Phosphorylated chitosan/poly(vinyl alcohol) based proton exchange membranes modified with propylammonium nitrate ionic liquid and silica filler for fuel cell applications

In our previous work, phosphorylated chitosan was modified through polymer blending with poly(vinyl alcohol) (PVA) polymer to produce N-methylene phosphonic chitosan/poly(vinyl alcohol) (NMPC/PVA) composite membranes. The aim of this work is to further investigate the effects of a propylammonium nitrate (PAN) ionic liquid and/or silicon dioxide (SiO₂) filler on the morphology and physical properties of NMPC/PVA composite membranes. The temperature-dependent ionic conductivity of the composite membranes with various ionic liquid and filler compositions was studied by varying the loading of PAN ionic liquid and SiO₂-PAN filler in the range of 5–20 wt%. As the loading of PAN ionic liquid increased in the NMPC/PVA membrane matrix, the ionic conductivity value also increased with the highest value of 0.53 × 10^?3 S cm^?1 at 25 °C and increased to 1.54 × 10^?3 S cm^?1 at 100 °C with 20 wt% PAN. The NMPC/PVA-PAN (20 wt%) composite membrane also exhibited the highest water uptake and ion exchange capacity, with values of 60.5% and 0.60 mequiv g^?1, respectively. In addition, in the single-cell performance test, the NMPC/PVA-PAN (20 wt%) composite membrane displayed a maximum power density, which was increased by approximately 14% compared to the NMPC/PVA composite membrane with 5 wt% SiO₂-PAN. This work demonstrated that modified NMPC/PVA composite membranes with ionic liquid PAN and/or SiO₂ filler showed enhanced performance compared with unmodified NMPC/PVA composite membranes for proton exchange membrane fuel cells.     

盐卤除硝工艺的研究

介绍了一种采用氨碱蒸馏废液兑卤水进行除硝的新工艺 ,通过中试确定了该工艺的主要技术参数 ,为工程设计提供了条件。     

Biodegradation of monoaromatic hydrocarbons in aquifer columns amended with hydrogen peroxide and nitrate

The ability of indigenous microorganisms to degrade benzene, toluene, ethylbenzene and xylenes (BTEX) in laboratory scale flow-through aquifer columns was tested separately with hydrogen peroxide (110 mg/l) and nitrate (330 mg/l as NO₃⁻) amendments to air-saturated influent nutrient solution. The continuous removal of individual components from all columns relative to the sterile controls provided evidence for biodegradation. In the presence of hydrogen peroxide, the indigeneous microorganisms degraded benzene and toluene (> 95%), meta- plus para-xylene (80%) and ortho-xylene (70%). Nitrate addition resulted in 90% removal of toluene and 25% removal of ortho-xylene. However, benzene, ethylbenzene, meta- and para-xylene concentrations were not significantly reduced after 42 days of operation. Following this experiment, low dissolved oxygen (< 1 mg/l) conditions were initiated with the nitrate-amended column influent in order to mimic contaminated groundwater conditions distal from a nutrient injection well. Toluene continued to be effectively degraded (> 90%), and more than 25% of the benzene, 40% of the ethylbenzene, 50% of the meta- plus para-xylenes and 60% of the ortho-xylene were removed after several months of operation.     

离心萃取装置中硝酸羟胺还原反萃钚的研究

用十六级分离式混合—离心澄清萃取装置,在20-24℃,30-34℃,45-50℃等不同温度下进行了3B槽硝酸羟胺还原反萃钚的实验。结果表明,钚的收率均可达99.9%以上。在20-24℃时,有机相出口级附近几级的钚浓度较高,实验条件一旦波动,有可能造成钚的流失,且钚在萃取设备中有明显的积累。温度升高,14级反萃(停留时间约18min)时,钚的收率基本得到保证。     

用硫酸铁铵容量法测定钛精矿中二氧化钛含量

样品在过氧化钠熔融、水浸取及盐酸酸化后，在盐酸和硫酸介质中，隔绝空气，用金属铝将钛(Ⅳ)还原至钛(Ⅲ)，以硫氰酸盐为指示剂，用硫酸铁铵标准溶液滴定。     

Bi12TiO20 synthesized directly from bismuth (III) nitrate pentahydrate and titanium glycolate and its activity

