Characteristics of hydrostatic bearing/seal parts for water hydraulic pumps and motors. Part 1: Experiment and theory

In this paper, the load-carrying capacity, power losses and stiffness of disk-type hydrostatic thrust bearings including the case of eccentric loading are discussed theoretically. The numerical analysis method is established based on a two-dimensional elastohydrostatic problem with an elastic deformation model, which is extended to adapt it for a non-axisymmetric load acting on the thrust bearing. The bearing is made of a combination of stainless steel/stainless steel and stainless steel/plastics. For the elastic materials, the maximum stiffness derived from, i.e., minimum film thickness is, larger than that of the rigid material in the range of a large ratio of pocket pressure and a hydrostatic balance ratio of over unity, which is defined as the ratio of the load to the maximum hydrostatic load-carrying capacity. The maximum load-carrying capacity and minimum power loss can exist in the domain of the hydrostatic balance ratio over unity for the case of the bearing consisting of elastic/rigid materials, in comparison with that composed of the same rigid materials. For the case of water, the power loss due to leakage flow is slightly larger but that due to frictional torque is much smaller than that in the case of hydraulic oil. Then, the total power loss is much smaller than that of hydraulic oil.     

AD2S80在测角系统中的应用

DS2S80是美国AD公司生产的以鉴幅方式对感应同步器信号进行处理的专用芯片。由它与感应同步器构成的测角系统具有成本低、功耗小、所需外部元件少、可靠性好等优点。介绍了AD2S80数字转换芯片的引脚、组成测角系统的工作原理、外围电路的设计，给出了一种半量式测角系统的实现方案。     

连铸喷嘴特性测试与分析

通过测试连铸二冷喷嘴性能，对比同型号喷嘴使用前后两种状态下特性参数，分析了喷嘴参数变化的原因。提出了对使用中的喷嘴特性进行检测与校核的建议，以确保喷嘴特性满足铸坯二冷工艺条件，保证铸坯质量。     

铸铁热分析用试样新型激冷剂的实验研究

从冷却曲线上相变段倾角最小原则出发，研究了新型激冷剂的配比与热分析法检测铸铁成分精度的关系，实验结果表明，能使相变段倾角最小的成分配比，也能提高对铸铁成分的热分析和检测精度。     

固体火箭发动机喷管用烧蚀隔热材料研究进展

介绍了固体火箭发动机喷管用烧蚀隔热材料的研究进展，喷管受热分析，指出了先进复合材料的发展趋势，提出碳／酚醛复合材料在制造低成本的发动机喷管中仍有重大使用价值。     

玻璃两面重叠手印拍摄机理

根据斯涅尔定律和菲涅尔公式阐述清水衬底法消除玻璃下界面手印或玻纹的影像，以及用偏振光，紫外线拍摄玻面痕迹的方法和机理。     

光电摆角动态测量原理及其测量系统

本文阐述了用于测量物体摆角及摆心浮动量的光电动态实时测量原理,以及根据此原理研制的光电导弹喷管摆角动态测量系统。     

排列互比法用于超精测角的研究

作者分析了我互比法现行的两种数据处理方法的缺点，提出了应用最小二乘法原理推导出合理的数据处理方法。本文还首次从理论上阐明了排列互比法测量结果中出现一次谐波系统误差的原因，提出了减少和消除这一些系统误差的方法，并给实验验证。     

Novel miniature integrated optical goniometers

A new principle and arrangement for directly determining the angle of incidence of an optical beam on an object are proposed and demonstrated. The novelty of the approach lies in the realization of a ‘smart object’, which extracts a portion of the incident beam's power into an optical waveguide attached to the object's surface or embedded in its body for converting the angle of incidence into the position of a guided beam with finite lateral extent. This ‘integrated optical light pointer’ beam is accomplished by means of creating additional degrees of freedom on the target in two different ways. While a first type is based on introducing spatial variations of the waveguide thickness, a second type makes use of a chirp of the grating periodicity. The feasibility for practical applications has been experimentally demonstrated by a direct comparison with a commercial high-resolution encoder, resulting in an r.m.s. error of <30′'. Measurements have been performed for chips fabricated based on replicated polycarbonate substrates and with no external optics, showing the great potential of this approach for realizing low-cost yet high-performance miniature goniometers.     

用变角XPS定量分析研究GaAs光电阴极激活工艺

用变角X射线光电子能谱 (XPS)技术分析了GaAs光电阴极的激活工艺 ,定量计算了阴极表面激活层和界面氧化层的厚度和组成。界面氧化物是由于O原子穿过激活层 ,扩散到GaAs与 (Cs,O)激活层的界面上而形成的。导入过量O会增加O GaAs界面层的厚度 ,而对 (Cs,O)激活层厚度影响较小。在激活过程中 ,严格控制和减少每次导入的O量是减少界面氧化层厚度 ,提高灵敏度的重要途径。在第一步激活后的阴极样品 ,通过较低温度的加热和再激活 ,能获得比第一步高出 30 %的光电灵敏度的原因是较低温度加热减少了界面氧化层的厚度和界面势垒