大功率CO2激光器脉冲电源研究

本文论述了直流高压与高频脉冲电源相叠加，构成高频、高压脉冲电源，并使其对CO2激光器进行放电实验，研究了同条件下的放电参数与功率。     

低频电脉冲采油工程设备的开发与应用

低频电脉冲采油技术是通过升压、整流、充电等电路将电能蓄积在电容器中,通过触发电路,使能量瞬时释放,在井内液体中产生震动波,作用于地层,改善地层的渗流状况,达到提高采收率的目的。Ⅰ型设备在双河油田应用11井次,成功率72%;Ⅱ型设备在古城油田应用10井次,成功率90%。主要是由于Ⅰ型设备关键部件在处理油井时要放在井下,受高温、高压的影响及井下空间的限制,设备稳定性差、寿命短、能量小、效果差;Ⅱ型设备解决了上述问题,从而提高了试验成功率。     

现代住区规划的几点思考

通过对居住区规划中住区交通组织、环境建设,以及住宅配套现实处理方法的分析,指出现代住区的规划要根据当地实际情况,因地制宜组织住区交通网络,合理整合住宅内外环境,适度超前建设配套设施。     

关于广义函数δ(x)的讨论

本文应用《电气子教学学报》之邀约而写，旨在针对一些读者对该韩过去刊出的有关广义函数δ(x）的文章中的质疑，从数学角度提供一些有助于正确认识、处理和运用广义函数的辅助材料。     

Project to develop school education services in Delhi, India

There are many ways in which quantitative decision models can be applied in project management. The introduction of a project evaluation review technique network model to the development of a school education service in the city of Delhi, India, is described. The reasons for choosing this method, its advantages and limitations are discussed. Examples of the information obtained from the model are presented and explained.     

光纤复合架空地线雷击断股的分析及试验

介绍了光纤复合架空地线(0PGW)雷击断股的特征，讨论了其原因和机理，并进行了0PGW的雷电冲击电波试验，分析了造成断股的影响因素，提出了防止雷击造成0PGW断股的措施。     

Measurement of the coolant flow rate using correlation of temperature fluctuations

The transit time of the coolant, and thus its velocity, has been measured using the temperature fluctuation at the outlet of a reactor core. An impulse response function estimation is introduced, which substitutes the widely used cross-correlation measurement technique. It is shown in theory and practice that the time delay estimation is improved when using the impulse response function instead of the cross-correlation function in parameter estimation. Extremely low velocities (down to 2 cm/sec) have been measured in a natural circulation regime in a research reactor.     

Flashover voltage characteristics of contaminated station insulators under temporary ac overvoltages in the ac system connected with a frequency converter station

According to the recent analysis results of temporary ac overvoltage in the ac system connected with a frequency converter station, large-magnitude over-voltages were confirmed to occur under some special system conditions. Most of the station insulators currently used cannot withstand such overvoltages according to an evaluation based on the data obtained earlier. The necessity of tests to be done to evaluate such performance more accurately was recognized. Both power frequency and switching impulse overvoltage flashover tests were made on contaminated insulators by the method well simulating the natural wetting condition. Switching impulse flashover voltage with the waveshape having a long wavefront time of 2 ms can be well correlated with the flashover voltage characteristics of temporary ac overvoltage. Higher flashover voltage characteristics were obtained by a clean fog test method compared with those obtained by equivalent fog test method.     

Experimental Study about Activated Water Generated by the Electro—hydraulic Impulse Strengthening the Mechanical Performance of Concrete

On the basis of a great number of experiments, it is proved that the strength of concrete is improved greatly when it is mixed with activated water produced by the electro-hydraulic impulse.With the proper parameters, the compression strength of concrete can be increased by 45% .The reason for improvement of concrete strength by using activated water is discussed from the aspect of the structure of molecule.     

Line balancing in a just-in-time production environment: balancing multiple U-lines

The introduction of multiple, independent production lines has helped many firms to increase their production flexibility, provide for redundancy when equipment breaks down, reduce idle time and labor costs, and achieve many other benefits. This paper introduces and formalizes the multiple U-line balancing problem. Optimal solution methodologies are provided for Type I (minimize the number of stations for a given cycle time), Type II (minimize the cycle time for a given number of stations), and cost-minimization line-balancing problems. A branch-and-bound algorithm is also developed for the situation in which equipment requirements are dependent on the line configuration and the task assignment to stations. Computational results indicate that the greatest benefit of exploiting multiple lines occurs for smaller cycle-time problems that require higher output.