Compressive strength and wear properties of SiC/Al6061 composites reinforced with high contents of SiC fabricated by pressure-assisted infiltration

Pressure-assisted infiltration was used to synthesize SiC/Al 6061 composites containing high weight percentages of SiC. A combination of PEG and glass water was used to fabricate SiC preforms and the effect of the presence of glass water on the microstructure and mechanical properties of the preforms was evaluated by performing compression tests on the preforms. Also, the compressive strength and the hardness of the SiC/Al composites were investigated. The results revealed that the glass water improved the compressive strength of the preforms by about five times. The microstructural characterization of the composites showed that the penetration of the aluminum melt into the preforms was completed and almost no porosity could be seen in the microstructures of the composites. Moreover, the composite containing 75 wt% SiC exhibited the highest compressive strength as well as the maximum hardness. The results of the wear tests showed that increasing the SiC content reduces the wear rate so that the Al-75 wt% SiC composite has a lower wear rate and a lower coefficient of friction than those of Al-67 wt% SiC composite. This indicated higher wear resistance in these composites than the Al alloy due to the formation of a tribological layer on the surface of the composites.     

Role of Nd-Ni on structural,spectral and dielectric properties of strontium-barium based nano-sized X-type ferrites

The influence of neodymium and nickel substitution on structural and dielectric parameters was investigated in strontium-barium X-type hexagonal ferrites having composition SrBaCu_2?xNi_xNd_yFe_28?yO₄₆ (x = 0, 0.2, 0.4, 0.6, 0.8, 1 and y = 0, 0.02, 0.04, 0.06, 0.08, 0.1). Sol-gel method was employed for synthesizing these hexagonal ferrites. The XRD plots of all studied materials which were annealed at 1250 °C show single phase characteristics. Lattice parameter ‘c’ increased as a consequence of larger radius of rare earth ion (Nd³⁺) as compared to (Fe³⁺), while lattice parameter ‘a’ showed very small variation. The cell volume was obtained in the range 2508.32–2523.75 (ų). The inclusion of Nd-Ni also affected X-ray density, bulk density and porosity. The FTIR spectroscopy indicated the particular absorption peaks of hexagonal ferrites and it was performed in the range of 500–700 cm^?1. On account of Nd-Ni doping, the dielectric constant, dielectric loss and AC-conductivity showed decreasing trend. The occupancy of Nd³⁺ ions at octahedral site impedes the valence alternation of Fe³⁺; therefore there was decrease in dielectric permittivity. Ac conductivity has been decreased from 9.14 to 6.49 (Ω cm)^?1 at frequency of 2.7 GHz. The Cole-Cole plots of synthesized materials noticeably revealed grain boundary contribution. The appearance of single semi-circle in impedance Cole-Cole graphs confirms the exceptional role of grain boundaries in the conduction process. The considerably lower dielectric parameters of investigated nano X-type ferrites propose their feasibility for high-frequency applications (phase shifters, dielectric resonators, stealth technology etc).     

Tuning of ferrimagnetic nature and hyperfine interaction of Ni2+ doped cobalt ferrite nanoparticles for power transformer applications

Ferrites may contain single domain particles which gets converted into super-paramagnetic state near critical size. To explore the existence of these characteristic feature of ferrites, we have performed magnetization(M-H loop) and Mössbauer spectroscopic studies of Ni²⁺ substitution effect in Co_1-xNi_xFe₂O₄ (where x?=?0, 0.25, 0.5, 0.75 and 1) nanoparticles were fabricated by solution combustion route using mixture of carbamide and glucose as fuels for the first time. As prepared samples exhibit spinel cubic structure with lattice parameters which decreases linearly with increase in Ni²⁺ concentration. The M-H loops reveals that saturation magnetization(M_s), coercive field(H_c) remanence magnetization(M_r) and magnetron number(η_B) decreases significantly with increasing Ni²⁺ substitution. The variation of saturation magnetization has been explained on the basis of Neel's molecular field theory. The coercive field(H_c) is found strongly dependent on the concentration of Ni²⁺ and decrease of coercivity suggests that the particles have single domain and exhibits superparamagnetic behavior. The Mössbauer spectroscopy shows two ferrimagnetically relaxed Zeeman sextets distribution at room temperature. The dependence of Mössbauer parameters such as isomer shift, quadru pole splitting, line width and hyperfine magnetic field on Ni²⁺ concentration have been discussed. Hence our results suggest that synthesized materials are potential candidate for power transformer application.     

