Comparative analysis of formaldehyde and toluene sorption on indoor floorings and consequence on Indoor Air Quality

Indoor surfaces may be adsorptive sinks with the potential to change Indoor Air Quality. To estimate this effect, the sorption parameters of formaldehyde and toluene were assessed on five floorings by an experimental method using solid-phase microextraction in an airtight emission cell. Adsorption rate constants ranged from 0.003 to 0.075 m·h⁻¹, desorption rate constants from 0.019 to 0.51 h⁻¹, and the partition coefficient from 0.005 to 3.9 m, and these parameters vary greatly from one volatile organic compound/material couple to another indicating contrasted sorption behaviors. A rubber was identified as a sink of formaldehyde characterized by a very low desorption constant close to 0. For these sorbent floorings identified, the adsorption rates of formaldehyde are from 2 to 4 times higher than those of toluene. Two models were used to evaluate the sink effects of floorings on indoor pollutant concentrations in one room from different realistic conditions. The scenarios tested came to the conclusion that the formaldehyde sorption on one rubber (identified as a sink) has a maximum contribution from 15% to 21% for the conditions of low air exchange rate. For other floorings, the sorption has a minor contribution less than or equal to 5%, regardless of the air exchange rate.     

A novel quasi-oppositional harmony search algorithm and fuzzy logic controller for frequency stabilization of an isolated hybrid power system

The intermittent wind power in isolated hybrid distributed generation (IHDG) may cause serious problems associated with frequency (f) and power (P) fluctuation. Energy storage devices such as battery, super capacitor, and superconducting magnetic energy storage (SMES) may be used to reduce these fluctuations associated with f and P. This paper presents a study of IHDG power system for improving both f and P deviation profiles with the help of SMES. The studied IHDG power system is consisted of wind turbine generator and diesel engine generator. Both f and P control problems of the studied power system model are addressed in presence or absence of SMES. Fuzzy logic based proportional–integral–derivative (PID) controller with SMES is used for the purpose of minimization of f and P deviations. The different tunable parameters of the PID controller and those of the SMES are tuned by a novel quasi-oppositional harmony search algorithm. Performance study of the IHDG power system model is carried out under different perturbation conditions. The results demonstrate minimum f and P deviations may be achieved by using the proposed fuzzy logic based PID controller along with SMES.     

ATSP:时态网络可视化的自适应时间片划分方法

现有的时态网络可视化方法大多采用等量时间片来可视化网络的演变，不利于时态模式的快速挖掘和发现。为此，根据时态网络固有的特征提出自适应时间片划分方法（Adaptive Time Slice Partition method，ATSP）。在时态网络的两种表示方式（基于事件的表示方式和基于快照的表示方式）的基础上，构建了ATSP的基础模型，同时提出了一种改进模型用来描述事件间隔时间服从长尾分布的时态网络。为了实现时间片的不等量划分，针对探索任务的不同提出了基于时态模式的ATSP规则和基于中心节点的ATSP规则，并提出了实现算法--层次划分算法（Hierarchical Partition algorithm，HP）和增量划分算法（Incremental Partition algorithm，IP）。实验结果表明，ATSP方法比传统的时间片划分方法更能准确地表示网络的时态特征，且该方法应用于可视化时，能有效归纳并展示网络的特征，明显提高了视觉分析的效率。     

An overlapping domain decomposition dual reciprocity method

We present a domain decomposition boundary integral equation method for two-dimensional partial differential equations. The overlapping Schwarz method is employed to improve the dual reciprocity boundary element method. The resulting algorithm turns out to be more accurate than a non-overlapping approach previously proposed. Some numerical results showing the improved accuracy and efficiency of the methods are given.     

基于积分原理的低功耗超声波流量检测方法

文章通过对时差式超声波流量检测方法的分析，提出了基于过零检测技术及积分法的信号处理方法，避免了繁琐的信号处理，降低了整机功耗。结合工作时序的设计，提出了实现低功耗超声波液体流量检测的措施。     

双级染料激光放大器泵浦能量分配的数值研究

用染料激光放大器的横向稳态泵浦理论，对不同的入射光能量选择不同的增益计算方法，研究了双级染料放大器的泵浦能量分配比例、泵浦光总能量和信号光能量大小对激光增益的影响。计算结果表明，对于其他参数确定的放大系统，存在着最佳的泵浦能量分配比例，可获得最大增益输出。通过自编程序的计算，可方便地找出特定系统泵浦能量分配比例的最佳值。     

A note on the Gauss-Jacobi quadrature formulae for singular integral equations of the second kind

A fast and efficient numerical method based on the Gauss-Jacobi quadrature is described that is suitable for solving Fredholm singular integral equations of the second kind that are frequently encountered in fracture and contact mechanics. Here we concentrate on the case when the unknown function is singular at both ends of the interval. Quadrature formulae involve fixed nodal points and provide exact results for polynomials of degree 2n − 1, where n is the number of nodes. Finally, an application of the method to a plane problem involving complete contact is presented.     

低温低渗透砂岩油藏窜流大孔道深部封堵技术研究

所用堵剂为高强度的淀粉接枝聚丙烯酰胺交联凝胶SAMG-1,由<6%淀粉、4.5%-5.5%丙烯酰胺、0.003%-0.006%交联剂组成,35℃成胶时间受淀粉和交联剂用量控制,为18-20小时以上,成胶前黏度-100 mPa.s。该堵剂具有长期稳定性,在储层岩心中注入深度15 cm的堵剂,在35℃候凝48小时后及老化90天后,封堵强度分别为0.61和0.59 MPa/cm,封堵率分别为98.6%和98.1%。该堵剂优先进入高渗层,注入0.5 PV并成胶后,2组双填砂管组成的模型低、高渗管渗透率保留率分别为68.4%、0.7%和69.4%、0.0%。吉林扶余油田西一区+15-8.2区块有水井6口,油井13口,含水率达91.5%,注入水最快在5天内到达油井。报道了该区块整体深部调剖封堵窜流通道的情况,详细叙述了+15-9.2井施工中通过注入压力和井底回压控制注入流量,使堵剂陆续进入原生和次生孔道的工艺作业,该井设计注入堵剂92 m3。6口水井整体调剖后,油井产液量差别减小,产油量增加,有效期已超过了9个月,共增油843 t,含水平均下降3.87%。图7表1参8。     

An algorithm for architecture partitioning in high-speed networks with bursty traffic

This paper analyzes the performance of a switching architecture. The performance measures include the elapsed time of packet transfer and the waiting time to begin transfer. The architecture is partitioned depending on the type of network used and the expected traffic in the network. Every partition has a switch with a buffer that can absorb surges of bursty traffic within the network partition. The buffer size depends on the type of the network and incoming traffic. The partition size depends on the network bandwidth, network traffic, packet size and buffer size. Examples of different networks are used to show the applications of the model. The results show that the elapsed time of packet switch transfer depends exponentially on the number of partitions in the network.     

伊朗德黑兰地铁轨道施工方法

依托伊朗德黑兰地铁一、二号线工程 ,针对地铁单洞单线采用的轨道施工轨排法存在的不足 ,根据单洞双线隧道的特点 ,提出了利用组装好的轨排直接铺设在隧道结构底板上作为轨道平板车临时轨道的施工新方法