Pure phase of sillenite structure, Bi₁₂TiO₂₀, was directly synthesized using stoichiometric bismuth (III) nitrate pentahydrate and titanium glycolate by co-precipitation. The influence of pH on the structure of Bi₁₂TiO₂₀ was studied in the pH range of 3–10. The sillenite structure was characterized using XRD and FTIR. The photo-degradation reaction of 4-nitrophenol (4-NP) was used to study photocatalytic activity of Bi₁₂TiO₂₀ as a function of the preparation pH. The rate of decomposition was followed by UV-vis and TOC. The beginning concentration of 4-NP, 44 ppm, decreased to less than 1 ppm within 30 min for all prepared catalysts. It was found that the decomposition rate constant of Bi₁₂TiO₂₀ is six times higher than those of either TiO₂ or Bi₂O₃ under the same conditions.     

月桂醇聚氧乙烯醚硝酸酯助燃降污性能的研究

通过柴油发动机台架试验证明 ,月桂醇聚氧乙烯醚硝酸酯用作柴油添加剂 ,既可提高柴油的燃烧性能 ,又可降低排放尾气中的一氧化碳 (CO)、未燃碳氢化合物 (HC)、氮氧化物 (NOx)含量及烟度等多种功能 ,是一种良好的多功能柴油助燃消烟添加剂。     

Direct synthesis of copper faujasite

Copper containing faujasite has been successfully prepared for the first time using a direct synthesis method. Faujasite type zeolite can be prepared in the presence of copper species by tuning the synthesis conditions. Ammonium hydroxide was used to form a copper complex that was later mixed with the reacting gel. Sodium is required to obtain copper faujasite. The complete elimination of sodium ions from the starting gel produces amorphous material. Crystallization took place at 358 K for 11 days. Crystallization temperature of 373 K produces ANA type zeolite as an impurity. Increasing by two times the amount of copper complex added to the reacting gel increases the crystallization time of Cu-FAU from 11 to 20 days (the crystallization rate decreases). The copper containing faujasite obtained was characterized by XRD, FESEM, EDX, EPR, FT-IR, TPR, and BET. According to the XRD pattern only FAU type zeolite was obtained. According to TPR experiments, the reduction temperature for Cu²⁺ ions present in Cu-FAU prepared by direct synthesis was 70 K more than for Cu-FAU prepared by ion-exchange. This difference can be due to the different location of the copper ions in the supercages or in the sodalite cages of the faujasite.     

稀土硝酸盐与邻香草醛缩邻氨基苯甲酸配合物的合成与表征

由邻香草醛缩邻氨基苯甲酸（以Ｈ２Ｌ表示）与稀土硝酸盐作用合成了３种新固体配合物。并对合成的配合物进行了元素分析、红外光谱、紫外光谱、差热—热重及摩尔电导分析，确定配合物的组成为〔Ｌｎ（ＨＬ）（ＮＯ３）（Ｈ２Ｏ）〕ＮＯ３（Ｌｎ＝Ｄｙ，Ｅｒ，Ｔｍ）。研究了配合物的配位方式和某些物理化学性质。     

硝酸铵的膨化机理研究

膨化硝酸铵是一种自敏化改性硝酸铵,由硝酸铵溶液在专用表面活性剂作用下,经真空强制析晶工艺制得.文中研究了膨化硝酸铵制备的膨化过程和专用表面活性剂的作用,结果表明:在真空和表面活性剂作用下,硝酸铵溶液由不饱和状态至饱和状态,进而达到过饱和状态,最终导致硝酸铵的快速结晶和体系的膨胀.在真空干燥过程中,形成中心空穴、微细孔道和裂缝,它们使膨化硝酸铵的起爆感度提高;专用表面活性剂具有降低硝酸铵溶液表面张力、发泡剂和加快结晶成核的作用.