Toward optimization of a robust low-cost sulfonated-polyethersulfone containing layered double hydroxide for PEM fuel cells

Polyethersulphone (PES) is an aromatic thermoplastic, at low environmental impact, evaluated in this work as a promising candidate for new polymer electrolytes in the PEMFCs technology. A sulfonation procedure has been tuned in order to graft sulfonic acid groups on the polymer chains (sPES) and to make it hydrophilic. Homogeneous membranes with different polymer's sulfonation degrees (SD%) have demonstrated excellent mechanical properties and very low permeability toward methanol (important in the DMFCs), even if low proton conductivity. Nanocomposite sPES membranes were prepared by dispersion of highly hydrophilic lamellar particles such as layered double hydroxide (LDH) in the polymer. Deep investigations performed by a combination of PFG-NMR, EIS, XRD, DMA, and scanning electron microscopy have evidenced the exfoliation of the lamellae in polymer matrix. However, a certain anisotropy was evidenced both in the morphology and molecular diffusion, favored in the longitudinal direction (parallel to surface), while completely inhibited in the cross-section. This finding is most likely induced by the polymer structure, therefore particular attention must be paid to the choice of the filler and preparation of the composites. © 2019 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2019 , 136, 47884.     

浅谈在多节目码流复用与解复用中PID码的作用

文章简要阐述了PID码在多节目码流的复用与解复用中所起的作用。并运用PID码的原理来解释和解决在实际工作中碰到的PID码问题。     

FTIR-ATR studies of diffusion and perturbation of water in polyelectrolyte thin films. Part 4. Diffusion, perturbation and swelling processes for ionic solutions in SPEES/PES membranes

We report diffusion rates and equilibrium concentrations of water in a polyelectrolyte SPEES/PES film using ATR/FTIR spectroscopy. The data for water obtained by fitting spectral intensities to a dual mode diffusion model in the presence of different counter ions (at 0.2 mol dm⁻³) follow the order Li⁺>Cs⁺>Na⁺>Ca²⁺>K⁺. Diffusion is progressively slower for higher concentrations of NaCl (0.2-0.85 mol dm⁻³) and the NO₃⁻ counter anion leads to a faster diffusion rate than for Cl⁻ at the same concentration. Both water uptake and diffusion rates are broadly consistent with expectations based on the differential degrees of swelling, caused by changes in the SO₃⁻/SO₃⁻ interpolymer chain repulsive forces leading to a decrease in volume diffusion compared with the value for pure water. Direct spectral measurements of the degree of swelling confirm that the process does occur, although the order of the swelling amounts does not map directly onto that of the diffusion rates. This is probably because the interfacial dissociation processes are hydration dependent.     

聚醚砜膜原位清洗方法的实验研究

实验对已污染的聚醚砜膜进行了清洗的研究,并通过测量各种清洗剂清洗后膜水通量的恢复,确定适宜的清洗剂、清洗时间、清洗液浓度和操作压力,选择出最佳的清洗方案,取得较好的清洗效果。通过研究表明:被污染的聚醚砜膜用混合清洗剂清洗恢复率可达到85%,效果要明显优于单一的清洗方法。     

Dehydrogenation of Cyclohexene on Platinum Nanoclusters on a Thin Film of Al2O3/NiAl(100)

Using a scanning-tunneling microscope, reflection high-energy electron diffraction and photoelectron spectra with synchrotron radiation, we investigated the temperature dependence of the dehydrogenation of cyclohexene (C₆H₁₀) adsorbed on Pt nanoclusters supported on an ultra-thin film of Al₂O₃/NiAl(100). The Pt clusters, grown by vapor deposition, are structurally ordered and exhibit a mean diameter 2.2 nm and height 0.4 nm. The progress of dehydrogenation was monitored through the temporal variation of C 1s photoelectron spectra; analysis of these features revealed that the dehydrogenation of cyclohexene with increasing sample temperature occurs as a sequential process beginning around 150 K, a temperature significantly less than that for Pt single-crystal surfaces. The dehydrogenation behavior, particularly the decomposition into elemental carbon, is found to vary with Pt coverage.     