DSR的一种自适应路由自动缩短机制

动态源路由协议是无线自组织网络众多路由协议中被广泛关注的一种按需路由协议，目前，关于该协议的优化措施有很多。本文先分析了动态源路由协议的一种优化机制——路由自动缩短，该机制能动态缩短处于工作状态路由的跳数，但不保证缩短路由的质量，在此基础上，提出一种自适应路由自动缩短机制，新机制既可缩短路由．又能保证缩短路由质量．理论分析及仿真结果表明，自适应路由缩短机制的各项性能优于原路由缩短机制。     

An Improved Immune Genetic Algorithm for Solving the Optimization Problems of Computer Communication Networks

1　IntroductionIndesigningacomputercommunicationnet work ,thenetworkaveragedelayisanimportantpa rameterinthenetworkperformance .Inthispaper,weonlyconsiderM /M/1networks,whichmeansthatthemessageprocessingtimeisaprobabilisticdensityfunctionwithnegativepower,thegroupar rivalandsendingisofPoissiondistributionwithasinglequeue .Supposethatthenetworktopologicalstructureandtheestimatesoftheexternaltrafficrequirementsaregiven ,howtoselecttheoptimalroutestobeusedbythecommunicatingnodesinthenetworksoast…     

对地域通信网呼损的研究与仿真

本文通过对具有迂回路由的地域通信网呼损的研究与计算机仿真,得出迂回路由的存在使呼损大为降低的结论,从而增加了地域通信网的抗毁性能。     

新型实用布线算法──L─M算法

本文提出新型布线算法，集李氏迷宫法与线搜索法的长处为一体，以饱和带法进行动态排序，以线搜索法确定借孔位置，然后用李氏法进行单层布线，获得最佳路径，从而达到线型好，布通率高的效果。     

Prediction and quality control of the melt index during production of high-density polyethylene

In polyolefin processes the melt index (MI) is the most important control variable indicating product quality. Because of the difficulty in the on-line measurement of MI, a lot of MI estimation and correlation methods have been proposed. In this work a new dynamic MI estimation scheme is developed based on system identification techniques. The empirical MI estimation equation proposed in the present study is derived from the 1 ^st -order dynamic models. Effectiveness of the present estimation scheme was illustrated by numerical simulations based on plant operation data including grade change operations in high density polyethylene (HDPE) processes. From the comparisons with other estimation methods it was found that the proposed estimation scheme showed better performance in MI predictions. The virtual sensor model developed based on the estimation scheme was combined with the virtual on-line analyzer (VOA) to give a quality control system to be implemented in the actual HDPE plant. From the application of the present control system, significant reduction of transition time and the amount of off-spec during grade changes was achieved     

超高速线路保护原理及应用

在广泛参阅了对暂态量保护的研究 ,对各种基于故障时产生暂态量的保护原理和技术特点及应用进行了分析比较 ,并指出了各种新型保护的优缺点及暂态量保护的发展趋势     

论解放战争时期中间路线的兴衰及成因

抗日战争胜利初期,国共内战迫在眉睫。为挽救危局,强国富民,中间人士提出所谓中间路线,企图走“第三条道路”实现和平建国。在反动政府的强力弹压和中共的教育帮助下,中间路线退出历史舞台。民主党派的转型历程充分昭示了中国人民在中共领导下走上新民主主义道路的必然性。