浅谈降低岩土施工成本的几点意见

通过正确分析岩土施工成本的价格体现和存在问题 ,对实现成本效益做出科学评价 ,并提出降低岩土施工成本的途径     

罐装降脂减肥果茶生产工艺的研究

本文介绍了以各种中药材为主要原料 ,配以茶叶为辅料 ,运用先进的处理方法制备降脂减肥果茶的生产工艺、质量标准 ,并对确定生产工艺的几个主要问题进行了探讨     

Obstacle avoidance tracking control with antiswing and tracking errors constraint for underactuated automated lifting robots with load hoisting/lowering

The existing automated lifting robot technology focuses merely on motion control and ignores the surrounding environment. In practice, obstacles inevitably exist in the movement path of the automated lifting robot, which affects construction safety. Furthermore, due to the underactuated characteristics of the automated lifting robot, the load can be difficult to control when it swings violently, which undoubtedly poses huge challenges to obstacle avoidance trajectory planning and controller design. In this paper, an obstacle avoidance trajectory and its tracking controller with antiswing and tracking errors constraint are proposed. To ensure accurate load positioning and effective obstacle avoidance, the proposed control method introduces a four-segment polynomial trajectory interpolation curve to construct an obstacle avoidance trajectory based on analyzing the geometric relationship between variables. To improve the transient coupling control performance of the system, combined with the passive analysis of the automated lifting robot system, this method constructs a potential function that limits the tracking error and a coupling signal that enhances the coupling relationship between the system variables. Barbalat's lemma and Lyapunov techniques are used to analyze the stability of the system. Simulation and experimental results show that the proposed control method can significantly suppress or even eliminate load oscillation, accurately locate the load, avoid obstacles, improve the safety and efficiency of the working automated lifting robot, and have strong robustness to changes in system parameters and the addition of external disturbances.     

The effect of small dose of topiroxostat on serum uric acid in patients receiving hemodialysis

Introduction : Topiroxostat, a recently developed xanthine oxidase inhibitor, is expected to have fewer adverse effects than allopurinol because it has different mechanism of action from alloprinol. However, its dosage, usage and safety have not been established in patients with impaired renal function or those undergoing dialysis at the development since no studies was conducted in these patients. Methods : Cross over clinical trial using 3 months of allopurinol and topiroxostat on 27 maintain Japanese HD patients were carried out. The effects on oxidative stress status of both drugs were also evaluated by measuring oxidation reduction potential. Findings : Twenty‐five of twenty‐seven patients completed study. The mean serum uric acid levels in the topiroxostat‐treated arm was significantly lower than it in the allopurinol‐treated arm time‐dependently (P < 0.0001). Corrected oxidative stress ratio defined as biological antioxidant potential/diacron reactive oxygen metabolites was significantly increased in topiroxostat‐arm (*P = 0.0035), but not in allopurinol‐arm (P = 0.1429). No significant difference was seen in diacron reactive oxygen metabolites, biological antioxidant potential, static oxidation‐reduction potential, and capacity oxidation‐reduction potential between pre and post treatment of both drugs. Discussion : It is suggested that a low dose of topiroxostat decreased serum uric acid sufficiently to maintain it below 7.0 mg/dL in patients receiving hemodialysis.     

Numerical simulation and comparison of electrical characteristics between uniaxial strained bulk and SOI FinFETs

In this paper, electrical characteristics of 25 nm strained fin-typed field effect transistors (FinFETs) with oxide-nitride-stacked-capping layer are numerically studied. The FinFETs are fabricated on two different wafers, one is bulk silicon and the other is silicon-on-insulator (SOI) substrate. A three-dimensional device simulation is performed by solving a set of density-gradient-hydrodynamic equations to study device performance including, such as the drain current characteristics (the I_D-V_G and I_D-V_D curves), the drain-induced barrier height lowering, and the subthreshold swing. Comparison between the strained bulk and SOI FinFETs shows that the strained bulk FinFET is promising for emerging multiple-gate nanodevice era according to the manufacturability point of view.     

炉内空气分级低NO_x燃烧技术

通过对氮氧化物生成机理的分析,论述了降低氮氧化物生成的基本途径和炉内空气分级燃烧脱硝的基本原理。通过实例考察了火上风量、径向空气分布、炉内氧量、炉内负荷和三次风投停对氮氧化物排放量的影响,说明炉内空气分级燃烧技术是降低煤粉炉NOx排放量的有效方法。     

Silicon-Germanium Structure in Surrounding-Gate Strained Silicon Nanowire Field Effect Transistors

In this paper we numerically examine the electrical characteristics of surrounding-gate strained silicon nanowire field effect transistors (FETs) by changing the radius (R_SiGe) of silicon-germanium (SiGe) wire. Due to the higher electron mobility, the n-type FETs with strained silicon channel films do enhance driving capability (∼8% increment on the drain current) in comparison with the pure Si one. The leakage current and transfer characteristics, the threshold-voltage (V_t), the drain induced barrier height lowering (DIBL), and the gate capacitance (C_G) are estimated with respect to different gate length (L_G), gate bias (V_G), and R_SiGe. For short channel effects, such as V_t roll-off and DIBL, the surrounding-gate strained silicon nanowire FET sustains similar characteristics with the pure Si one.     

无功补偿与技术降损简述

就技术线损结合吕梁电网实际进行实例分析，根据电力电容器并联补偿原理和电力系统中的无功设备。提出补偿办法。     

Thermal,hydrolytic, anticorrosive,and tribological properties of alkyd‐silicone hyperbranched resins with high solid content

Novel alkyd hyperbranched resins (AHBRs) modified with a Z‐6018 silicone (a polysiloxane intermediate) and with high solid content were synthesized by etherification reaction using an acid catalyst. Different molar ratios of AHBR to silicone were used. Structural, thermal, hydrolytic, anticorrosive, and tribological properties were studied using infrared (IR) analysis, nuclear magnetic resonance (NMR), vapor pressure osmometry (VPO), thermogravimetric analysis (TGA), acid value, electrochemical impedance spectroscopy (EIS), and pin‐on‐disk friction. IR and NMR provide evidence of grafting of the silicone on AHBR; the efficiency of grafting was quantified by TGA. Thermal stability was studied also by acid value analysis. Grafting increases the number average molecular mass, enhances thermal stability, and improves significantly hydrolytic stability. Corrosion resistance on steel is improved by two orders of magnitude, hence our modified materials can be used as highly effective anticorrosion coatings. Grafting lowers dynamic friction dramatically, more so at higher concentrations of silicone. © 2011 Wiley Periodicals, Inc. J Appl Polym Sci, 2012