Annular‐ring slot antenna designs with circular polarization radiation

The design of a microstrip‐fed annular‐ring slot antenna (ARSA) with circular polarization (CP) radiation is initially studied. To obtain CP radiation with broad 3‐dB axial ratio (AR) bandwidth that can cover the WiMAX 2.3 GHz (2305–2320 MHz, 2345–2360 MHz) and WLAN 2.4 GHz (2400–2480 MHz) bands, a novel technique of extending an inverted L‐shaped slot from the bottom section of the annular‐ring is proposed. To suppress the harmonic modes induced by the CP ARSA, the technique of integrating a defected ground structure into the annular‐ring slot is further introduced. From the measured results, 10‐dB impedance bandwidth and 3‐dB AR bandwidth of 44.86 and 9.68% were achieved by the proposed harmonic suppressed CP ARSA. Furthermore, average gain and radiation efficiency of ～4.7 dBic and 71%, respectively, were also exhibited across the bands of interest. © 2014 Wiley Periodicals, Inc. Int J RF and Microwave CAE 25:337–345, 2015.     

简体接管边缘应力区局部减薄处应力特征

参考《压力容器定期检验规则》第40条,采用有限元方法计算了筒体接管边缘应力区局部减薄处的应力分布,得到了局部减薄处凹坑的尺寸与位置对应力的影响趋势,讨论了应力集中系数随尺寸变化的规律,为筒体接管边缘应力区局部减薄处的强度评定提供了一定的计算依据。     

基于VXI总线的超宽带线性调频信号源的设计

主要介绍了VXI总线C尺寸超宽带线性调频信号源的设计方法，重点描述了利用现场可编程逻辑器件FPAG和DSP设计VXI总线接口电路，以及数字波形存储直读技术在线性调频信号源中的应用。     

中低速率语音波形编码

提出了一种波形编码的新方法，阐述了其编码原理。该编码算法简单，恢复的语音质量较好。由于利用了矢量量化技术，所以该编码速率较低。     

螺旋槽管强化传热原理及在石化装置上的应用前景

详细介绍了螺旋槽管换热器的强化传热原理 ,阐明了在无相变和有相变两种工况下 ,螺旋槽管换热器的强化作用 ,并介绍了螺旋槽管换热器的设计计算方法。说明了在石油化工装置上应用的必要性     

小型中间下料预焙电解槽技术条件摆布的思考

对小型中间下料预焙电解槽技术条件摆布的原则和具体数据进行了探讨，提出了尽可能利用从大型预焙槽上得出的先进经验，并消化吸收，掌握好各种条件的平衡，以取得好经济技术指标的观点。     

Effect of strain waveform on creep-fatigue life for Sn–8Zn–3Bi solder

This paper describes the creep‐fatigue life of Sn–8Zn–3Bi under push–pull loading. Creep‐fatigue tests were carried out using Sn–8Zn–3Bi specimens in fast–fast, fast–slow, slow–fast, slow–slow and hold–time strain waveforms. Creep‐fatigue lives in the slow–slow and hold‐time waveforms showed a small reduction from the fast–fast lives but those in the slow–fast and fast–slow waveforms showed a significant reduction from the fast–fast lives. Conventional creep‐fatigue life prediction methods were applied to the experimental data and the applicability of the methods was discussed. Creep‐fatigue characteristics of Sn–8Zn–3Bi were compared with those of Sn–3.5Ag and Sn–37Pb.     

发射机脉冲调制器的探讨

针对雷达发射机调试实践中存在的调制器脉冲波形问题，对磁控管发射机常采用的刚性调制器脉冲波形影响雷达性能及发射机可靠性的情况进行了分析与探讨，并结合实际，提出了调制器脉冲波形的改善途径及解决办法。     

TBM地区低孔渗高产气储层预测

 本文从TBM地区目的层的地质和地球物理特征分析出发，以三维地震资料为基础，综合利用人工和神经网络波形分类等定性储层预测方法和利用反演及敏感地震属性分析，对TBM地区低孔渗砂岩分布区开展了砂体展布特征分析和天然气高产区预测研究。根据研究结果部署了10口钻井，已完钻的4口井中有3口获得高产气流（其中DK27井日产天然气36.8×10⁴m³）。值得指出的是，目前所用的预测方法还不能预测厚度小于6m的单砂层或砂层组构成的储层。     

斜槽电机铁心叠压胎的设计

文章介绍了一种电机铁心为斜槽的叠压胎,重点分析了叠压胎定位 斜键的设计及其公差计算。