首页 | 本学科首页   官方微博 | 高级检索  
     

压铸填充过程的理论探讨
引用本文:钱万选.压铸填充过程的理论探讨[J].特种铸造及有色合金,2002(4):47-49,51.
作者姓名:钱万选
作者单位:沈阳航天新新集团
摘    要:对在同一个压铸件上造成品质差异的原因进行了探讨分析,指出:这是由于存在填充过程的两个区域,即主干型腔和非主干型腔,这二个区域填充状况是不一样的,中有顺应这个规律,搞好压铸模设计,特别是浇注系统的设计,才是提高压铸产品品质的根本途径。

关 键 词:填充过程  主干型腔  非主干型腔  入射角  压力梯度  压力铸造
文章编号:1001-2449(2002)04-0047-04

Discussion on the Theory of Mold Filling Process in Die Casting
Qian Wansuan.Discussion on the Theory of Mold Filling Process in Die Casting[J].Special Casting & Nonferrous Alloys,2002(4):47-49,51.
Authors:Qian Wansuan
Abstract:Reason of quality difference for the same die casting was analyzed. It is indicated that there exist two areas in mold filling process, namely, primary trunk die cavity and non primary trunk die cavity. The two areas are different in filling quality. The radical ways to improve die casting quality are conformable to the law with respect to die casting die design,especially the gating system design.
Keywords:Primary Trunk Die Cavity  Non  primary Trunk Die Cavity  Injection Angle  Pressure Gradient  
本文献已被 CNKI 维普 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号