Top illuminated organic photodetectors with dielectric/metal/dielectric transparent anode

The top illuminated organic photodetectors (OPDs) with a Dielectric/Metal/Dielectric (DMD) transparent anode are fabricated. The transparent electrode is composed of molybdenum trioxide (MoO₃)/silver (Ag)/MoO₃ layers and zinc oxide (ZnO)/aluminum (Al) is used for bottom cathode. The optimized DMD electrode has an optical transmittance of 85.7% at the wavelength of 546 nm and sheet resistance of ∼6 Ω/sq. The fabricated OPDs exhibit a high detectivity and wide range linearity.     

Measurement of Electrophysiological Signals In Vitro Using High-Performance Organic Electrochemical Transistors

Biological environments use ions in charge transport for information transmission. The properties of mixed electronic and ionic conductivity in organic materials make them ideal candidates to transduce physiological information into electronically processable signals. A device proven to be highly successful in measuring such information is the organic electrochemical transistor (OECT). Previous electrophysiological measurements performed using OECTs show superior signal-to-noise ratios than electrodes at low frequencies. Subsequent development has significantly improved critical performance parameters such as transconductance and response time. Here, interdigitated-electrode OECTs are fabricated on flexible substrates, with one such state-of-the-art device achieving a peak transconductance of 139 mS with a 138 µs response time. The devices are implemented into an array with interconnects suitable for micro-electrocorticographic application and eight architecture variations are compared. The two best-performing arrays are subject to the full electrophysiological spectrum using prerecorded signals. With frequency filtering, kHz-scale frequencies with 10 µV-scale voltages are resolved. This is supported by a novel quantification of the noise, which compares the gate voltage input and drain current output. These results demonstrate that high-performance OECTs can resolve the full electrophysiological spectrum and suggest that superior signal-to-noise ratios could be achieved in high frequency measurements of multiunit activity.     

红外光谱法用于快速测定车用柴油酸度等性质的研究

针对车用柴油酸度等性质测定过程繁琐，采用衰减全反射样品池测定车用柴油的红外光谱，用偏最小二乘法（PLS）建立红外光谱测定车用柴油酸度、密度、闪点和凝点的4个校正模型，验证标准误差分别为0.46 mg/(100 mL),0.77kg/m3,2.60 ℃,2.77 ℃，该方法符合标准方法再现性要求。与标准方法相比，该方法具有无需预处理、操作简单、测量快速、重复性好等优点。     

三相全控桥式整流电路实验装置的研制

介绍了开发三相全控桥式整流电路实验装置的背景;叙述了TC787芯片的内部结构、工作原理、特点及芯片的各个管脚的功能;详细介绍了该实验装置的触发电路的设计思路、设计结果和工作原理;介绍了该实验装置的主电路部分的结构和特点。该实验装置性能可靠,符合本科生实验要求。     

The Cooperative Molecular Field Effect

Two‐dimensional arrangements of molecules can show remarkable cooperative electronic effects. Such effects can serve to achieve direct electronic sensing of chemical and physical processes via electrostatic effects, i.e., without transfer of charge or matter between the locus of sensing and that of detection.     

新国标烯烃限值的无铅汽油对汽车耐久性能的影响

选用3种轿车,使用烯烃含量接近新国标限值35％的无铅汽油,行驶8×10~4km,进行整车和发动机台架检测,并对进气阀和喷嘴进行评定。试验结果表明,在行驶8×10~4km后,整车的动力性、经济性很稳定,电喷车的排放检测值符合现行国标的限值要求;进气阀较清洁,喷嘴流量损失小;发动机外特性、比油耗、活塞窜气量、汽缸压缩压力等都变化不大。这说明,符合现行国标烯烃限值要求的无铅汽油适合目前我国汽车的使用并能满足现行排放法规的要求。     

北京谱仪漂移室读出电子学校准电路

本文介绍的电路可同时进行时间和电荷校准,它的校准量程大,精度高,稳定性好,可输出864路指数形校准信号,并可手动或程控。它的时间校准精度优于±250ps,电荷量校准精度优于±1％。