Designed damping controller for SSSC to improve stability of a hybrid offshore wind farms considering time delay

This paper presents the stability improvement results of hybrid doubly fed induction generator (DFIG)-based and permanent magnet generator (PMG)-based offshore wind farms (OWFs) using a static synchronous series compensator (SSSC). An adaptive-network-based fuzzy inference system (ANFIS) controller of the proposed SSSC is designed to render adequate damping characteristics to the studied system. A frequency-domain approach based on a linearized system model using eigenvalue technique analysis is performed. A time-domain scheme based on a nonlinear system model subject to a three-phase short circuit fault at infinite bus with variations in the signal transmission delays has also been investigated to compare the damping of the studied system in cases of with and without controller. The simulation results with MATLAB/SIMULINK toolbox have been presented. It can be concluded from the simulation results that the proposed SSSC joined with the designed ANFIS damping controller can offer adequate damping performance to the studied hybrid DFIG-based and PMG-based OWFs under severe disturbance.     

Sinusoidal disturbance rejection in chaotic planar oscillators

The main goal of this paper is to design a compensator able to restore the nominal behavior of a planar system, which is rendered chaotic by an unmeasurable sinusoidal disturbance input. To reach such a goal, some instruments, taken from algebraic geometry, are used to estimate the unmeasurable disturbance from the time derivatives of the output of the system and of the control input. Copyright © 2015 John Wiley & Sons, Ltd.     

基于滑模的运载器主动段俯仰通道姿控系统设计

与传统比例-积分-微分（PID）控制方法相比，滑模控制（SMC）方法可以比较容易地将不确定性纳入控制器设计中，从而增强系统的鲁棒性。探索了SMC技术在运载器主动段姿态控制中的工程应用，首先通过分析基于趋近律的SMC系统，提出了降低不连续切换项系数的需求，然后研究了基于干扰上界的SMC方法。三通道小偏差仿真结果验证了两种方法的控制效果，表明第2种控制器的鲁棒性更好，稳态误差小，同时发动机喷管摆角需求较小。     

Anti‐Sway Crane Control Considering Wind Disturbance and Container Mass

A method for estimating the sway angle using an observer has already been proposed. The state observer estimates the sway angle accurately and must use the detected sway angle value. However, the estimated sway angle has an error owing to rope length error, friction force, and wind. Moreover, the container mass cannot be determined, and therefore the observer parameter is not suitable. We already proposed robust antisway control for overcoming rope length error without adding a new sensor. Further, we designed a friction disturbance observer to cancel out the influence of the friction force. In this paper, we first propose a container mass estimation method when a crane system performs rolling up control. The observer parameter can be selected using the estimated mass value. Second, in crane parallel shift control, we propose a robust antisway control even when there is a wind disturbance. We design a wind disturbance observer and propose a wind disturbance estimator to separate the friction observer output from the wind disturbance observer output. We confirm through experiments that the proposed method can reduce vibration.     

Design of disturbance observer based on adaptive-neural control for large-scale time-delay systems in the presence of actuator fault and unknown dead zone

This article presents an adaptive neural compensation scheme for a class of large-scale time delay nonlinear systems in the presence of unknown dead zone, external disturbances, and actuator faults. In this article, the quadratic Lyapunov–Krasovskii functionals are introduced to tackle the system delays. The unknown functions of the system are estimated by using radial basis function neural networks. Furthermore, a disturbance observer is developed to approximate the external disturbances. The proposed adaptive neural compensation control method is constructed by utilizing a backstepping technique. The boundedness of all the closed-loop signals is guaranteed via Lyapunov analysis and the tracking errors are proved to converge to a small neighborhood of the origin. Simulation results are provided to illustrate the effectiveness of the proposed control approach.     

