降低成品油二次物流运输成本的思考

介绍了传统成品油进货和管理模式存在的诸如成品油物流以行政区划、中问环节多、信息化程度不高、运输路线未优化造成物流成本提高等问题。提出要降低成品油二次物流运输成本，当务之急是加强成品油物流的信息化建设；调整管理模式，打破行政区域界限，开展经济辐射半径内的库站物流配送；引进竞争机制，打破运输垄断，一、二次物流结合，大、小车型搭配，提高运营效率；做好运杂费全面预算、核算及运行费用的过程控制。     

游梁式抽油机二次平衡分析

为解决游梁式抽油机能耗大、效率低的问题，设计了二次平衡装置。这种装置通过是挂在抽油机后端的平衡重的平衡作用，降低一次平衡曲柄轴净扭矩的两个峰值，达到减少能耗提高效率的目的。对抽油机的二次平衡作了较详尽的理论分析，给出了实行二次平衡后曲柄轴净扭矩的计算公式和安装二次平衡装置前后曲柄轴净扭矩曲线图。在大庆油田两口井上进行的现场试验结果表明，安装二次平衡装置后，两口井年节约电费分别为0.25万元和1．17万元，经济效益明显。     

连续梁的简便计算

利用三转角方程，对连续梁的内力进行精确的计算，该方法简捷明了，便于应用。     

高氯酸为催化剂乙酰化法测定伯醇或仲醇

提出了以主氯酸为催化剂，分析纯乙酸乙酯为介质，乙酸化法测定伯、仲醇的实验条件，实现了对经典方法的改进，简化了操作程序。     

8Li次级束的产生

在北京串列加速器次级束流线上通过2 H(7Li,8Li) 1H逆运动学反应产生了用于核天体物理研究的8Li次级束。准直后的次级束纯度达到 80 %以上 ,对于 44MeV的7Li强度约为 3 0s- 1·pnA- 1,可以用来进行逆几何转移反应的实验测量。     

工业建筑多层框架的活荷载不利布置

以设防烈度为8度的框架厂房为例，详细分析了活荷载不利布置对框架梁、柱内力的影响，得出何时需要考虑活荷载不利布置、何时不需要考虑活荷载不利布置的结论，可供工程设计参考。     

黄河黑山峡河段大柳树水库比小观音水库原始库容多40亿m3的作用

一级开发大柳树高坝原始库容比二级开发小观音高坝多 4 0亿m3 ,库容大带来的好处体现在 5～ 7月可多向下游增供水量 ,缓解下游河道断流 ;延长泄放清水时间 ;增加发电效益 ;满足宁蒙河段防凌要求 ;增加汛期集中泄水 ,减缓下游河道淤积萎缩 ;满足南水北调西线工程水量调节要求等。为了更好优化配置黄河水资源 ,从全局和长远利益考虑 ,应采用一级开发方案 ,修建大柳树高坝大库     

Evidence of High Vertical Wave-Number Behavior in a Continuously Stratified Reservoir: Boadella, Spain

High vertical wave-number modes clearly dominate the internal wave field during the stratification period in Boadella reservoir in northeast Spain. In this period, the extraction of hypolimnetic water, due to summer irrigation, brought the surface level down by 6 m in one month and the epilimnetic water progressively occupied the whole water column. The temperature profile, with the exception of a few meters at the surface layer, presented an almost constant temperature gradient of about 0.7°C/m. The period of the main vertical mode is 24 h with an amplitude of around 1 m. Thermistor chain records and meteorological data allow us to deduce that this mode is, at least, a third vertical mode forced by the wind, which normally has a typical periodicity of 24 h. However, when the wind changes direction from south to north, the circulation cells developed due to this forced nonstationary oscillation are destroyed. When this occurs, the Bulk Richardson number is Rib ～ 1. Similar vertical structures as a response to wind forcing should be expected in similar systems, although this has not been reported in the literature.     

Modelling and analysis of 3-D arrangements of particles by point processes with examples of application to biological data obtained by confocal scanning light microscopy

Within the concept of point processes, a review is presented of quantities which can be used in studies of three-dimensional (3-D) aggregates of particles. Suitable characteristics and estimators are given for both unmarked and marked point processes. To demonstrate the feasibility of such quantitative approaches, an application in histology, dealing with 3-D arrangements of cell nuclei in rat liver, is described. Using a confocal scanning light microscope, 3-D images are recorded and image analysis used to obtain the coordinates of the centroid, together with the volume and DNA content, of each cell nucleus. Examples of results are given, using both unmarked and marked point processes. In the latter case, cell type, nuclear volume and ploidy group are suitable marks.     

HYDRODYNAMIC FORCE ON SMOOTH HORIZONTAL CYLINDER IN UNIFORM OSCILLATORY FLOW

ＨＹＤＲＯＤＹＮＡＭＩＣ　ＦＯＲＣＥ　ＯＮ　ＳＭＯＯＴＨ　ＨＯＲＩＺＯＮＴＡＬ　ＣＹＬＩＮＤＥＲ　ＩＮ　ＵＮＩＦＯＲＭ　ＯＳＣＩＬＬＡＴＯＲＹ　ＦＬＯＷＨＹＤＲＯＤＹＮＡＭＩＣＦＯＲＣＥＯＮＳＭＯＯＴＨＨＯＲＩＺＯＮＴＡＬＣＹＬＩＮＤＥＲＩＮＵＮＩＦ...