储层泥浆侵入深度预测方法研究

泥浆侵入半径的确定尚缺乏严格的验证标准.以油水两相渗流理论和离子扩散方程为基础,结合储集层特点,研究了不同储层参数下泥浆滤液对地层的侵入特性.数值模拟侵入时间选取10 d和20 d.数值模拟结果表明,侵入半径在渗透率不变的情况下随孔隙度的增大而减小,在孔隙度不变的情况下随渗透率的增大而增大;当渗透率和孔隙度都发生变化时,泥浆侵入半径一般随孔隙度的增加呈幂函数增加.依据这种关系对测井资料约束处理,得到的泥浆侵入半径较客观地反映了地层的真实情况.     

弹性-粘弹性复合结构随机响应的各阶谱矩的计算方法

提出了一种新的计算弹性-粘弹性复合结构随机响应的各阶谱矩的计算方法，它是一种时域复模态分析方法。利用此方法获得了弹性-粘弹性复合结构在白噪声、滤过白噪声等典型平稳随机激励下随机响应的各阶谱矩的解析表达式，分析了粘弹性对各阶谱矩的影响。此计算方法简便、易用，无论单自由度或多自由度系统均适用，为进一步研究弹性-粘弹性复合结构在随机激励下的可靠性打下良好基础。     

吐丝圈径对大规格高碳盘条组织性能的影响

计算与分析了斯太尔摩冷线上盘条的吐丝圈径、搭接密度及"佳灵"装置横向布风曲线之间的关系,研究了吐丝圈径的大小对大规格82B盘条组织和性能的影响,确定了大规格82B盘条最小吐丝圈径应为980mm.     

Salt-water up-coning during extraction of fresh water from a tropical island

Rainwater can collect in a lens-shaped region within the rock of a tropical island, and may be separated from the underlying salt water by a sharp interface. This paper presents a nonlinear theory for determining the shape of this interface. The island is assumed to be saturated with rain, and provision is made for the outflow of rain-water through the sides of the island. The effect of a bore well on the shape of the interface is investigated, and the problem is solved using a spectral method. An integral-equation method is also presented for the case when the island has infinite width.     

Influence of protein and lipid concentration of the test lubricant on the wear of ultra high molecular weight polyethylene

To gain a better understanding of the ultra-high molecular weight polyethylene (UHMWPE) wear mechanism in the physiological environment, the effects of protein and lipid constituents of synovial fluid on the specific wear rate of UHMWPE were examined experimentally. The multidirectional sliding pin-on-plate wear tester was employed to simulate the simplified sliding condition of hip joint prostheses. Bovine serum γ-globulin and synthetic l--DPPC were used as model protein and lipid constituents of synovia, respectively. Results of the wear test indicated that the UHMWPE wear rate primarily depended on the protein concentration of the test lubricant. Lipids acted as a boundary lubricant and reduced polyethylene wear in the low protein lubricants. However, the polyethylene wear rate increased with increasing lipid concentrations if the protein concentration was within the physiological level. Increased interactions between protein and lipid molecules and lipid diffusion to polyethylene surface might be responsible for the increased wear.     

Bootstrapping the Local Periodogram of Locally Stationary Processes

Abstract. Locally stationary processes are non‐stationary stochastic processes the second‐order structure of which varies smoothly over time. In this paper, we develop a method to bootstrap the local periodogram of a locally stationary process. Our method generates pseudo local periodogram ordinates by combining a parametric time and non‐parametric frequency domain bootstrap approach. We first fit locally a time varying autoregressive model so as to capture the essential characteristics of the underlying process. A locally calculated non‐parametric correction in the frequency domain is then used so as to improve upon the locally parametric autoregressive fit. As an application, we investigate theoretically the asymptotic properties of the bootstrap method proposed applied to the class of local spectral means, local ratio statistics and local spectral density estimators. Some simulations demonstrate the ability of our method to give accurate estimates of the quantities of interest in finite sample situations and an application to a real‐life data‐set is presented.     

Boiling: Size Distribution of Bubbles as Demanded by the Principle of Maximum Information

The principle of maximum informational entropy is used to find the probability density function for the departure radius of a bubble in boiling on a solid surface. A general relation is derived, which leads to particular expressions.     

关于彩色火焰蜡烛的研制

本文阐述了利用焰色反应的原理研制彩色火焰蜡烛，着重分析并解决了在研制工作中出现的几个技术关键，如主燃剂的选取、蜡烛成型和强度、发色剂的选择与用量等．     

Comments on the shortcomings of predicting the precision of Cavalieri volume estimates based upon assumed measurement functions

It is well known that the estimation of an object's volume by means of serial cross-sections, the so-called Cavalieri method, yields an unbiased estimate. But by itself it provides no means by which to estimate how precise this estimate is unless the shape of the volume is fully known beforehand. This knowledge can only be partially determined from the serial section information that is collected. Methods have been developed that claim to surmount this difficulty by using the serial section data to create a mathematical model of the volume's shape properties. The model then is used to estimate (predict) the precision of the volume estimate (its CE) from the single set of data available. Unfortunately, the theory underlying the model is flawed and so the model itself amounts to no more than an unsubstantiated guess about the shape of the volume. Therefore, the precision of the volume estimates that one obtains from the method is only as good as the model and this cannot be ascertained from the single set of acquired data. In this letter I explain the inadequacies of the modelling method. I suggest that it be used only with caution, if at all. Instead I suggest two alternative ways to predict the CE, one that is based upon a rule-of-thumb approach to the object's shape, and another that is based upon spectral analysis of the measurement function and that is easy to implement with available computer software.     

Variations in Spectral Slope in Lake Taihu,a Large Subtropical Shallow Lake in China

Spectral slope (S), describing the exponential decrease of the absorption spectrum over a given wavelength range, is an important parameter in the study of of chromophoric dissolved organic matter (CDOM) dynamics, and also an essential input parameter in remote sensing models. Furthermore, S is often used as a proxy for CDOM composition, including the ratio of fulvic to humic acids and molecular weight. The relative broad range in S values reported in the literature can be explained by the different spectral ranges and fitting methods used. A single exponential model is used to fit the S values for 17 investigations involving 458 samples in Lake Taihu from January to October in 2004. The average S value was 15.18 ± 1.39 μm⁻¹ for the range of 280–500 nm, which fell within the range reported in the literature. The frequency distribution of S value basically obeyed a normal distribution. Significant differences in S values between summer and other seasons showed that phytoplankton degradation was one of the important sources of CDOM in summer, whereas CDOM mainly came from the river input in other seasons. Furthermore, the estimated S value decreased with increasing wavelength range used in regression. The maximum and minimum values derived from the regression were 17.89 ± 1.25 μm⁻¹ and 13.62 ± 2.11 μm⁻¹ for the wavelength ranges of 280–380 nm and 400–500 nm, respectively, a decrease of 23.9%. S values significantly decreased with the increase of CDOM absorption coefficients. CDOM absorption coefficients could be more appropriately estimated from exponential model introducing the variation of S with absorption coefficients, making them useful for a remote sensing bio-optical model of Lake Taihu. DOC-specific absorption coefficient a*(λ) and the parameter M describing molecular size of the humic molecules could also be used as a proxy for the sources and types of CDOM. A general relationship was found between S and a*(λ), and M values. S increased with the decrease of DOC-specific absorption coefficient and the increase of M corresponding to the decrease of molecular weight.