调试,经测试表明该ARM系统应用在广域电磁接收机中以实现主控功能是可行的。     

RUSSIAN AND SOVIET CRYPTOLOGY III – SOVIET COMINT AND THE CIVIL WAR, 1918–1921

The importance of radio communications, both in controlling military forces and for purposes of intelligence collection, was recognized from the beginning by the new Soviet leaders in Russia. By January 1919, a radio intelligence service had been established in the Red Army, although shortages of equipment and comint personnel limited its operations during the civil war. Both sides in the civil war suffered from poor communications security.     

一种易工程实现的数字接收系统定时同步算法

为解决数字接收系统的定时同步问题,提出了一种易于FPGA实现的数字接收系统定时同步算法。该算法通过计算时域基带过采样信号的瞬时功率,可以快速确定瞬时功率最大值所对应的样点,该样点即为最佳采样点。最后,以QPSK信号为例,在FPGA平台上对算法进行了实现,实现结果证明了该算法的有效性。该算法直接在时域进行,具有速度快、易于FPGA实现等优点,亦可用于对其他数字信号进行定时同步。     

Study on multiple receiver systems in non-line-of-sight ultraviolet communication systems

In this article, multiple receiver effects in a non-line-of-sight （NLOS） ultraviolet （UV） communication system is studied. The idea of using multiple receivers for diversity reception is known as a practical, effective and widely applied technique in wireless communications. The current approach is to use multiple antennas at the receiver in order to improve the quality of the received signal. A method of modeling and simulation is proposed to depict the principle and feasibility of the multiple receiver adopted in UV communication. The study provides an insight to the channel characteristics and achievable capabilities of ultraviolet communication systems with multiple receivers. It provides guidelines for practical system design with discussions on trade off between the receiver gain and the additional cost.     

一种用于900MHz射频识别(RFID)读写器芯片的1.8VCMOS直接变频接收机

设计了针对解决900MHz RFID读写器收发机芯片中本地载波干扰问题而优化的直接变频接收机,并在0.18μm 1P6M混合信号CMOS工艺上实现验证.设计中使用了一种串联反馈结构的基带放大器以达到同时实现无源混频器输出缓冲,直流消除以及信号放大的功能.实际测量显示,该接收机的输入1dB压缩点为-4dBm,当中频信号解调信噪比要求为10dB时,可达到的灵敏度为-70dBm.该接收机与整个收发机集成在同一块芯片中,使用1.8V电源电压,工作时静态电流为90mA.     

A New Class of Efficient Block-Iterative Interference Cancellation Techniques for Digital Communication Receivers

A new and efficient class of nonlinear receivers is introduced for digital communication systems. These iterated-decision receivers use optimized multipass algorithms to successively cancel interference from a block of received data and generate symbol decisions whose reliability increases monotonically with each iteration. Two variants of such receivers are discussed: the iterated-decision equalizer and the iterated-decision multiuser detector. Iterated-decision equalizers, designed to equalize intersymbol interference (ISI) channels, asymptotically achieve the performance of maximum-likelihood sequence detection (MLSD), but only have a computational complexity on the order of a linear equalizer (LE). Even more importantly, unlike the decision-feedback equalizer (DFE), iterated-decision equalizers can be readily used in conjunction with error-control coding. Similarly, iterated-decision multiuser detectors, designed to cancel multiple-access interference (MAI) in typical wireless environments, approach the performance of the optimum multiuser detector in uncoded systems with a computational complexity comparable to a decorrelating detector or a linear minimum mean-square error (MMSE) multiuser detector.     

Analysis and design of a fully integrated CMOS low‐noise amplifier for concurrent dual‐band receivers

This article thoroughly analyzes a concurrent dual‐band low‐noise amplifier (LNA) and carefully examines the effects of both active and passive elements on the performance of the dual‐band LNA. As an example of the analysis, a fully integrated dual‐band LNA is designed in a standard 0.18‐μm 6M1P CMOS technology from the system viewpoint for the first time to provide a higher gain at the high band in order to compensate the high‐band signal's extra loss over the air transmission. The LNA drains 6.21 mA of current from a 1.5‐V supply voltage and achieves voltage gains of 14 and 22 dB, input S₁₁ of 15 and 18 dB, and noise figures of 2.45 and 2.51 dB at 2.4 and 5.2 GHz, respectively. © 2006 Wiley Periodicals, Inc. Int J RF and Microwave CAE, 2006.