An iterative method for suboptimal control of linear time-delayed systems

This article presents a new approach for solving the Optimal Control Problem (OCP) of linear time-delay systems with a quadratic cost functional. The proposed method can also be used for designing optimal control time-delay systems with disturbance. In this study, the Variational Iteration Method (VIM) is employed to convert the original Time-Delay Optimal Control Problem (TDOCP) into a sequence of nonhomogeneous linear two-point boundary value problems (TPBVPs). The optimal control law obtained consists of an accurate linear feedback term and a nonlinear compensation term which is the limit of an adjoint vector sequence. The feedback term is determined by solving Riccati matrix differential equation. By using the finite-step iteration of a nonlinear compensation sequence, we can obtain a suboptimal control law. Finally, Illustrative examples are included to demonstrate the validity and applicability of the technique.     

引入激光回馈的双光束干涉效应的研究

提出了一种引入He-Ne激光回馈的双光束干涉系统,并在理论和实验两方面进行了研究。实验中对系统中的干涉信号及激光器尾光功率变化同时进行探测。发现当干涉仪的主回馈镜移动时,激光器尾光信号是正弦形波形,而干涉仪输出的是以双峰为一个周期的信号,双峰中一峰总是高于另一峰,并且当主回馈镜移动方向改变时,同一周期中两峰出现的顺序也随之改变。对实验现象进行了理论分析,并模拟出干涉信号及激光自身功率的变化曲线。理论分析及模拟结果与实验结果完全吻合。讨论了利用发现的现象进行测量的可行性,所提出的测量方法易于实现。     

关于从旋涡炉渣回收铜的研究

介绍了用自然澄清法降低、回收旋涡炉渣中的铜的方法。该方法工艺简单。操作方便，不仅降低冶炼成本，同时提高了经济效益。     

Comparative studies on Ar and He closed-cycle MHD power plants combined with fossil fuel

Comparative studies on Ar and He closed-cycle MHD power plants combined with fossil fuel are performed. The sizes of a regenerative heat exchanger and a boiler are expected to be smaller for He than for Ar. The pressure loss of a working gas in a regenerative heat exchanger is reduced for He. The purification subsystem for He is expected to be more compact and economical than that for Ar; but a larger compressor is required for He than for Ar.     

同位素稀释质谱法测定高放废液中的铀

用双同位素稀释质谱法测定高放废液中的微量铀,采用TBP/Kel-F粉反相分配色层法分离铀,双稀释剂分别为浓缩~(235)U及~(238)U,铀同位素丰度比的质谱测定相对标准误差优于0.1%,化学处理及质谱测定全流程铀的空白值为3×10~(-9)g,方法检测限对于铀为1×10~(-9)g,高放废液中微量铀测定结果不确定度为±2%。     

压水堆硼稀释事故的计算

一、概述核电厂压水堆的初始过剩反应性是通过控制捧、固体可燃毒物和溶解在主回路冷却剂中的硼酸等三种方式联合控制的。随着反应堆的燃耗和裂变毒物的积累,堆的过剩反应性不断减少,需要通过化容系统,控制硼酸的浓度来进行补偿。如果化容系统发生故障或操作员误操作,就会给回路注入无硼或低于规定浓度的补给水,给反应堆引入正反应性,造成硼稀释事故。按核安全法规的要求,应对换料、冷停堆、热停堆和启动等工况进行计算,并要求在这些     

烃类在三甘醇和四甘醇中无限稀释活度系数的测定与关联

用气相色谱法分别测定了苯、甲苯、乙苯、正庚烷、正辛烷、正壬烷和正癸烷在三甘醇和四甘醇中的无限稀释活度系数 ,测定温度范围为 5 0～ 13 0℃。用修正的UNIFAC模型 (Dortmund)对上述不同温度下的无限稀释活度系数实验数据进行关联 ,得到了三甘醇和四甘醇与其它基团的相互作用参数 ,并将计算结果与实测值进行了比较。     

Linear viscoelastic properties of mixtures of 3- and 4-arm polybutadiene stars

The viscoelastic properties of a three-arm and a four-arm star polybutadiene with the same arm molecular weight (M_a) were studied. The zero-shear recoverable compliance (J⁰_e) and plateau modulus (G⁰_N) for these stars are the same. The zero-shear viscosity (η₀) of the three-arm star is 20% lower than that of the four-arm star. Mixtures of the stars had J⁰_e and G⁰_N unchanged. A $\text{50}\text{50}$ mixture of the three- and four-arm star was diluted with a low molecular weight linear polybutadiene. G⁰_N∝ø²; J⁰_e∝ø^?1 and M_e∝ø^?1, as expected for dilution with a θ-solvent.