Active disturbance rejection based trajectory linearization control for hypersonic reentry vehicle with bounded uncertainties

This paper investigates a novel compound control scheme combined with the advantages of trajectory linearization control (TLC) and alternative active disturbance rejection control (ADRC) for hypersonic reentry vehicle (HRV) attitude tracking system with bounded uncertainties. Firstly, in order to overcome actuator saturation problem, nonlinear tracking differentiator (TD) is applied in the attitude loop to achieve fewer control consumption. Then, linear extended state observers (LESO) are constructed to estimate the uncertainties acting on the LTV system in the attitude and angular rate loop. In addition, feedback linearization (FL) based controllers are designed using estimates of uncertainties generated by LESO in each loop, which enable the tracking error for closed-loop system in the presence of large uncertainties to converge to the residual set of the origin asymptotically. Finally, the compound controllers are derived by integrating with the nominal controller for open-loop nonlinear system and FL based controller. Also, comparisons and simulation results are presented to illustrate the effectiveness of the control strategy.     

An enhanced anti-disturbance attitude control law for flexible spacecrafts subject to multiple disturbances

As well-known disturbance rejection methods, active disturbance rejection control and disturbance observer-based control can effectively improve the control performances of complex systems in the presence of disturbances. However, the accurate rejection of multiple disturbances for control systems of practical engineering, for example, the attitude control system of flexible spacecraft, is still a bottleneck problem. In order to further improve the anti-disturbance capability and reduce the conservativeness, this paper proposes a novel enhanced anti-disturbance control law for the attitude control system of flexible spacecraft by combining active disturbance rejection control and disturbance observer-based control in a unified framework. More specifically, the disturbance from flexible vibration is described by an uncertain exogenous system based on the partially known information including elastic damping ratios and modal frequencies. The disturbance observer-based control is utilized to estimate and thereby reject this disturbance. On the other hand, the other disturbances such as external environmental disturbance and complex model nonlinearity are merged into a equivalent disturbance with bounded derivative, which is compensated by using the active disturbance rejection control law. Stability and robustness analysis are carried out for the disturbance observer and extended state observer. Finally, simulation results of low-earth-orbit flexible satellite are presented to verify the effectiveness of proposed methods.     

DVD视盘机的电磁骚扰抑制

本文讨论对DVD视盘机的电磁骚扰的抑制，使其电磁骚扰水平符合有关标准的要求，不成为新的电磁环境中的污染源。     

A direct numerical simulation of transition phenomena in a mixed convection channel flow

This study intends to provide an increased understanding of the laminar-turbulent transition phenomena for the buoyancy-assisted heated vertical channel flow during the early transient stage. The spectral method with weak formulation is applied in the direct numerical simulation. Initial disturbances consist of the finite-amplitude two-dimensional TS wave and a pair of three-dimensional oblique waves for the K-type disturbances. The results from the harmonic energy competitions of different wave modes show that for the buoyancy-assisted heated flow, the (k_x=1, k_z=1) or (1,1) and (1,0) modes would gain energy immediately and start to rise at almost the same rate. This phenomenon is different from that of the buoyancy-opposed flow, where the (1,1) mode decays slowly in the beginning until other modes gain enough energy and then it begins to grow quickly and overtakes the (1,0) mode after a short time period. These different transition patterns match with the experimental results that the flow transition is supercritical and subcritical for the buoyancy-assisted and -opposed flows, respectively. Buoyancy-assisted heated flow transition follows the general trend of an isothermal flow in the beginning, but the thermal-buoyant force is crucial in accelerating the instability and also causing notable differences during the subsequent transition process. All of the results for the vortex structures development, kinetic energy budget of the disturbances, flow visualization by tagged fluid particles, and the local temperature fluctuations are consistent in pointing to a clear pattern for the buoyancy-assisted heated flow transition.     

就地补偿在动力厂水泵电机上的应用实例

就我公司动力厂给水车间155kW水泵电机无功就地补偿的可行性及经济效益进行了分析和研究，对工厂用电如何节能降耗有一定的参考价值。