Progressive NO2 Sensors with Rapid Alarm and Persistent Memory-Type Responses for Wide-Range Sensing Using Antimony Triselenide Nanoflakes

Antimony triselenide (Sb₂Se₃) nanoflake-based nitrogen dioxide (NO₂) sensors exhibit a progressive bifunctional gas-sensing performance, with a rapid alarm for hazardous highly concentrated gases, and an advanced memory-type function for low-concentration (<1 ppm) monitoring repeated under potentially fatal exposure. Rectangular and cuboid shaped Sb₂Se₃ nanoflakes, comprising van der Waals planes with large surface areas and covalent bond planes with small areas, can rapidly detect a wide range of NO₂ gas concentrations from 0.1 to 100 ppm. These Sb₂Se₃ nanoflakes are found to be suitable for physisorption-based gas sensing owing to their anisotropic quasi-2D crystal structure with extremely enlarged van der Waals planes, where they are humidity-insensitive and consequently exhibit an extremely stable baseline current. The Sb₂Se₃ nanoflake sensor exhibits a room-temperature/low-voltage operation, which is noticeable owing to its low energy consumption and rapid response even under a NO₂ gas flow of only 1 ppm. As a result, the Sb₂Se₃ nanoflake sensor is suitable for the development of a rapid alarm system. Furthermore, the persistent gas-sensing conductivity of the sensor with a slow decaying current can enable the development of a progressive memory-type sensor that retains the previous signal under irregular gas injection at low concentrations.     

从铅阳极泥处理后的渣料中综合回收有价金属的生产实践

叙述了从铅阳极泥回收金银后的渣料中综合回收有价金属的生产实践。根据渣料性质，将火法和湿法工艺相互结合，使渣料中的锑、铋、金、银、铅、铜得以较彻底的分离和回收。     

胶体五氧化二锑研究现状及发展方向

对胶体五乳化二锑的研究现状进行了回顾，详细概述了胶体五乳化二锑的各种制备方法及其特点和适用范围，讨论了两种成胶理论。针对目前存在的问题，对胶体五乳化二锑的研究方向及研究重点提出了几点建议。     

溶胶–凝胶法制备ATO-SiO_2抗静电复合薄膜的特性研究

采用两步溶胶–凝胶法制备出 ATO(掺锑氧化锡)-SiO_2复合抗静电薄膜。通过 DTA-TG、XRD、SEM 对 薄膜的结构和形貌进行了表征,结果表明:抗静电复合薄膜表面均匀致密。薄膜中 SiO_2为无定形结构,ATO 的衍射峰 与 SnO_2一致。研究了 SnO_2的含量对薄膜导电性能、结合强度和透过率的影响,发现随 SnO_2含量增加 ?(SnO_2/ SiO_2)从 5 至 12.5,薄膜的表面电阻降低(从 1010ù/□降低到 108ù/□),薄膜的结合强度下降,薄膜的透过率降低(从 89.0%降至 84.2%),结合三方面性能,得出最佳 SnO_2的配比为:?(SnO_2/ SiO_2)=10。     

火焰原子吸收光谱法测量污水中锑量的测量不确定度评定

通过火焰原子吸收光谱法对水中的锑量进行了测定,对影响测量结果的不确定度分量进行了量化的计算,从而得出影响锑量测量不确定的主要因素是测量样品消解液中的锑的质量浓度引起的不确定度.     

锡或锑在无取向电工钢中的研究进展

近年来,在节能减排背景之下,国内外众多研究者对无取向电工钢磁性能的提升做了大量研究。为了探索无取向电工钢磁性能提升的方法,对锡或锑对无取向电工钢磁性能的作用机制(晶粒尺寸和晶体织构的控制)进行分析。基于该作用机制,介绍锡或锑的添加对无取向电工钢磁性能的影响。经研究发现,适量的锡或锑在晶界偏聚,不会阻碍晶界的移动并且致使晶粒尺寸降低;与此同时,锡或锑在晶界偏聚不仅抑制{111}织构在原始晶界处形核及生长,还降低(100)晶粒表面能,促进(100)晶粒生长。因此,适量添加锡或锑,可使无取向电工钢铁损下降、磁感提升。最后结合生产工艺,建议无取向电工钢的研究方向应为稀土含量对高牌号无取向硅钢夹杂物尺寸和数量分布的影响,锡或锑的添加量和常化工艺参数(常化时间、常化温度)对常化晶粒尺寸的影响。     

