| 残余应力应变释放系数的有限元分析 |
| |
| 引用本文： | 刘晓红.残余应力应变释放系数的有限元分析[J].机械设计与制造,2011(5). |
| |
| 作者姓名： | 刘晓红 |
| |
| 作者单位： | 广西大学机械工程学院,南宁,530004 |
| |
| 摘 要： | 通过建立16Mn残余应力盲孔法有限元分析模型,模拟出孔边应力、应变的变化情况.揭示了残余应力引起的孔边应力、应变变化情况与应变释放系数A、B值之间的关系,并用孔边应力、应变的有限元运算结果计算出A、B值.通过应变计中点应变法、应变计中点应力法和平均应变法三种方法去标定和修正应变释放系数,通过对三种方法的比较表明,三种方法的计算结果与实验结果相符.且计算精度较高.证实了残余应力有限元模拟的准确性和A、B值标定和修正方法的多样性.
|
| 关 键 词： | 残余应力 有限元法 应变释放系数 盲孔法 |
The finite element analysis for residual stress and strain release coefficient |
| |
| LIU Xiao-Hong.The finite element analysis for residual stress and strain release coefficient[J].Machinery Design & Manufacture,2011(5). |
| |
| Authors: | LIU Xiao-Hong |
| |
| Affiliation: | LIU Xiao-Hong(Institute of Mechanical Engineering,Guangxi University,Nanning 530004,China) |
| |
| Abstract: | Through modeling the finite element analysis for the16Mn residual stress blind hole method,changes for the stress and strain along the hole are simulated.The relationship between the stress,strain changes caused by the residual stress and the factor A,B value released by the strain are revealed.And A,B value could be calculated with the calculation resulted from the finite element for stress and strain.Coefficient of strain release can be standardized and revised through the following three kinds of methods... |
| |
| Keywords: | Residual stress Finite element method(FEM) Coefficient of strain release Blind-hole method |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
