中频数字化及数字式正交解调

本文介绍用数字式下变频法实现中频正交解调的基本原理及主要性能。     

碗米坡水电站水机一级过速保护优化和改进

本文主要介绍了碗米坡电厂水机一级过速保护的组成部分和设计原则,分析了碗米坡水电厂水机一级过速保护在甩负荷试验中该保护误动作导致事故停机问题,并详细阐述相应的优化和处理方法。     

Rejection thresholds (RjT) of sweet likers and dislikers

Sweetness is generally a desirable taste, however consumers can be grouped into sweet likers and dislikers according to optimally preferred sucrose concentrations. Understanding the levels of sweetness in products that are acceptable and unacceptable to both consumer groups is important to product development and for influencing dietary habits. The concentrations at which sucrose decreases liking (the rejection threshold; RjT) in liquid and semi-solid matrices were investigated in this study. Thirty six consumers rated their liking of 5 sucrose aqueous solutions; this identified 36% sweet likers (SL) whose liking ratings increased with increasing sucrose and 64% sweet dislikers (SD) whose liking ratings decreased above 6% (w/v) sucrose. We hypothesized that SL and SD would have different RjT for sucrose in products. This was tested by preparing 8 levels of sucrose in orange juice and orange jelly and presenting each against the lowest level in forced choice preference tests. In orange juice, as sucrose increased from 33 g/L to 75 g/L the proportion of people preferring the sweeter sample increased in both groups. However, at higher sucrose levels, the proportion of consumers preferring the sweet sample decreased. For SD, a RjT was reached at 380 g/L, whereas a significant RjT for SL was not reached. RjT in jelly were not reached as the sweetness in orange jelly was significantly lower than for orange juice (p < 0.001). Despite statistically significant differences in rated sweetness between SL and SD (p = 0.019), the extent of difference between the two groups was minor. The results implied that sweet liker status was not substantially related to differences in sweetness perception. Self-reported dietary intake of carbohydrate, sugars and sucrose were not significantly affected by sweet liker status. However the failure to find an effect may be due to the small sample size and future studies within a larger, more representative population sample are justifiable from the results of this study.     

陀螺稳定平台扰动的自抗扰及其滤波控制

分析了影响陀螺稳定平台隔离控制精度的主要因素,包括被控系统模型中的未建模部分、状态的随机扰动以及输出信号的测量噪声等。研究了综合解决各方面影响因素的控制方案以进一步提高陀螺稳定平台隔离精度。针对上述影响因素,设计一个两步控制策略。第一步,利用自抗扰对系统中未建模部分进行观测及其前向补偿,将自抗扰控制中的反馈控制设计为PID控制,以实现抗平台扰动的调节控制;第二步,利用Kalman滤波器对系统中的状态扰动及测量噪声进行滤波消除。详细描述了提出的控制策略并对其性能进行了系统仿真实验及参数优化。结果表明,该方案在幅值为3°、频率为1/6Hz的载体扰动下能达到4.61%的隔离度,与非线性摩擦力建模辨识及其前向补偿策略控制实际陀螺稳定平台达到的隔离度的最好值9.39%相比,文中提出的控制隔离性能提高了50.9%,具有更高的实用价值。     

Processing of alumina-coated clay–diatomite composite membranes for oily wastewater treatment

Crack-free alumina-coated clay–diatomite composite membranes were successfully prepared by a simple pressing and dip-coating route using inexpensive raw materials at a temperature as low as 1000 °C in air. The changes of porosity, flexural strength, pore size, flux, and oil rejection rate of the membranes were investigated while changing the diatomite content. A simple burn-out process subjected to the used membranes in air completely recovered the specific surface area, steady state flux, and oil rejection rate of the virgin membranes. The recycled membranes showed an exceptionally high oil rejection rate (99.9%) with a feed oil concentration of 600 mg/L at an applied pressure of 101 kPa. The typical porosity, pore size, flexural strength, oil rejection rate, and steady state flux of the recycled alumina-coated clay–diatomite composite membrane were 36.5%, 0.12 μm, 32 MPa, 99.9%, and 6.91×10⁻⁶ m³ m⁻² s⁻¹, respectively, at an applied pressure of 101 kPa.     

自适应线性自抗扰控制器的设计

自抗扰控制器对于抑制不确定的扰动有良好的效果,但其控制器参数较多且整定困难。为了实现自适应的线性自抗扰控制器,对线性自抗扰控制器的参数整定策略展开了研究。首先,设计了基于观测误差的线性扩张观测器参数自适应整定算法。接着,设计了自抗扰控制器线性反馈环节的参数的自适应整定算法。最后,利用李雅普诺夫方法,证明上述自适应整定算法得到的参数可以保证扩张状态观测器的观测误差和被控系统最终输出误差都收敛至零。实验结果表明:精密气浮运动平台低速工况下,自适应线性自抗扰控制器的参数在0.8s内即可迅速完成整定计算;线性扩张观测器观测误差绝对值小于2nm;被控精密气浮运动平台的速度波动不大于5%。自适应线性自抗扰控制器实现了控制器参数在线整定,控制器的性能表现满足要求。     

Supervised data analysis and reliability estimation with exemplary application for spectral data

The analysis and classification of data is a common task in multiple fields of experimental research such as bioinformatics, medicine, satellite remote sensing or chemometrics leading to new challenges for an appropriate analysis. For this purpose different machine learning methods have been proposed. These methods usually do not provide information about the reliability of the classification. This, however, is a common requirement in, e.g. medicine and biology. In this line the present contribution offers an approach to enhance classifiers with reliability estimates in the context of prototype vector quantization. This extension can also be used to optimize precision or recall of the classifier system and to determine items which are not classifiable. This can lead to significantly improved classification results. The method is exemplarily presented on satellite remote spectral data but is applicable to a wider range of data sets.     

线性调节器盼抗干扰设计

本文给出了一种扰动情况下线性调节器的设计方法。主导思想是,在最优控制律中附加干扰成份,以抵消扰动信号的影响,使系统保持希望的平衡态,并在规定的性能指标下为最优。文中还给出了一个轧机控制系统的设计实例及仿真结果。     

Analysis of continuous stirred ultrafiltration based on dimensional analysis approach

In this study an attempt has been made to obtain a dimensional analysis based empirical model of ultrafiltration process under stirred condition, which for a given membrane will predict the permeate flux and the rejection during the dynamic as well as the steady state phases of operation from the process conditions applied, viz. pressure drop, stirrer speed, bulk concentration of the filtered species etc. A dimensional analysis by Rayleigh’s method was performed and the obtained dimensionless groups were related with the help of experimentally obtained data in this study, by non-linear regression employing Levenberg and Marquardt technique. Two equations have been obtained, one for the prediction of flux and other for the rejection. The computed results are found to be in good agreement with the experimental data obtained in this study during the ultrafiltration of PEG-6000 by cellulose acetate membrane and the absolute average deviation was found to be within less than 7%.