Microstructural and electrical changes in Ca0.9R0.1CeNbMoO8 (R = Y,Sm, Nd,La) ceramics induced by rare-earth ion doping

Rare-earth ions doped Ca_0.9R_0.1CeNbMoO₈ (R = Y, Sm, Nd, La) ceramics have been successfully prepared by solid-state method, and their modifications to the microstructure and electrical properties are also investigated. The rare-earth ions doped ceramics exhibit the scheelite structure. With the increase in the radius of rare-earth ions, the lattice distortion and bond interaction will be enhanced, and the consistency of grain size will be reduced. The ceramics exhibit negative temperature coefficient (NTC) thermistor characteristics in the temperature range of 473 K-1273 K, and the activation energy decreases with the increase of the radius of rare-earth ions. Rare-earth ions doping can increase the content of Ce³⁺ ions and promote the conductivity of ceramics. Except for Sm³⁺-doped ceramics, the high-temperature aging rate of other ceramics is less than 2%. The existence of some metastable Sm²⁺ ions in Sm³⁺-doped ceramics not only increases the activation energy, but also reduces the high-temperature stability of the ceramics.     

Corrosion behaviour of AA2024 aluminium alloy in different tempers in NaCl solution and with the CeCl3 corrosion inhibitor

The paper analyses the corrosion behaviour of naturally and artificially aged AA2024 alloy in NaCl solution and in the presence of an environment-friendly corrosion inhibitor, CeCl₃. On the basis of the values of polarisation resistance and corrosion current density, the corrosion resistance of the protective inhibitor film is established as well as the general corrosion resistance of this aluminium alloy. Resistance to pit formation is determined based on the difference in pitting and corrosion potentials while resistance to pit growth is determined based on the amount of charge consumed during pit growth. A scanning electron microscope is used to examine the morphology of the pits formed during the pitting corrosion testing, as well as to determine the cerium content on intermetallic particles and the matrix AA2024 alloy. The corrosion behaviour of AA2024 alloy is investigated after different test periods in NaCl solution and in the same solution with the CeCl₃ inhibitor. The corrosion resistance of both tempers of AA2024 alloy is more than one order of magnitude higher in the presence of CeCl₃. An explanation of the observed differences in the corrosion behaviour of the naturally and artificially aged AA2024 alloy is proposed. Different corrosion behaviour of the alloy after different test periods is also explained.     

Rare earth oxides as carbon oxidation catalysts

The behavior of a number of rare earth oxides as catalysts for the oxidation of graphite in air has been investigated by the methods of thermal analysis. Of the oxides studied, only CeO₂ showed significant activity in accelerating the gasification of graphite by oxygen between 500 and 1000°C. Cerium salts, which decompose to a finely dispersed oxide phase at low temperatures, e.g. Ce (III) nitrate and ammonium Ce (IV) nitrate, were found to be very active catalysts. The catalytic effect may be due to a redox process involving the cyclic conversion of the oxide from the Ce (IV) to the Ce (III) oxidation state, or the oxide particles may provide sites for the dissociative chemisorption of oxygen.     

Corrosion Inhibition Mechanism with Spilt Cell Technique of Rare Earth Metal on LC4 Al Alloy

A new method of studying the corrosion inhibition mechanism of rare earth metal(REM) on LC4 Al alloy with the spilt cell technique was studied. The principle and experimental method of the spilt cell technique were analyzed. By measuring the change of net-electric current between the two electrodes caused by the change of the amount of oxygen in the solution and the addition of CeCl₃, the influence of corrosive performance of CeCl₃ on LC4 super-power aluminum alloy in the 0.1 mol·L⁻¹ NaCl solution was investigated. Meanwhile, the conditional changes of pH values, CeCl₃ solution, additire and time of performance were also studied. Finally, the features of electrode surface were revealed by using SEM and X-ray energy-dispersive spectrometry (EDS). By combining these with other electric chemical techniques, such as potential-time curve, polarization curve et al.     

新型香料苹果酯-B的合成

以硫酸高铈为催化剂,通过乙酰乙酸乙酯和1,2-丙二醇反应合成了苹果酯-B,研究了各有关因素对产品收率的影响。实验表明,硫酸高铈是合成苹果酯-B的良好催化剂,在酯醇物质的量比为1∶1.25、催化剂用量为0.3g/0.1mol乙酰乙酸乙酯、环己烷10mL、反应时间2h的条件下,苹果酯-B的收率可达91.5%。     

铈和磷对中碳锰钢低温回火脆性的影响

本文采用冲击试验和断口扫描电镜，俄歇谱分析等方法，研究了铈对不同磷含量的中碳锰钢低温回火脆性的影响。结果表明，磷在奥氏体晶界偏聚是导致含磷锰钢产生低温回火脆性的原因，而铈的加入，可减少磷的偏聚程度，增加回火马氏体的冲击值，从而降低中碳锰钢的回火脆性。     

Structural properties of inorganic materials: tungsten bronze SBN ceramics

Rare-earth doped strontium barium niobates were synthesized using usual ceramic technique. The dopants are La, Ce, Gd, Sm and Nd. The materials were characterized by XRD and density measurements. The grain sizes were determined from SEM analysis. Lattice parameters changed uniformly with rare-earth dopants in unfilled structures. Density measurements and SEM analysis confirmed only minute changes in the densities of the ceramics.     

新型长余辉稀土发光材料发光特性探讨

本文对新型长余辉稀土发光材料在不同照度 ,不同激发时间等多种条件下的发光特性进行了检测 ,并对检测结果进行了分析讨论。     

Superconductivity and magnetism in niobium doped YBa2Cu3O7 Related high Tc ceramics

Magnetic characterization has been performed on the members of the cuprateniobate RBa₂Cu₂NbO₈ (R = Pr, Nd, and La) series and R_1.5Ce_0.5Sr₂Cu₂NbO₁₀ (R = Pr, Eu, Nd, and Sm) series. The PrBCNO samples show a signature in the magnetization of a magnetic ordering at 12K. The PrCSCNO sample is nonsuperconducting and shows two distinct orderings at 17K and 53K. No such magnetic phase transition is observed down to 2K in the Nd and La based RBCNO materials or the Nd, Sm, and Eu based RCSCNO materials. Measurements of the lower critical field curve, dc irreversibility line, and critical curent densities are reported for each of the superconducting NdCSCNO, SmCSCNO, and EuCSCNO compounds.     

New Environment-Friendly Approach for Bastnasite Metallurgic Treatment (I): Extraction of Tetravalent Cerium from Sulphuric Acid Medium with Di(2-ethylhexyl) Phosphoric Acid

Bastnasiteisamainsourceofrareearthproducts inwhichCeO2/REOisabout50%.Atpresent,a cidity leachingcombinedwithalkali conversion method[1]iscommonlyusedinthebastnasitetreat ment.Thismethodisunfriendlytotheenvironment becausetheradioactiveelementofthoriuman…