镨掺杂分布对1.3μm光纤放大器特性影响

对掺氟化镨玻璃光纤放大器的小信号增益，用广义的高斯近似公式可获得精确的分析表达。文中研究了限制光纤芯层中央部分的镨掺杂对光纤放大器特性的影响，结果发现限制镨掺杂分布能改进光纤放大器的工作效率，且截止波长比芯层全部均匀掺镨的光纤更长。     

Pressureless low temperature sintering of nanocrystalline zirconia ceramics via dry powder processing

Pressureless sintering approaches provide a simple avenue to manufacture dense ceramic parts with minimal processing equipment, but current pressureless sintering techniques have yet to demonstrate capabilities of producing dense ceramics while maintaining sub-50 nm grain sizes. Nanocrystalline yttria stablized zirconia ceramics were process from 4 mol% yttria stablized zirconia (4YSZ) nanopowders with a crystallite size of 7.5 nm using dry cold isostatic pressing (CIP) where powders are dried immediately prior to green compact formation and CIP vacuum bagging. It is shown that CIP pressures >75 000 psi (517 MPa) effectively remove pores larger than 100 nm and that pressureless sintering occurs at reduced temperatures for green densities ≥50%. Though the sintering kinetics are shown to be similar to other zirconia nanopowder sintering studies, the small initial crystallize size and reduced sintering temperature allowed densities as high as 97.2%, while retaining a ceramic grain size at or below 40 nm. Produced nanocrystalline 4YSZ ceramics with a grain size of 30.3 nm and a density of 96.3% had Vicker's hardnesses as high as 14.2 GPa and Vicker's indentation fracture resistance of 3.43 MPa·, demonstrating that simple processing approaches can be refined to fabricate nanocrystalline ceramics while maintaining high hardness and indentation fracture resistance.     

奥氏体化温度及冷却方式对20Mn2SiVB钢组织及性能的影响

通过各种试验手段,研究了20Mn2SiVB钢不同奥氏体化温度及不同冷却方式处理后其显微组织及其强度和塑性的变化,确定了最佳的热处理工艺。结果表明:900℃奥氏体化后风冷时钢的强塑性最好;在强塑性最佳时的微观组织是铁素体+粒状贝氏体。     

大剂量Si-Mn复合孕育剂在铸铁中的应用

从例证和机理两方面来说明通过大剂量Si Mn复合孕育在铸铁中的应用 ,使Mn的作用得到充分发挥 ;Mn13是提高铸铁组织中珠光体量和性能的理想元素 ;通过调节大剂量Si Mn复合孕育剂中Mn的比例来稳定和提高基体组织中的珠光体量 ,达到稳定和提高铸铁性能的目的 ,它的可操作性比通过控制化学成分来稳定和提高铸铁的性能更好更容易 ,冲天炉熔炼效果更明显。     

Quantum hydrodynamic simulation of discrete-dopant fluctuated physical quantities in nanoscale FinFET

Impact of the discrete dopants on device performance is crucial in determining the behavior of nanoscale semiconductor devices. Atomistic quantum mechanical device simulation for studying the effect of discrete dopants on device's physical quantities is urgent. This work explores the physics of discrete-dopant-induced characteristic fluctuations in 16-nm fin-typed field effect transistor (FinFET) devices. Discrete dopants are statistically positioned in the three-dimensional channel region to examine associated carrier's characteristic, concurrently capturing “dopant concentration variation” and “dopant position fluctuation”. An experimentally validated quantum hydrodynamic device simulation was conducted to investigate the potential profile and threshold voltage fluctuations of the 16-nm FinFET. Results of this study provide further insight into the problem of fluctuation and the mechanism of immunity against fluctuation in 16-nm devices.     

34Mn6大断面圆管坯表面渣沟缺陷分析

本文结合理论并通过试验对比分析说明了 34Mn6大断面铸坯表面渣沟缺陷的成因 ,并制定了改善措施 ,为以后改进表面质量提供依据     

火灾条件下16Mn钢的力学性能试验研究

对建筑工程常用的16Mn钢在火灾条件下的力学性能进行了测试,获得了16Mn钢的屈服强度、极限强度、弹性模量和伸长率等力学性能随火灾温度变化的规律,并对影响16Mn钢力学性能的因素进行了分析。     

纳米磁性Mn3O4粉末的溶剂热法合成及表征

以MnO2为主要原料,应用溶剂热法合成了纳米磁性Mn3O4粉体.研究和讨论了反应温度、填充度、溶剂种类、降温速率对产物性能的影响,得到溶剂热法制备纳米磁性Mn3O4的最佳条件.产物经XRD表征为单一相Mn3O4,经粒度分析仪及透射电镜(TEM)检测,为四方晶型,平均粒径为55nm.     

超声共沉淀法合成锂离子电池正极材料

采用超声共沉淀法,合成尖晶石型掺杂锰酸锂Li1.05Co0.10Ni0.10Mn1.80O4前驱体,并使用三段热处理方式,制备出尖晶石产物。用粒度分布、XRD、SEM、EDS及电化学性能测试等对其进行表征。结果表明:与未处理试样相比,超声共沉淀法制备的产物的粒度分布变窄,体积比表面积由7.0116m2/cm3缩小至6.9789m2/cm3,晶格常数从0.822nm缩小至0.821nm,晶粒尺寸从67.41nm减小至57.78nm,晶形更加完整,颗粒均匀性更好。经装配成电池测定电化学性能,其充放电平台增长,比容量加大,循环性能更优越。