An iterative method for suboptimal control of linear time-delayed systems

This article presents a new approach for solving the Optimal Control Problem (OCP) of linear time-delay systems with a quadratic cost functional. The proposed method can also be used for designing optimal control time-delay systems with disturbance. In this study, the Variational Iteration Method (VIM) is employed to convert the original Time-Delay Optimal Control Problem (TDOCP) into a sequence of nonhomogeneous linear two-point boundary value problems (TPBVPs). The optimal control law obtained consists of an accurate linear feedback term and a nonlinear compensation term which is the limit of an adjoint vector sequence. The feedback term is determined by solving Riccati matrix differential equation. By using the finite-step iteration of a nonlinear compensation sequence, we can obtain a suboptimal control law. Finally, Illustrative examples are included to demonstrate the validity and applicability of the technique.     

嵌入式RISC核MPEG2/AC3解码器

介绍了在一个嵌入RISC核的AC3／MPEG2音／视频解码器中，通过增加特殊指令及其相应的硬件逻辑，对AC3的音频解码进行了一定的改进，不仅达到了AC3解码的实时性要求，而且降低了对存储器的要求。     

Sequential Decoding of Convolutional Codes for Rayleigh Fading Channels

The performance of sequential decoding of long constraint length convolutional codes is evaluated for Rayleigh fading channels. Sequential decoding is not practical below a certain theoretical signal-to-noise ratio, and these theoretical limits are calculated for a number of modulation methods and code rates. As an example, with BPSK modulation, soft decisions and code rate 1/2, the theoretical signal-to-noise ratio per information bit is 5.7 dB. Above this limit the bit error rate can be made arbitrarily small by increasing the constraint length at no significant complexity cost. Furthermore, it is shown that with carefully chosen quantization steps, 8 level uniform quantization gives a negligible loss also for sequential decoding on a Rayleigh fading channel. Simulation results using 8 level quantization correspond well with the theoretical performance bounds. Also, the performance on a correlated channel with finite interleaving has been obtained. With an interleaver depth of 50×50 and a normalized doppler frequency equal to 0.01 we are only 0.5 dB away from the performance with perfect interleaving. Finally, bit error rate results show this scheme to compete well with Turbo codes.     

应用金属迭片挠性联轴器改造D1000-32型风机

使用液力偶合器因故障频繁，对高炉稳产、高产造成严重威胁，而且维修费用较高，对偶合器改造后，应用金属迭片挠性联轴器其故障率、维修费用都很低。     

MC-CDMA系统迭代检测中的一种信道估计算法

在DS—CDMA系统中，联合译码的迭代多用户检测是克服多址干扰增加系统容量的有效方法。本文将多用户检测和译码相结合的迭代检测技术应用于MC—CDMA系统，其中，多用户检测器由串行干扰消除和其后的MMSE滤波器组成。文中提出一种时域信道估计作为迭代初始值的频域信道估计算法，比单纯的频域信道估计方法节约导频符号数量，并且由于信道估计性能的改善，加快了迭代检测的收敛速度。     

一种改善Turbo乘积编码OFDM系统性能的新方法

本文提出一种利用对译码器软信息限幅来改善多径衰落信道中Turbo乘积编码OFDM(TPC-OFDM)系统性能的新方法。通过对不同多径衰落信道中QPSK映射和16QAM映射的TPC-OFDM系统性能的数值仿真，结果表明在10^-5误比特率下，这种新方法比传统的迭代译码大约有6～10dB的改进，对严重多径环境下TPC-OFDM系统的错误平底也有明显的改进。     

求非线性方程近似解的逐次迭代法

本文提出了求解非线性问题的一种新方法——逐次迭代法，本方法先是给出一个初始近似解，然后将这个近似解进行校正迭代，使之接近于真实解，把一个非线性问题转化为一个线性问题来解决。     

A feasibility study of a direct-mapping parallel processing method to solve linear equations in load-flow calculation

With the growing size and complexity of power systems, system analysis—such as transients calculation—takes much time. Hence, fast calculation methods are required. Although parallel processing is a hopeful method, there have been difficulties in the parallel solution of linear equations which appear in power-flow calculations by the Newton-Raphson method. This paper aims at the fast calculation of the power-flow problem by means of parallel processing. In order to improve the suitability to the parallel solution of the differential equation in transients calculation, we assume the use of a direct-mapping parallel processing machine to map directly the network of a power system onto a network of processors. Under this assumption, we propose a new parallel-processing-oriented method in which the linear equation is solved by linear iterations between nodes with Aitken acceleration. We simulate the method on three model power systems and compare this Parallel Iterative Method (PIN) with a Parallel Direct Method (PDM) which uses the banded matrix according to the number of operations required. As a result, we can expect that PIM may solve linear equations faster than PDM with m processors, although the PIM might be inferior to the PDM with m × m processors, where m denotes the half-band width of the banded matrix.     

一种全局优化的多面体凸分解匹配方法

提出了一种全局优化的多面体匹配方法，该方法对物体的拓扑关系和结构关系进行多级匹配,利用全局优化的松驰迭代方法减少匹配误差，并由匹配的一致性准则进行匹配结果的检测，根据物体的内在特征来进行匹配，从而解决非同构物体的匹配.可广泛应用于物体识别、三维物体重建、医学图象处理等领域，实验证明此方法质量好、自动化程度高，是一种有效的全局优化结构匹配方法．     

集团变分法(CVM)及其在合金相图计算中的应用

介绍了集团变分法的集团概率变量、配置熵等统计分析的理论基础及Helmholtz自由能的描述模型.提出了巨势及相对化学势的几何分析理论.讨论了应用集团变分法和巨势分析理论进行相平衡计算的过程,并分析了同结构平衡相图计算的若干实例.