Thermo-economic investigation on the hydrogen production through the stored solar energy in a salinity gradient solar pond: A comparative study by employing APC and ORC with zeotropic mixture

In this paper, a salinity gradient solar pond (SGSP) is used to harness the solar energy for hydrogen production through two cycles. The first cycle includes an absorption power cycle (APC), a proton exchange membrane (PEM) electrolyzer, and a thermoelectric generator (TEG) unit; in the second one, an organic Rankine cycle (ORC) with the zeotropic mixture is used instead of APC. The cycles are analyzed through the thermoeconomic vantage point to discover the effect of key decision variables on the cycles’ performance. Finally, NSGA-II is used to optimize both cycles. The results indicate that employing ORC with zeotropic mixture leads to a better performance in comparison to utilizing APC. For the base mode, unit cost product (UCP), exergy, and energy efficiency when APC is employed are 59.9 $/GJ, 23.73%, and 3.84%, respectively. These amounts are 47.27 $/GJ, 29.48%, and 5.86% if ORC with the zeotropic mixture is utilized. The APC and ORC generators have the highest exergy destruction rate which is equal to 6.18 and 10.91 kW. In both cycles, the highest investment cost is related to the turbine and is 0.8275 $/h and 0.976 $/h for the first and second cycles, respectively. In the optimum state the energy efficiency, exergy efficiency, UCP, and H₂ production rate of the system enhances 42.44%, 27.54%,15.95%, and 38.24% when ORC with the zeotropic mixture is used. The maximum H₂ production is 0.47 kg/h, and is obtained when the mass fraction of R142b, LCZ temperature, pumps pressure ratio, generator bubble point temperature are 0.603, 364.35 K, 2.12, 337.67 K, respectively.     

玄武岩纤维填料应用于两种混合生长反应器的评价

采用单丝直径微米级的伞状玄武岩纤维(BF)作为填料,将其引入序批式反应器(SBR)和后置缺氧反硝化SBR外聚合物(EPS)含量和扫描电子显微镜形貌图,考察了两种SHBR的污水处理效果。试验结果表明:基于SBR的SHBR的出水COD、氨氮、总氮去除率分别为83.2%、89.9%、86.8%;基于后置缺氧反硝化SBR的SHBR优良,而基于后置缺氧反硝化SBR的SHBR的脱氮效果得到进一步的优化和提升。两种SHBR的BF填料中EPS含量分析结果显示:在好氧环境下,蛋白质(PN)的含量高于多糖(PS)的含量;在缺氧条件下,PS的含量明显高于PN的含量。     

用SBR1502胶浆制取道路沥青改性用胶乳

用附聚法和降粘法浓缩ＳＢＲ１５０２胶浆制取道路沥青改性用胶乳。结果表明：总固物质量分数可由（２１±２）％上升到４５％～５０％。该胶乳与齐鲁石化公司炼油厂１００号乙沥青混合，改性后的道路沥青具有良好的使用性能，可满足高等级路面沥青的技术要求。     

EM用于SBR反应器处理生活污水

重点讨论了有效微生物群（EM）在SBR反应器中对生活污水的COD、TP、NH3－N和TN的去除效果。试验结果表明，当EM投量（VEM／V污水）为1／10000－1／1000时，能显著提高SBR对COD、TP、NH3－N和TN的去除率和降解速度；当EM投量（VEM／V污水）为1／100000－5／1000时，对TN的去除率随EM量的增加而逐渐提高；当EM投量为1／10000时，能显著缩短SBR的曝气时间并可节能降耗。     

高密度澄清池在邯钢第二污水处理厂的应用

高密度澄清池是一种新型高效的澄清池。介绍了高密度澄清池的工艺原理、运行条件和主要参数及在邯钢第二污水处理厂的应用情况。     

Big-Fish--Little-Pond effect on academic self-concept: A cross-cultural (26-country) test of the negative effects of academically selective schools.

Academically selective schools are intended to affect academic self-concept positively, but theoretical and empirical research demonstrates that the effects are negative. The big-fish--little-pond effect (BFLPE), an application of social comparison theory to educational settings, posits that a student will have a lower academic self-concept in an academically selective school than in a nonselective school. This study, the largest cross-cultural study of the BFLPE ever undertaken, tested theoretical predictions for nationally representative samples of approximately 4,000 15-year-olds from each of 26 countries (N=103,558) who completed the same self-concept instrument and achievement tests. Consistent with the BFLPE, the effects of school-average achievement were negative in all 26 countries (M beta=-.20, SD=.08), demonstrating the BFLPE's cross-cultural generalizability. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

SBR工艺发展应用综述

关于SBR工艺的书籍和文章很多。本文在这些资料的基础上整理总结 ,对经典SBR工艺的应用进行了综述 ,归纳了经典SBR工艺的特点 ,介绍了各种新型SBR工艺。     

城市污水处理厂的施工监理

指出施工监理是一项细致而又责任重大的工作。把握好污水处理厂关键工序的施工及检查,才能对污水处理工程进行有效地控制和管理,使之发挥最大的经济和社会效益。     

丁苯胶乳改性道路沥青的推广应用

用丁苯胶乳对胜利１００号沥青进行改性试验．发现随着胶乳掺量的增加．沥青的高温性能、粘结性能改善幅度也大。但综合考虑沥青生产成本等因素．认为：对丁苯胶乳改性胜利１００号道路沥青．掺胶量控制在２％即可满足一般高等级道路工程的需要。文中还介绍了丁苯胶乳沥青近年来的推广使用情况并做了相应的技术经济分析和建议。     

Short fibre elastomer composites: effect of fibre length,orientation, loading and bonding agent

A series of short fibre reinforced styrene butadiene rubber (SBR) composites were prepared by incorporating sisal fibres of different lengths and different concentrations. The vulcanization behaviour and the properties of the vulcanizates were measured by the relevant ASTM procedures. The processing characteristics such as green strength and mill shrinkage were improved by the addition of fibres. The properties like tensile strength, tear strength, moduli at 10% and 20% elongations were found to be maximum for composites containing longitudinally oriented fibres of length 6 mm. Mixes containing 35 phr loading of fibres and bonding agent showed better mechanical performance than others. The failure behaviour of tensile and tear specimens have been analysed by scanning electron microscopy techniques. Paper presented at the poster session of MRSI AGM VI, Kharagpur, 1995