| 铝合金高速切削表面粗糙度影响因素研究 |
| |
| 引用本文： | 毛文亮,杨小平,邹山梅. 铝合金高速切削表面粗糙度影响因素研究[J]. 机械研究与应用, 2010, 0(5): 53-55 |
| |
| 作者姓名： | 毛文亮 杨小平 邹山梅 |
| |
| 作者单位： | [1]甘肃机电职业技术学院,甘肃天水741001 [2]甘肃农业大学工学院,甘肃兰州730070 |
| |
| 摘 要： | 为有效降低高速切削中铝合金的表面粗糙度值,通过多因素正交试验和单因素试验对各铣削参数进行研究,结果显示:各参数对铝合金表面粗糙度影响程度从大到小的顺序是:切削深度、主轴转速、每齿进给量、行距,且转速为18000r/min,每齿进给量为0.075mm,行距和每齿进给量一致,选择较小的切削深度时,在铝合金表面可获得较好的加工质量。
|
| 关 键 词： | 铝合金 高速切削 表面粗糙度 |
Research on the influence factors of high-speed cutting surface roughness of aluminum alloy |
| |
| Mao Wen-liang,Yang Xiao-ping,Zou Shan-mei. Research on the influence factors of high-speed cutting surface roughness of aluminum alloy[J]. Mechanical Research & Application, 2010, 0(5): 53-55 |
| |
| Authors: | Mao Wen-liang Yang Xiao-ping Zou Shan-mei |
| |
| Affiliation: | 1.Gansu institute of mechatronic technology,Tianshui Gansu 741001,China;2.School of technology,Gansu agricultural university,Lanzhou Gansu 730070,China) |
| |
| Abstract: | To effectively reduce surface roughness value of aluminum in high-speed cutting,high-speed milling parameters were studied by multi-factor orthogonal and single-factor test.The results showed that the parameters to the surface roughness value of aluminum,the influence degree in order is depth of cut,spindle speed,feed per tooth,and line spacing.In addition,the better surface machining quality in aluminum alloy can be obtained when the following condition was satisfied：18000r/min speed;0.075mm feed per tooth,same line spacing and feed per tooth and a smaller depth of cut. |
| |
| Keywords: | aluminum alloy high speed cutting surface roughness |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
