|
|||||
|
|
| 射孔弹壳体冷挤压工艺分析及有限元模拟 | |
| 引用本文： | 张渝,周杰,胡启国.射孔弹壳体冷挤压工艺分析及有限元模拟[J].热加工工艺,2010,39(1). |
| 作者姓名： | 张渝 周杰 胡启国 |
| 作者单位： | 1. 重庆大学,材料科学与工程学院,重庆,400044;重庆交通大学,机电与汽车工程学院,重庆,400074 2. 重庆大学,材料科学与工程学院,重庆,400044 3. 重庆交通大学,机电与汽车工程学院,重庆,400074 |
| 基金项目： | 重庆市科委自然科学基金计划，重庆市教委科学技术研究项目 |
| 摘 要： | 针对射孔弹壳体挤压件进行了工艺分析。对比了一次性成形和预挤压-变薄拉深加顶镦两种工艺方案,并比较了整体式凹模和预应力组合凹模两种不同模具结构对成形的影响。采用有限元软件Deform2D对不同工艺方案和模具结构进行了模拟验证。结果表明,采用两次挤压成形工艺方案,同时选用预应力组合凹模结构,可显著提高挤压凹模的承载能力,使凹模内壁所受等效应力降低到安全范围内。 |
| 关 键 词： | 射孔弹 冷挤压 组合凹模 数值模拟 |
Analysis of Cold Extrusion Process for Perforating Charge Shell and FEM Simulation |
|
| ZHANG Yu,ZHUO Jie,HU Qiguo.Analysis of Cold Extrusion Process for Perforating Charge Shell and FEM Simulation[J].Hot Working Technology,2010,39(1). | |
| Authors: | ZHANG Yu ZHUO Jie HU Qiguo |
| Affiliation: | ZHANG Yu1,2,ZHUO Jie1,HU Qiguo2(1.College of Materials Science , Engineering,Chongqing University,Chongqing 400044,China,2.School of Mechatronics , Automotive Engineering,Chongqing Jiaotong University,Chongqing 400074,China) |
| Abstract: | Aiming at perforating charge shell,the extrusion technology was analyzed.The onceforming process was contrasted with the pre-extrusion and drawed with upsetting process,and the influences of integral die and combined die on the forming were analyzed and compared.To validate the different process scheme and die structure,the numerical simulation was done using FEM software Deform2D.The results show that the load carrying capacity of extrusion die increases greatly and the effective stress acting on the inner... |
| Keywords: | perforating charge cold extrusion combined die numerical simulation |
| 本文献已被 CNKI 万方数据 等数据库收录！ | |