金属管式换热器在气烧石灰竖窑上的应用

气烧石灰竖窑针对窑型产能较低、能耗较高的弊端,韶钢在新建气烧石灰竖窑上采用的双预热技术,使窑的产量提高47.5％,活性度提高每10min在20ml以上,能耗降低35.62％,经济效益明显.     

燃烧—气体容量法测定冶金石灰中的二氧化碳

冶金石灰是石灰石经过工业煅烧的产品。其二氧化碳含量低，且经过高温煅烧后基本不含有机物。无需按照《石灰石、白云石化学分析国家标准中二氧化碳的化学分析方法》中用酸进行试样分解，只需在1200℃高温中灼烧，使石灰中残留的或煅烧后吸收空气中二氧化碳而形成的碳酸盐分解，象通常测定含碳耐火材料中二氧化碳那样，采用气体容量法进行测定。     

机械化竖窑技术和节能特性简介

鞍钢耐火公司新建两座430m^3机械化石灰竖窑，与普通窑炉相比具有热耗低、石灰活性高、燃料适应性强、结构简单的特点。     

光敏丝室探测器PET的触发判选处理器

介绍了为光敏丝室探测器PET而设计的触发判选处理器（TRIG）的结构和原理，该处理器具有触发判选，计数率损失测量，随机符合事例率测量，探测器分区计数统计以及系统定标等多项功能，由于应用了EPLD技术和流水线作业等技术，实现了TRIG系统的高集成度和高性能 。     

试论安定性不合格消石灰对柔性路面质量的影响

由于过烧石灰的存在和消解不当等原因，造成消石灰安定性不合格，当石灰稳定类路面结构成型或投入使用后，消石灰中的生石灰颗粒开始吸收周围水分，慢慢消解，消解过程中发生体积膨胀，对路面产生破坏。解决石灰安定性问题对防止公路前修后坏，延长路面使用寿命具有积极的现实意义。     

电弧炉采用石灰石单渣冶炼工艺的研究

采用优质石灰石取代质量差的白灰 ,进行了单渣电弧炉熔炼。结果表明 ,钢水成本降低 ,钢水质量提高 ,取得了良好的效果。     

大跨度钢桁架桥的施工与实践

介绍了天生桥一级水电站引水道进水塔大跨度钢桁架桥施工的全过程，包括制作，运输、安装、试验等几个部分，以供类似工程施工参考。     

Acidity in upland and hill soils: Cation exchange capacity,pH and lime requirement

For 30 acid upland and hill soils, with initial pH from 3.5 to 5.8, and loss on ignition from 14% to 94%, cation exchange capacity varied with pH according to the relationship CEC = m pH+C, where m and C are characteristic of each soil. The slope m depended on loss on ignition (LOI), and is given by: m=Δ CEC/Δ=0.22 LOI+1.92. Because of these relationships, CEC measured at the natural pH of the soil (in 0.025 M MgSO₄ solution) is more relevant to field conditions than a conventional measurement at pH7. An improved method for estimating lime requirement (LR) of these soils was developed, based on the relationship found between LR and the difference in CEC (ΔCEC) between that at the natural pH of the soil and that at the target pH of 5.5: LR=1.12 ΔCEC+1.48. Lime requirement can therefore also be estimated from loss on ignition using the earlier relationships, and is given by: LR=(0.25 LOI+2.15) Δ+1.48, where Δ is the difference between the natural pH (in 0.025 M MgSO₄) and the target pH. Predictions based on this agreed well with results for a further 10 soils.     

Biofiltration of toluene in the absence and the presence of ethyl acetate under continuous and intermittent loading

BACKGROUND: Two peat biofilters were used for the removal of toluene from air for one year. One biofilter was fed with pure toluene and the other received 1:1 (by weight) ethyl acetate:toluene mixture. RESULTS: The biofilters were operated under continuous loading: the toluene inlet load (IL) at which 80% removal occurred was 116 g m^?3 h^?1 at 57 s gas residence time. Maximum elimination capacity of 360 g m^?3 h^?1 was obtained at an IL of 745 g m^?3 h^?1. The elimination of toluene was inhibited by the presence of ethyl acetate. Intermittent loading, with pollutants supplied for 16 h/day, 5 days/week, did not significantly affect the removal efficiency (RE). Biomass was fully activated in 2 h after night closures, but 6 h were required to recover RE after weekend closures. Live cell density remained relatively constant over the operational period, while the dead cell fraction increased. Finally, a 15 day starvation period was applied and operation then re‐started. Performance was restored with similar re‐acclimatization period to that after weekend closures, and a reduction in dead cell fraction was observed. CONCLUSION: This study demonstrates the capacity of the system to handle intermittent loading conditions that are common in industrial practices, including long‐term starvation. Copyright © 2008 Society of Chemical Industry     

一种T形高压输电线路故障测距新方法

对T形线路的故障测距，现有方法都是先判断故障支路，再将3端线路等效成2端线路进行测距。但在 T节点附近短路，尤其是经高阻短路时，现有的测距方法由于无法正确判别故障支路而存在一定范围的测距死区。针对上述缺陷，分别假设故障发生在某一支路，由假定正常的2段支路端的电压、电流推算求得 T节点电压和注入假定故障支路的电流，从而分别求得3个故障距离。经证明，求得的3个故障距离有且仅有1个在0和对应支路总长度之间，该距离就是真实的故障距离，故障发生在对应支路上。该方法无需事先判别故障支路即可测距，在 T节点附近经高阻故障时无测距死区。其测距精度理论上不受过渡电阻和故障类型影响，无需故障前数据，且对滤波无高要求。EMTP仿真结果表明该方法正确、有效，测距精度高。