| 纳米尼龙6注塑熔接线拉伸性能的研究 |
| |
| 引用本文： | 申长雨,刘娜,张滟.纳米尼龙6注塑熔接线拉伸性能的研究[J].郑州大学学报(工学版),2007,28(2):1-4. |
| |
| 作者姓名： | 申长雨 刘娜 张滟 |
| |
| 作者单位： | 郑州大学橡塑模具国家工程研究中心,河南,郑州,450002 |
| |
| 摘 要： | 针对纳米尼龙6,研究了熔体温度、模具温度、保压压力和注射速度等工艺因素对具有熔接线和无熔接线注塑件拉伸强度的影响.研究表明:具有熔接线纳米尼龙6注塑件的拉伸强度明显低于纯尼龙6和无熔接线纳米尼龙6注塑件的拉伸强度.随着熔体温度、模具温度、保压压力和注射速度的增大,纳米尼龙6注塑件的拉伸强度都随之提高;在所选择的工艺因素中,保压压力对注塑件熔接线拉伸强度影响最大.
|
| 关 键 词： | 熔接线 纳米尼龙6 拉伸强度 |
| 文章编号： | 1671-6833（2007）02-0001-04 |
| 修稿时间： | 2007-01-05 |
Study on the Weld Line Strength of Injection Molded Nylon 6 Nanocomposites |
| |
| SHEN Chang-yu,LIU Na,ZHANG Yan.Study on the Weld Line Strength of Injection Molded Nylon 6 Nanocomposites[J].Journal of Zhengzhou University: Eng Sci,2007,28(2):1-4. |
| |
| Authors: | SHEN Chang-yu LIU Na ZHANG Yan |
| |
| Affiliation: | National Engineering Research Center for Advanced Polymer Processing Technology, Zhengzhou University, Zhengzhou 450002, China |
| |
| Abstract: | In this study,molding condition including melt temperature,mold temperature,packing pressure and injection speed on the mechanical properties particularly the weld line strength of injection molded nylon 6 nanocomposites were investigated.It is found that with addition of nano particles the weld line becomes significantly weak compared with that of pure nylon 6 parts and non-weld line nylon 6 nanocomposites.As melt temperature,mold temperature,packing pressure and injection speed increase the weld line strength of molded nanocomposites also increase.Among the processing factors,packing pressure exhibits the most significant effect on weld line strength. |
| |
| Keywords: | weld line nylon 6 nanocomposties tensile strength |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
