Influence of Se and Te substitutions at Tl-site of Tl(Ba,Sr)CaCu2O7 superconductor on the AC susceptibility and electrical properties

The Sr and Ba bearing Tl-1212 phase, Tl(Ba,Sr)CaCu₂O₇ is an interesting superconductor. The Sr only bearing TlSr₂CaCu₂O₇ is not easily prepared in the superconducting form. The Ba only bearing TlBa₂CaCu₂O₇ on the other hand does not show improvement in the transition temperature with elemental substitution. In this work the influence of multivalent Se (non-metal) and Te (metalloid) substitutions at the Tl-site of Tl_1-xM_x(Ba,Sr)CaCu₂O₇ (M = Se or Te) superconductors for x = 0–0.6 was studied. The samples were prepared via the conventional solid-state reaction method. XRD patterns showed a single Tl-1212 phase for x = 0 and 0.1 Se substituted samples. The critical current density at the peak temperature, T_p of the imaginary (χ”) part of the AC susceptibility (χ = χ’ +χ”), J_c-inter(T_p) for all samples was between 15 and 21 A cm⁻². The highest superconducting transition temperature was shown by the x = 0.3 Se-substituted sample (T_c-onset = 104 K, T_c-zero = 89 K, T_cχ’ = 104 K and T_p = 80 K). Te suppressed the superconductivity of Tl-1212 phase. The order of highest transition temperatures are as follows: Tl_1-xTe_x(Ba,Sr)CaCu₂O₇<Tl(Ba,Sr)CaCu₂O₇<Tl_1-xSe_x(Ba,Sr)CaCu₂O₇. This work showed that Se was better than Te in improving the transition temperature and flux pinning of the Tl-1212 phase. The roles of ionic radius of Se and Te on the superconductivity of Tl(Ba,Sr)CaCu₂O₇ are discussed in this paper.     

Fundamental Evaluation of Power Supply and Rectifiers for Wireless Power Transfer Using Magnetic Resonant Coupling

This paper provides a fundamental analysis of a power supply and rectifiers for wireless power transfer using magnetic resonant coupling (MRC). MRC enables efficient wireless power transfer over middle‐range transfer distances. MRC for wireless power transfer should operate at a high frequency in the industry science medical band, such as 13.56 MHz, because the size of the transfer device decreases at higher transfer frequencies. Therefore, the output frequency of the power supply on the transmitting side should be 13.56 MHz. In addition, the rectifier on the receiving side is operated at a high frequency. This paper focuses on the reflected power in the power supply and rectifiers. Thus, the parametric design method is clarified for the power supply, including a low‐pass filter to match the output, the impedance of the power supply with the characteristic impedance of the transmission line. In addition, the effects on the rectifiers of silicon carbide and gallium nitride diodes are confirmed by performing an experiment and a loss analysis.     

A new design strategy for DC/DC LLC resonant converter: Concept,modeling, and fabrication

In this paper, a new design procedure for LLC converter has been introduced. In fact, this method is a computer-based design algorithm based on a numerical technique. In the process of designing, the value of the resonant element is obtained by solving the LLC converter fundamental equation. This converter will be controlled by using state feedback, such as output voltage variable. As a matter of fact, in a control system, the change of output voltage (because of load variation) will affect the switching frequency, so the output voltage will be tuned. In the designing process, the fundamental equations of LLC converter are obtained, and the value of the resonant elements is calculated. Also, a comparison analysis is carried out between the proposed and typical methods. The simulation is done to investigate the validity of the proposed method. Moreover, a prototype is manufactured, and the experimental test is done to evaluate its applicability.     

基于谐振原理的硅微机械加速度计

基于力学振动原理 ,导出敏感梁类谐振振动的微分方程 ,给出了振梁型加速度计的设计原理。指出了加速度计谐振梁频率的相对变化量与梁的厚度无关 ;为避免输出非线性频率信号 ,频率的相对变化率和激励振动的振幅都不宜太大     

南京老虎山黄土-古土壤剖面不同粒级组分的磁化率及其古气候意义

利用沉降离心法将老虎山黄土-古土壤的酸不溶相分离成<2μm、2～45μm和>45μm三个粒级组分,并分别测定了这些组分和全岩的磁化率。结果表明,无论是全岩,还是三个不同粒级组分,它们的磁化率都可以单独作为长江中下游地区古气候演变的参考指标。其中,<2μm粒级的质量磁化率明显大于全岩和2～45μm、>45μm两粒级,而且其分辨率也明显高于2～45μm和>45μm这两个粒级组分。本实验结果还显示,虽然<2μum的质量磁化率最大,但对全岩质量磁化率的贡献率与2～45μm粒级相当,>45μm粒级的贡献率较低。     

关于沥青针入度指数

介绍了沥青针入度指数(PI)的由来和计算、使用意义、局限性和分析。     

纳米加工和纳米电子器件

介绍了电子束曝光技术、EUV光刻技术和X射线光刻技术的进展;对各种纳米电子器件如单电子器件、共振隧穿器件和分子电子器件的研究现状及面临的主要挑战进行了讨论。     

Superconductivity and magnetism in niobium doped YBa2Cu3O7 Related high Tc ceramics

Magnetic characterization has been performed on the members of the cuprateniobate RBa₂Cu₂NbO₈ (R = Pr, Nd, and La) series and R_1.5Ce_0.5Sr₂Cu₂NbO₁₀ (R = Pr, Eu, Nd, and Sm) series. The PrBCNO samples show a signature in the magnetization of a magnetic ordering at 12K. The PrCSCNO sample is nonsuperconducting and shows two distinct orderings at 17K and 53K. No such magnetic phase transition is observed down to 2K in the Nd and La based RBCNO materials or the Nd, Sm, and Eu based RCSCNO materials. Measurements of the lower critical field curve, dc irreversibility line, and critical curent densities are reported for each of the superconducting NdCSCNO, SmCSCNO, and EuCSCNO compounds.     

可见光共振腔发光二极管的研究进展

共振腔发光二极管是一种具有优良发光性能的光电器件。概述了对可见光共振腔发光二极管的共振腔结构、反射镜材料体系、基本工作机理和发光特性，并展望了这种器件的发展前景。     

碲酸盐系统玻璃组成和结构对非线性光学性能的影响

碲酸盐系统重金属氧化物玻璃是一种优秀的非线性光学玻璃材料，具有较大的三阶非线性光学效应、超快光学响应、较宽红外透过范围、较好稳定性以及广泛应用前景。碲酸盐系统玻璃中的中间离子和网络外离子的加入会改变组成网络的配位多面体组成、键性和能带结构，进而影响玻璃的非线性光学性能。探讨了碲酸盐系统玻璃的网络结构，阐述了玻璃组成、结构以及纳米簇和非线性光学性能之间的相互关系。