Reducing numerical dissipation in smoke simulation

Numerical dissipation acts as artificial viscosity to make smoke viscous. Reducing numerical dissipation is able to recover visual details smeared out by the numerical dissipation. Great efforts have been devoted to suppress the numerical dissipation in smoke simulation in the past few years. In this paper we investigate methods of combating the numerical dissipation. We describe visual consequences of the numerical dissipation and explore sources that introduce the numerical dissipation into course of smoke simulation. Methods are investigated from various aspects including grid variation, high-order advection, sub-grid compensation, invariant conservation, and particle-based improvement, followed by discussion and comparison in terms of visual quality, computational overhead, ease of implementation, adaptivity, and scalability, which leads to their different applicability to various application scenarios.     

地层测试的压力"下滑恢复"响应分析

在油气井的试油测试资料中，压力恢复曲线有时会出现下滑现象，常被认为是施工失误所致。本文以实际资料为例，分析了“下滑恢复”的压力响应特征和影响因素，认为只在低渗透地层有可能产生“下滑恢复”现象，并提出了避免“下滑恢复”的施工建议。     

Drying of Uncoated Paper with Gas-Fired Infrared Emitters—Optimum Emitters' Location Within a Paper Machine Drying Section

This article theoretically investigates the drying of uncoated paper with gas-fired infrared (IR) emitters installed within the drying section of a given commercial paper machine. Specifically, it presents the ideal location of two opposing IR emitters within the drying section. The ideal location of the two opposing IR emitters corresponds to the highest machine speed with specified average moisture content of paper sheet at the end of the drying section. This article also presents the average evaporation rate, temperature, and moisture content of the paper sheet as it travels through the drying section with the two opposing IR emitters operating at the optimum location. In addition, the temperature and moisture profiles in the sheet thickness direction, before and after the IR emitters, are provided. This article is not concerned with the potential effects of drying with IR emitters on paper sheet properties and machine runnability issues.     

Relaxation phenomena caused by equilibration of point defects

Relaxation phenomena due to equilibration of point defects in metals are reviewed. The relaxation effect in specific heat observed in tungsten and platinum confirms that in both cases the nonlinear increase in the high-temperature specific heat has to be attributed to point-defect formation. Relaxation phenomena observed by measurements of electrical resistivity and positron annihilation are also considered. The comparison of the data seems to be favorable for the conclusion that all the phenomena are of one origin.     

A novel method of suppressing the inrush current of transformers by using a series‐connected voltage‐source PWM converter

This paper proposes a novel method of suppressing the inrush current of transformers. A small‐rated voltage‐source PWM converter is connected in series to the transformers through a matching transformer. As the connected PWM converter serves as a resistor for the source current, no inrush phenomena occurs. The required rating of the PWM converter, which serves as the damping resistor for the inrush phenomena, is 1/400 that of the main transformers in single‐phase circuits. In three‐phase circuits, it is 1/900. The basic principle of the proposed method is discussed. Digital computer simulation is implemented to confirm the validity and excellent practicability of the proposed method using the PSCAD/EMTDC. A prototype experimental model is constructed and tested. The experimental results demonstrate that the proposed method can perfectly suppress the inrush phenomena. © 2006 Wiley Periodicals, Inc. Electr Eng Jpn, 157(4): 56–65, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20174     

三元催化转化器中的现象分析与研究

在介绍和分析国内外研究现状的基础上，论述了三元催化转化器中的传递现象及化学反应动力学．探讨了三元催化转化器在暖机过程中有害物质的催化转化模型，并建议采用数学模型的方法对催化器在发动机所有工况下的工作过程进行模拟。     

Electrokinetic remediation of soils contaminated with heavy metals

This paper describes the results obtained from an electrokinetic treatment of a real soil polluted by lead acetate. Powdered soil samples were pressed with a consolidometer till 100 kPa to obtain cylindrical specimens with the same characteristics as a subsoil. Tests were carried out in a Perspex electrochemical cell where soil specimens were introduced with a hollow punch. A low intensity direct current was applied in order to remove contaminants, due to electrophoresis and electroosmosis phenomena. The water flow, conductivity, apparent electroosmotic coefficient, as well as other characteristic parameters, were measured throughout the test. The water content and degree of pore saturation were estimated at the beginning and end of the test. The soil slab was divided into four slices and the Pb concentration profile determined. The main factor governing the extraction of contaminant was found to be the pH in the acidic range. Indeed, under these conditions high removal efficiencies could be reached. These results could lead to the design of a new electrochemical treatment cell equipped with a cationic membrane to expand the region of favourable pH within the soil.     

Studies on the dielectric and relaxor behavior of sol-gel derived barium strontium zirconate titanate thin films

The dielectric behavior of sol-gel derived Ba_0.80Sr_0.20(Zr_xTi_1−x)O₃ (0.0 ≤ x ≤ 0.50) thin films is studied. A relaxor behavior is observed for x ≥ 0.35. The degree of relaxation increases with Zr content. The frequency dependence of the polar regions follows Vogel-Fulcher relation with a characteristic cooperative freezing at freezing temperature (T_f). Below T_f, a long range polarization ordering is likely to take place. The plausible mechanism of the relaxor behavior of BSZT thin films with Zr contents ≥ 0.35 has been proposed based on the measured temperature as well as frequency dependent dielectric data. The solid solution system is visualized as a mixture of Ti^+ 4 rich polar regions and Zr^+ 4 rich regions; with the increase in Zr content the volume fraction of the polar regions is progressively reduced. At and above 35.0 at.% Zr substitution the polar regions exhibit typical relaxor behavior.