基于关键路径延时检测的自适应电压缩减技术

为了减小传统的最差情况设计方法引入的电压裕量,提出了一种变化可知的自适应电压缩减(AVS)技术,通过调整电源电压来降低电路功耗.自适应电压缩减技术基于检测关键路径的延时变化,基于此设计了一款预错误原位延时检测电路,可以检测关键路径延时并输出预错误信号,进而控制单元可根据反馈回的预错误信号的个数调整系统电压.本芯片采用SMIC180 nm工艺设计验证,仿真分析表明,采用自适应电压缩减技术后,4个目标验证电路分别节省功耗12.4％,11.3％,10.4％和11.6％.     

地震数据采集系统延迟时间研究与分析

文章分析了影响地震采集系统延迟时间的因素,并根据系统延迟的理论对产生的原因进行了论证.同时对实际生产中的测试方法进行了阐述研究和分析,提出了新的测试方法,并结合实际生产提出了合理性建议.     

SAW软扩频调制解调器的研究

报道了一种直接序列软扩频调制解调器的SAW实现方案，并给出了相应的实验结果。该方案对提高系统抗干扰能力、频宽利用等方面均具有与其他技术不同的特点。同时，该技术方案为进一步研究DS-OFDM打下了基础。     

A novel compact circuit for 4-PAM energy-efficient high speed interconnect data transmission and reception

Transmission of signals, whether on-chip or off-chip, places severe constraints on timing and extracts a large price in energy. New silicon device technologies, such as back-plane CMOS, provide a programmable and adaptable threshold voltage as an additional tool that can be used for low power design. We show that one particularly desirable use of this freedom is energy-efficient high-speed transmission across long interconnects using multi-valued encoding. Our multi-valued CMOS circuits take advantage of the threshold voltage control of the transistors, by using the signal-voltage-to-threshold-voltage span, in order to make area-efficient implementations of 4-PAM (pulse amplitude modulation) transceivers operating at high speed. In a comparison of a variety of published technologies, for signal transmission with interconnects of 10-15 mm length, we show up to 50% improvement in energy for on-chip signal transmission over binary encoding together with higher limits for operating speeds without a penalty in circuit noise margin.     

Frequency domain solution to delay-type Nehari problem

This paper generalizes the frequency-domain results on the delay-type Nehari problem in the stable case to the unstable case. The solvability condition of the delay-type Nehari problem is formulated in terms of the nonsingularity of three matrices. The optimal value γ_opt is the maximal γ∈(0,∞) such that one of the three matrices becomes singular. All sub-optimal compensators are parameterized in a transparent structure incorporating a modified Smith predictor.     

某型杀伤枪榴弹引信弹道炸原因分析及再设计思考

通过对某型杀伤枪榴弹引信所发生的三次弹道炸的原因进行分析，提出用延期索替代延期药盘，并对有关机构进行再设计的对策。     

一种简便的评定引战配合效率方法

在导弹近炸引信起爆延时具有随机性基础上，本文建立了一种用延时及其数学特征表示的评定引战配合效率的简便方法，并对有关应用问题进行了讨论。     

煤矿许用毫秒延期电雷管研究

文中对影响煤矿许用毫秒延期电雷管沼气安全性与延期时间精度的因素进行了研究。应用正交设计研制了新的延期药配方，确定了合理的雷管结构及装配工艺参数，产品性能达到ＧＢ８０３１《工业电雷管》的规定。     

Effect of cationic surfactant and inorganic anions on the electrochemical behavior of carbon steel in formation water

Corrosion behavior of carbon steel in formation water associated crude oil from Egyptian western desert was studied at various concentrations of dodecyl dimethyl ammonium chloride (CS) as a cationic surfactant. Polarization curves indicate that CS has a good inhibition efficiency for carbon steel in formation water and behaves as cathodic inhibitor. The inhibition efficiency was found to increase with increase in CS concentration until reaches a maximum constant value corresponding to the critical micelle concentration of CS and decrease with increase in solution temperature. The adsorption of CS follows the kinetic thermodynamic model and Flory-Huggins isotherm. Thermodynamic parameters obtained indicate that that the presence of the CS increases the activation energy. Polarization and Impedance measurements indicate that the addition of KI has a significant synergistic effect with CS and results in increase the inhibition efficiency of CS in formation water.     

IPv6 delay and loss performance evolution

Although packet delay and loss are two important parameters of the Internet performance, to the best of our knowledge, the evolution of large‐scale IPv6 delay and loss performance has previously not been studied. In this paper, we analyze more than 600 end‐to‐end IPv6 paths between about 26 testboxes of RIPE Network Coordination Centre over two years, and compare the delay and loss performance over time with their IPv4 counterparts. We present and discuss the measurement methodologies and show that IPv6 paths have a higher delay and loss than their IPv4 counterparts. The main reason for the worse performance stems from IPv6‐in‐IPv4 tunnels rather than from native IPv6 paths and such tunnels are still widely used today. Copyright © 2007 John Wiley & Sons, Ltd.