裂缝性油气藏采收率：100个裂缝性油气田实例的经验总结

通过对世界上100个裂缝性油气藏的综合评价，研究储集层及流体本身的性质(包括孔隙度、渗透率、黏度、可动油比例、含水饱和度、润湿性及裂缝分布特征等)和驱动机制及油藏管理战略(优化日产量和采用不同类型的提高采收率技术)对其最终采收率的影响。将裂缝性油气藏分为4类：I类的基质几乎没有孔隙度和渗透率，裂缝是储存空间和流体流动的通道；Ⅱ类的基质有较低的孔隙度和渗透率，基质提供储存空间，裂缝提供流动通道；Ⅲ类(微孔隙)的基质具有高孔隙度和低渗透率，基质提供储存空间，裂缝提供流动通道；Ⅳ类(大孔隙)的基质具有高的孔隙度和渗透率，基质提供储存空间和流动通道，裂缝仅增加渗透率。对26个Ⅱ类油气藏和20个Ⅲ类油气藏的开采历史的研究表明：Ⅱ类油气藏的采收率受水驱强度和最优日产量控制，日产量过高会很容易破坏Ⅱ类油气藏，一些Ⅱ类油气藏如果管理得当，采收率可以很高，不需要二次或三次采油；Ⅲ类油气藏的采收率主要受岩石和流体本身性质的影响，特别是基质渗透率、流体重度、润湿性以及裂缝强度等，不进行二次或三次采油不可能完全开采，往往需要采用一些提高采收率的专门技术。以往将Ⅱ类和Ⅲ类裂缝性油气藏归为一类，认识它们的区别将有助于选择更好的开发策略。     

An automatic torque ripple compensation system for direct drive motors

A serious problem in motion control is the occurrence of torque ripple. Since a direct drive (DD) motor with a magnet rotor uses a rare-earth magnet, the torque ripple is more serious than that of conventional servomotors. This paper presents an auto-compensation of torque ripple using a software-implemented torque observer. The frequency and amplitude of torque ripple can be obtained in the controller by using the estimated torque from an observer, and the autonomous generation of a compensating current component for a torque ripple is possible. The proposed algorithm has been verified by experiments.     

ABB变频器在双馈发电机试验台上的应用

本文介绍了风力发电系统目前存在的技术方案，重点介绍了ABB用于双馈式风力发电系统的变频产品ACS800—67的特性，并对由其构建的发电机测试平台的案例进行了实验分析。     

Series resonant ZCS‐PFM DC‐DC power converter with high‐frequency high‐voltage transformer link for high‐power magnetron drive

This paper presents a single lossless inductive snubber‐assisted ZCS‐PFM series resonant DC‐DC power converter with a high‐frequency high‐voltage transformer link for industrial‐use high‐power magnetron drive. The current flowing through the active power switches rises gradually at a turned‐on transient state with the aid of a single lossless snubber inductor, and ZCS turn‐on commutation based on overlapping current can be achieved via the wide range pulse frequency modulation control scheme. The high‐frequency high‐voltage transformer primary side resonant current always becomes continuous operation mode, by electromagnetic loose coupling design of the high‐frequency high‐voltage transformer and the magnetizing inductance of the high‐frequency high‐voltage transformer. As a result, this high‐voltage power converter circuit for the magnetron can achieve a complete zero current soft switching under the condition of broad width gate voltage signals. Furthermore, this high‐voltage DC‐DC power converter circuit can regulate the output power from zero to full over audible frequency range via the two resonant frequency circuit design. Its operating performances are evaluated and discussed on the basis of the power loss analysis simulation and the experimental results from a practical point of view. © 2005 Wiley Periodicals, Inc. Electr Eng Jpn, 153(3): 79–87, 2005; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20126     

Overview of Tiber-II—Evolution toward an Engineering Test Reactor

TIBER II is designed to be a minimum size and cost candidate for an international Engineering Test Reactor. High-current density Nb₃Sn superconducting magnets with radiation-tolerant polymide insulation is combined with a minimum thickness tungsten inbored shield and a common, external vacuum boundary to minimize the inner radial build of the tokamak core. This results in a major radius of 3 m, compared to 5 m for previous ETR designs such as INTOR, with correspondingly lower costs expected. Cyclic stress fatigue limits the number of pulses so that steady-state current drive, based on a combination of neutral beams, lower hybrid and ECH, is designed to achieve reactor-relevant nuclear testing conditions (Fluence 3MW yr/m², rwall > 1 MW/m² in steady state).This report is abstracted from a more complete information document UCID-20863 with numerous authors. See Ref. l for complete credits.     

A helical drive in-pipe robot based on compound planetary gearing

The modern society is fuelled by very comprehensive grids of gas and liquid pipelines. In recent years, various in-pipe robots have been developed for inspection and maintenance tasks inside such pipes. In this paper, a novel in-pipe robot is proposed and developed for gas/oil well interventions at thousands of meters downhole. Due to the nature of such intervention, in-pipe robot design must be capable of carrying a very large payload, as large as 2500?N inside a pipe with diameter as small as 54?mm. The proposed design concept is based on a compound planetary gearing system. One of the major novelties of this design is the use of pipe wall as a ring gear for one stage of the compound planetary gear system; the other novelty is the generation of helical angle when the planetary gears are expanded to press on the pipe wall. The proposed concept is compact, efficient, and has never been reported before. In this paper, the helical angle, the velocity, and load capability of the proposed system will be analyzed. The load transportation capability of the proposed robot is also measured based on an experiment. Initial data have shown great potential in carrying large payloads.     

压电双晶片型旋转精密驱动器动态特性和控制

提出了以自由端带有集中质量的悬臂式压电双晶片为驱动单元的新型冲击式旋转精密驱动器.制作了驱动器样机,建立了基于Lugre摩擦模型的驱动器动力学模型.对驱动器动态特性进行了仿真分析和实验对比研究.根据驱动器的动态特性,提出了冲击式压电双晶片型精密驱动器特定的定频调压控制方法.仿真分析结果和实验结果吻合较好,表明该动力学模型符合驱动器的动态特性,可用于对冲击式压电双晶片型旋转精密驱动器的理论分析.     

基于预处理的Ballon模型及在眼疲劳检测中的应用

获取眼睛轮廓和眼球轮廓对进一步研究人眼疲劳状态具有重要意义.提出基于预处理的Ballon模型对含有双眼的局部人脸图片进行人眼和眼球检测的方法.用微分算法抽取边缘、标识出物体、使用几何特性识别人艰区域,自动获取主动轮廓所需要的眼睛初始轮廓;使用提出的基于预处理的Ballon模型收敛人眼;结合数学形态等方法收敛到眼球.实验结果表明,该方法具有效果好、鲁棒性好、受光线影响弱等优点.     

The Rayleigh-Taylor instability in the spherical pinch

The spherical pinch (SP) concept is an outgrowth of the inertial confinement model (ICF). Unlike the ICF, where instabilities, especially the Rayleigh-Taylor instability, have been studied extensively, the instability study of the spherical pinch has just begun. The Rayleigh-Taylor instability is investigated for the first time in the SP in the present work. By using the simple condition for the Rayleigh-Taylor instability p·<0 (density and pressure gradients have opposite direction), we have qualitatively identified the regions for development of instabilities in the SP. It is found that the explosion phase (central discharge) is stable and instabilities take place in the imploding phase. However, the growth rate for the instability is not in exponential form, and the appearance of the Rayleigh-Taylor instability does not prevent the main shock wave from converging to the center of the sphere.