低品位硼矿的富集加工技术

报道了青海大柴旦地区低品位硼矿富集加工的新工艺，该工艺使硼矿品位30％－35％，B2O3收率大于80％，该工艺路线已工业化。     

大冶诺兰达炉渣选矿的研究与实践

对影响炉渣选矿指标的主要工艺因素作了较详细的分析。并对炉渣处理的一些工艺措施做了改进，提出了用粗颗粒充气式浅槽浮选和炉渣冷却等工艺。结果表明：铜、铁、金、银得到进一步回收，达到了预期效果。     

GL—2型Φ600mm螺旋选别攀枝花钛铁矿生产实践

攀矿选钛厂设计采用传统的螺旋选矿设备ＦＬＸ一１型φ６００ｍｍ螺旋选矿机和φ１２００ｍｍ螺旋溜槽，从选矿（铁）厂磁选尾矿物料中回收原生粒状钛铁矿积累了多年生产实践经验。而广东有色金属研究院研制的ＧＬ一２型φ６００ｍｍ螺旋选矿机具有处理能力大、分选效率高、选别粒级宽、不需冲洗水及占地面积小等特点，有取代选钛厂目前使用的螺旋选矿设备之趋势。     

关于砂金工艺矿物学研究规范化的建议

本文从样品的采集、加工、制备到砂金性状、矿砂物质组成;从分离、鉴定质量要求到选矿产品考察;从矿砂可洗性、可选性评价到矿砂工艺类型确定等项内容的系统化、标准化,阐述了砂金工艺矿物学的研究规范。     

Investigation into Displacement of Placer Gold Particles

The experimental research in displacement of gold particles in washed-out thickness of sand-gravel layer is conducted. The parameters of ability of gold particles to migrate in pulp flow are determined, and their immersion into loose soil is investigated.     

铜冶炼渣尾矿综合利用现状及研究

铜冶炼炉渣含有大量的有价金属元素,经过选矿工艺处理后,大部分铜被回收,选出的渣精矿返回熔炼炉,渣尾矿外售至水泥厂,尾矿中有价金属仍存在较大利用价值,在现有工艺流程后增加磁选工艺,磁选后的铁精粉用作炼钢配料,尾矿外售。主要介绍了熔炼渣及尾矿成分,现有工艺尾矿处理方式,新工艺的应用及实践。     

电感耦合等离子体原子发射光谱法测定云南某矿山锑矿选矿流程样品中锑

锑在现代工业体系中占有重要地位,快速准确测定锑矿中锑含量对锑矿的采选具有重要指导意义。云南某矿山锑矿以萤石为主要伴生矿,现有的盐酸、硝酸、氢氟酸和高氯酸混酸体系无法彻底分解样品,而采用碱熔处理流程长且引入大量基体,均无法满足准确快速测定的要求。选择硫酸-氢氟酸混酸体系分解样品,再用酒石酸-盐酸混合溶液加热浸取,锑完全溶解于溶液中,选择Sb 206.833{463}nm为分析谱线,使用电感耦合等离子体原子发射光谱法(ICP-AES)测定锑。结果表明,锑的质量浓度在5.0～80 μg/mL范围内与其发射强度呈良好的线性关系,校准曲线线性相关系数r=0.999 8;方法的检出限为0.012 μg/mL。按照实验方法对锑矿石成分分析标准物质和锑矿选矿流程样品中锑进行测定,结果的相对标准偏差(RSD,n=5)为0.71%～5.7%;标准物质的认定值和测定值相一致;锑矿选矿流程样品中锑的加标回收率为97%～102%,满足国家地质矿产行业标准DZ/T 0130—2006的要求。     

Processing of an East Mediterranean phosphate ore sample by an integrated attrition scrubbing/classification scheme (part one)

ABSTRACT

In this study, an Egyptian siliceous/calcareous sedimentary phosphorite was subjected to beneficiation by unsophisticated economic means. The mineralogical and chemical examination showed that the ore sample is a typical example for the East Mediterranean phosphorites with 21.80% P₂O₅, 10.93% acid insoluble and 16.61% loss on ignition. The primary crushed sample was classified into three size fractions without any milling and they were separately subjected to an integrated attrition scrubbing study. Screening and classification on the 2.30 mm and 0.071 mm sieves were sequentially introduced with the attrition process. The effect of solid%, attrition speed and time were studied and optimized for each size fraction. Results showed that three products were produced and could be categorized according to their P₂O₅ content into the coarse tailing (+2.30 mm), the attrition concentrate (?2.30 + 0.071 mm) and the phosphate fines (?0.071 mm). The P₂O₅ contents of these products reached 12.24%, 28.72% and 18.77%, with P₂O₅ distribution reached 6.74%, 51.75% and 41.51%, respectively. A global P₂O₅ of 28.72% was obtained with a recovery of about 52%. A tentative flow-sheet for the whole process was postulated.     

煤与单一矿物质在摩擦电选过程中的分离

摩擦电选能够有效分选粒度小于74μm的微粉煤,为了探索煤中矿物质在摩擦电选过程中的分离规律,将净煤(ρ1.3g/cm3)与煤中常见伴生矿物质如石英、高岭土、黄铁矿、方解石等分别按照一定比例混合,进行摩擦电选研究,并对各组精煤产品进行了X射线荧光光谱分析.试验结果表明:4种矿物质都可以通过摩擦电选方法有效脱除,方解石、石英、黄铁矿和高岭土的脱除率可分别达74.871%,82.608%,96.169%,94.986%.     

Chemical beneficiation of coal with aqueous hydrogen peroxide/sulphuric acid solutions

The removal of sulphur and ash from coal treated with aqueous hydrogen peroxide/sulphuric acid solutions has been studied at ambient temperature, under a variety of experimental conditions. Almost complete elimination of the sulphate and the pyritic sulphur was observed in most cases, as well as substantial reduction in the ash content. The other components of the organic coal matrix were not affected to a significant extent, indicating high selectivity of the $\text{H}{}_2\text{O}{}_2\text{H}{}_2\text{SO4}$ system towards sulphur oxidation. An optimal H₂SO₄ concentration was established, above which the acid was found to have an adverse effect on the oxidation of pyrite by hydrogen peroxide.