Effects of high-pressure-modified soy 11S globulin on the gel properties and water-holding capacity of pork batter

The effects of high-pressure-modified soy 11S globulin (0.1, 200, and 400 MPa) on the gel properties, water-holding capacity, and water mobility of pork batter were investigated. The high-pressure-modified soy 11S globulin significantly increased (P < 0.05) the emulsion stability, cooking yield, hardness, springiness, chewiness, resilience, cohesiveness, the a^* and b^* values, and the G′ and G′′ values of pork batter at 80 °C, compared with those of 0.1 MPa-modified globulin. In contrast, the centrifugal loss and initial relaxation time of T_2b, T₂₁, and T₂₂ significantly decreased (P < 0.05). Meanwhile, the microstructure was denser, and the voids were smaller and more uniform compared with those of 0.1 MPa-modified globulin. In addition, the sample with 11S globulin modified at 400 MPa had the best water-holding capacity, gel structure, and gel properties among the samples. Overall, the use of high-pressure-modified soy 11S globulin improved the gel properties and water-holding capacity of pork batter, especially under 400 MPa.     

Interfacial microstructure and mechanical properties of Ti3SiC2 ceramic and TC11 alloy joint diffusion bonded with a Cu interlayer

Reliable joints of Ti₃SiC₂ ceramic and TC11 alloy were diffusion bonded with a 50 μm thick Cu interlayer. The typical interfacial structure of the diffusion boned joint, which was dependent on the interdiffusion and chemical reactions between Al, Si and Ti atoms from the base materials and Cu interlayer, was TC11/α-Ti + β-Ti + Ti₂Cu + TiCu/Ti₅Si₄ + TiSiCu/Cu(s, s)/Ti₃SiC₂. The influence of bonding temperature and time on the interfacial structure and mechanical properties of Ti₃SiC₂/Cu/TC11 joint was analyzed. With the increase of bonding temperature and time, the joint shear strength was gradually increased due to enhanced atomic diffusion. However, the thickness of Ti₅Si₄ and TiSiCu layers with high microhardness increased for a long holding time, resulting in the reduction of bonding strength. The maximum shear strength of 251 ± 6 MPa was obtained for the joint diffusion bonded at 850 °C for 60 min, and fracture primarily occurred at the diffusion layer adjacent to the Ti₃SiC₂ substrate. This work provided an economical and convenient solution for broadening the engineering application of Ti₃SiC₂ ceramic.     

Apparent power-law distributions in animal movements can arise from intraspecific interactions

Lévy flights have gained prominence for analysis of animal movement. In a Lévy flight, step-lengths are drawn from a heavy-tailed distribution such as a power law (PL), and a large number of empirical demonstrations have been published. Others, however, have suggested that animal movement is ill fit by PL distributions or contend a state-switching process better explains apparent Lévy flight movement patterns. We used a mix of direct behavioural observations and GPS tracking to understand step-length patterns in females of two related butterflies. We initially found movement in one species (Euphydryas editha taylori) was best fit by a bounded PL, evidence of a Lévy flight, while the other (Euphydryas phaeton) was best fit by an exponential distribution. Subsequent analyses introduced additional candidate models and used behavioural observations to sort steps based on intraspecific interactions (interactions were rare in E. phaeton but common in E. e. taylori). These analyses showed a mixed-exponential is favoured over the bounded PL for E. e. taylori and that when step-lengths were sorted into states based on the influence of harassing conspecific males, both states were best fit by simple exponential distributions. The direct behavioural observations allowed us to infer the underlying behavioural mechanism is a state-switching process driven by intraspecific interactions rather than a Lévy flight.     

基于SAA7114H的视频图象采集系统的设计

介绍一种高度集成并具有广泛通用性的视频图象信号采集系统。系统的开发采用了功能强大的视频解码芯片SAA7114H和可编程逻辑门阵列器件(FPGA)，并考虑了在线编程的模式。文中给出了YUV色彩空间与RGB色彩空间的转换公式，经验证效果很好。在实际应用中，该系统作为前端图象采集部分取得了良好的效果。     

卷积码的线性系统

介绍了卷积码的线性离散时不变系统模型。从建立卷积码的状态变量方程出发,研究了卷积码的代数结构,并详细论述了基于状态变量方程描述的迭代译码算法。     

嵌入式数字智能涡街流量计的设计开发

针对目前涡街流重计存在精度不高的问题，采用Toeplitz自相关矩阵近似的准牛顿算法，对涡街传感器输出信号进行数字信号处理。针对客户超低功耗的要求，开发设计以超低功耗的混合信号处理器(MSP430F149)为微处理器，以采用KS0713为控制器的LCD为液晶显示模块，符合HART总线协议的嵌入式智能涡街流量计。     

Fixed-order H∞ compensator design

A method is presented for the construction of fixed-order compensators to provide H_∞ norm constraint for linear control systems with exogenous disturbances. The method is based on the celebrated bounded-real lemma that predicates the H_∞ norm constraint via a Riccati inequality. The synthesis of fixed-order controllers whose dimensions are less than the order of a given plant, is demonstrated by a set of sufficient conditions along with a numerical algorithm.     

H∞-control with measurement-feedback for Pritchard-Salamon systems

In this paper we extend the finite-dimensional results for the H_∞-control problem with measurement-feedback to a large class of infinite-dimensional systems, allowing for a certain type of unboundedness in the input and output operators (the Pritchard-Salamon class). The main result of the paper relates the solvability to the suboptimal H_∞-control problem to the existence of stabilizing solutions to certain operator Riccati equations. Furthermore, a characterization of all suboptimal controllers is given.     

堇青石基玻璃陶瓷的制备与展望

介绍了制备堇青石基玻璃陶瓷的三种方法：熔融法、烧结法和溶胶-凝胶法，综述了玻璃组成、添加剂和成核剂对堇青石基玻璃陶瓷的烧结及性能的影响，并对其未来的发展进行了展望。     

The new intra-urban dynamics: Suburbanisation and functional specialisation in French cities

This article examines the relationships between the employment suburbanisation from central cities towards their suburbs, and the process of intra-urban specialisation that occurred simultaneously in the fifty largest French metropolitan areas. A methodology is proposed to identify urban subcentres and to analyse the effects of the intra-urban specialisations on suburbanisation patterns. We conclude that the specialisation of both subcentres and central cities has a significant effect on suburbanisation rates. Lastly, an intra-metropolitan shift/share analysis provides additional insights into the employment dynamics of central cities and suburbs during the last twenty years. Received: 25 July 2000 / Accepted: 29 May 2001