The Difference in Turbulent Diffusion between the Active and Passive Scalars in a Thermally Stably Stratified Medium

The difference in the turbulent diffusion between the active (heat) and passive (mass) scalars in a thermally stably stratified medium is investigated. The axisymmetric problem is treated on the formation of a turbulent circulation flow above a heated disk and on the turbulent diffusion of a passive scalar (impurity) from a continuous surface source in a stably stratified medium. The results indicate that the thermal stratification causes appreciable differences in the coefficients of turbulent transfer between the active (heat) and passive (mass) scalars. This means that the assumption of the identity of the coefficient of turbulent diffusion of heat and mass, employed in conventional models of turbulence, produces significant errors in estimating the heat and mass transfer in a thermally stably stratified medium.     

求非线性方程近似解的逐次迭代法

本文提出了求解非线性问题的一种新方法——逐次迭代法，本方法先是给出一个初始近似解，然后将这个近似解进行校正迭代，使之接近于真实解，把一个非线性问题转化为一个线性问题来解决。     

Morphology and structure of poly(p-phenylene terephthalamide) crystallized from dilute organic solution

The high-temperature crystallization of poly(p-phenylene terephthalamide) (PPTA) from dilute organic solutions was achieved through the introduction of a non-solvent, or precipitating agent, at the desired crystallization temperature. The morphology and crystal structure were examined for crystals produced from PPTA polymer with two different molecular weights (M_w = 46000 and 3430 g mol⁻¹), using transmission electron microscopy. For the high-molecular-weight polymer, ribbon-like crystals were produced, while the low-molecular-weight polymer yielded small needles or platelets. In both cases, electron diffraction showed that the Northolt allomorph was obtained. For the high-molecular-weight polymer, the molecular axes were parallel to the ribbon axes in a chain-extended type structure. A hypothesis for the orientation of the low-molecular-weight PPTA in the small platelets, is also given.     

Water-soluble copolymers: 22. Copolymers of acrylamide with 2-acrylamido-2-methylpropanedimethylammonium chloride: Aqueous solution properties of a polycation

The viscometric, turbidimetric and potentiometric properties of copolymers of acrylamide (AM) with 2-acrylamido-2-methylpropanedimethylammonium chloride (AMPDAC) were studied in aqueous solutions. The AMPDAC polymers exhibit poor salt tolerance and large, negative viscosity/temperature coefficients. Furthermore, the polymers were found to be sensitive to changes in pH. The AMPDAC polymers undergo phase separation in the presence of dianions as a function of temperature and AMPDAC composition.     

Residual Stress Simulation of Injection Molding

In this study, distribution and history of residual stresses in plaque-like geometries are simulated based on linear thermoviscoelastic model, which helps to understand the mechanics and evolution of the residual stresses in the injection molding process. The numerical calculation of direction, combined with the specified boundary conditions. Results show that the stress variation across the thickness exhibits a high surface tensile value changing to a compressive peak value close to the surface, with the core region experiencing a parabolic tensile peak. Residual stress distribution throughout the thickness is almost same along the flowpath and the final residual stresses value near the gate is lower than the value near the end of flowpath.     

铝型材推弯工艺

通过铝型材圆环的推弯实验,研究了推弯工艺原理、变形过程,结合有限元模拟得到了和实验结果相吻合的型材厚度分布、成形零件卸载回弹后的曲率半径及型材截面畸变.结果表明:推弯零件曲率及截面畸变一致性高,成形模具结构简单且便于调整,数值模拟可以用于推弯工艺的优化分析.     

管壳式换热器流场三维数值模拟

采用多孔介质方法 ,在PHOENICS 3 3程序的基础上建立了换热器的三维流动计算模型。引入体积穿透率、表面穿透率、分布阻力等来描述换热器内的管束。模型通过计算Halle等[1] 的实验工况来进行验证 ,并尝试用于计算 2 0 0MW低温供热堆主换热器内的流场     

多人决策的一类相对均衡解

本文分析由于决策人偏好不同而引起决策差异的多人多目标决策问题，提出了这类决策问题的一类相对均衡解的概念和求取方法。相对均衡解以决策群体偏好的加权集结为基础，能最大程度地反映每个决策人的偏好。文中研究相对均衡解的ＳＷＴ求取方法，并给出了求解的步骤。     

圆筒混合机振动和粘漏料问题及解决办法

对圆筒混合机长期未得彻底解决的振动、大型零部件寿命短、筒体内壁粘料、进料漏斗堵料与漏料等问题进行了原因分析；根据宝钢烧结分厂的实践经验提出了解决办法。     

A BOUNDARY INTEGRAL EQUATION AND ITS NUMERICAL SOLUTION OF POTENTIAL FLOW AROUND SURFACE-IRREGULA-RITIES

In this paper,using complex functional theory,the authors turn the potentialflow around the surface irregularities in a pressure conduit and semi-infinite platforms intoDirichlet problem.Based on Schwarz formula and by the application of Plemelj's formula,theauthors change the problem into the integration of a Cauchy boundary integral equation in theflow plane through the substitution of variables.Using numerical integration,the authors obtainthe velocity distribution and pressure coefficient along surface irregularities and platforms.Thephysical concept of this method is clear,the convergent speed is rapid and the computative effi-ciency is high.The calculated values agree well with the measured results.It is an effective andsimple method in solving potential flow.