电感耦合等离子体原子发射光谱法测定云南某矿山锑矿选矿流程样品中锑

锑在现代工业体系中占有重要地位,快速准确测定锑矿中锑含量对锑矿的采选具有重要指导意义。云南某矿山锑矿以萤石为主要伴生矿,现有的盐酸、硝酸、氢氟酸和高氯酸混酸体系无法彻底分解样品,而采用碱熔处理流程长且引入大量基体,均无法满足准确快速测定的要求。选择硫酸-氢氟酸混酸体系分解样品,再用酒石酸-盐酸混合溶液加热浸取,锑完全溶解于溶液中,选择Sb 206.833{463}nm为分析谱线,使用电感耦合等离子体原子发射光谱法(ICP-AES)测定锑。结果表明,锑的质量浓度在5.0～80 μg/mL范围内与其发射强度呈良好的线性关系,校准曲线线性相关系数r=0.999 8;方法的检出限为0.012 μg/mL。按照实验方法对锑矿石成分分析标准物质和锑矿选矿流程样品中锑进行测定,结果的相对标准偏差(RSD,n=5)为0.71%～5.7%;标准物质的认定值和测定值相一致;锑矿选矿流程样品中锑的加标回收率为97%～102%,满足国家地质矿产行业标准DZ/T 0130—2006的要求。     

Formation of Zinc–Antimony-Based Spinel Phases

Formation of spinel phases in ZnO–Sb₂O₃and ZnO–Sb₂O₃–Bi₂O₃systems is studied by the use of X-ray diffraction. The formation of nonstoichiometric Zn_2.33Sb_0.67O₄phase is observed in both the systems at ∼900°C. However, in these systems, at higher temperatures ( T ≥ 1100°C), formation of the inverse spinel phase Zn₇Sb₂O₁₂is observed. The study has been extended to understand the effect of CrO₃doping on the stability of the different spinel phases in the previously mentioned systems. Interestingly, in both the systems, samples doped with CrO₃, displayed the presence of Zn_2.33Sb_0.67O₄phase <1200°C, indicating the stabilization of the spinel phase by CrO₃.     

Antimony Solubility and Speciation in Aqueous Sulphuric Acid Solutions at 298 K

This work is an experimental and theoretical study of antimony speciation and the solubility of Sb₂O₅, Sb₂O₃ and Sb₂(SO₄)₃ at 298 K in aqueous sulphuric acid solutions (0 to 6 kmol/m³). A thermodynamic model was developed to quantify the solubility products and aqueous metal speciation. Main dissolved species were H₃SbO_3(aq) and H₃SbO_4(aq). The solubility of antimony increases with increasing solution acidity and with the presence of hydrogen peroxide in the solution. The following standard equilibrium constants at 298 K were obtained: Log K⁰_(Sb2O5) = 11.7±0.5, Log K⁰_(Sb2O3) = 32±1, and Log K⁰_(Sb2(SO4)3) = 55±2.     

Possible effects of site isolation in antimony oxide-modified vanadia/titania catalysts for selective oxidation of o-xylene

Titania-supported vanadia catalysts were modified by addition of antimony oxide for application in o-xylene selective oxidation to phthalic anhydride. It was shown that active and selective catalysts can be prepared by ball-milling mixtures of powders of TiO₂, V₂O₅and Sb₂O₃followed by calcination. X-ray photoelectron spectroscopy proves the formation of highly dispersed overlayers of vanadium oxide and antimony oxide, in which V⁵⁺is partially reduced to lower oxidation states and Sb³⁺is partially oxidized to Sb⁵⁺. Antimony oxide segregated into the outermost surface layers. It is therefore inferred that the presence of the antimony oxide modifier spatially separates V–O species and leads to site isolation which may be responsible for the positive effect of the modifier for the catalyst's selectivity.