酚酞基聚芳醚砜和聚乙烯的共混研究

以聚乙烯接枝聚乙二醇(PE—g—PEO)为增容剂并用于酚酞基聚芳醚砜(PES—C)与聚乙烯(PE)共混体系。用力学性能测定等方法研究了增容剂用量、PEO加入量对PES—C与PE共混物拉伸强度的影响。结果表明.一定量的增容剂可以改善:PES—C与PE的相容性并提高PE的拉伸强度;同时.加入少量聚乙二醇(PEO).可以通过改善PES—C的加工熔融性,提高PES—C和PE的相容性,从而改善共混物的力学性能。     

Preparation and characterization of ZrO2/PES hybrid ultrafiltration membrane with uniform ZrO2 nanoparticles

In current or next-generation reuse systems, the development of new classes of antifouling membranes is needed before viable membrane-based approaches for wastewater reclamation can be achieved. In this study, ZrO₂/PES hybrid ultrafiltration membranes with uniform ZrO₂ nanoparticles were prepared by combining an ion-exchange process with a traditional immersion precipitation process. Hydrous ZrO₂ sol was synthesized by addition of anion-exchange resin in N,N-dimethylformamide solvent containing zirconyl chloride. Homogeneous ZrO₂/PES casting solution was then obtained by dissolving PES polymer in the ZrO₂ sol. The existence and dispersion states of ZrO₂ nanoparticles in the resultant membrane matrix were examined by X-ray photoelectron spectrometer, thermogravimetric analysis, scanning electron microscope and transmission electron microscope. The results indicate that the ZrO₂ nanoparticles were well dispersed throughout the PES matrix and the diameter of the formed nanoparticles was about 5–10 nm. The hydrophilicity of the membranes was determined by measuring the contact angles. The antifouling property was determined by antifouling experiments and atomic force microscopy. The results confirm that the existence of ZrO₂ nanoparticles improves the hydrophilicity and reduces protein adsorption of membranes.     

Atom transfer radical polymerization (ATRP): A versatile and forceful tool for functional membranes

The progress in atom transfer radical polymerization (ATRP) provides an effective means for the design and preparation of functional membranes. Polymeric membranes with different macromolecular architectures applied in fuel cells, including block and graft copolymers are conveniently prepared via ATRP. Moreover, ATRP has also been widely used to introduce functionality onto the membrane surface to enhance its use in specific applications, such as antifouling, stimuli-responsive, adsorption function and pervaporation. In this review, the recent design and synthesis of advanced functional membranes via the ATRP technique are discussed in detail and their especial advantages are highlighted by selected examples extract the principles for preparation or modification of membranes using the ATRP methodology.     

Porous polyethersulfone hollow fiber membrane in gas–liquid contacting processes

Porous polyethersulfone hollow fiber membranes were fabricated via dry–wet phase inversion method with the polymer concentration in the spinning dope either 13 wt% or 15 wt%. The fabricated hollow fiber membranes were characterized by different test methods and the performance of membranes in contactor applications was tested by CO₂ absorption. The mean pore size, effective surface porosity and membrane porosity decreased while the membrane density and Liquid Entry Pressure (LEPw) increased as polymer concentration increased. The CO₂ absorption flux of the fabricated membranes was measured in two cases; i.e. when the absorbent, distilled water, was in the lumen side or in the shell side. The CO₂ flux for the membrane, fabricated from 13 wt% PES solution, was compared with some commercial and in-house made membranes. The former membrane had 111% higher flux than a commercial PTFE membrane.     

下一代网络信令的研究进展

随着NGN标准化工作的加快,信令协议已成为NGN标准化组织研究的重点,本文主要依据TISPAN提出的NGN架构,对相关的信令协议及其研究进展进行了介绍,包括传送层和业务层.